Gorka Kerejeta

Mr. Gorka Kerejeta

orcid

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 October 2024 in Smart Cities
Verified
Journal Article
Open access
PDF file
GAGonzalo Abad
Gonzalo Abad
ALAnder Plaza Lafuente
Ander Plaza Lafuente
GKGorka Kerejeta
Gorka Kerejeta
Small wind turbines placed at city locations are affected by variable-speed winds that frequently change direction. Architectural constructions, buildings of different heights and abrupt orography of Cities make the winds that occur at City locations more variable than in flat lands or at sea. However, the performance of Small-wind turbines under this type of variable wind has not been deeply studied in the specialised literature. Therefore, this article analyses the behaviour of small wind turbines under variable and gusty winds of cities, also considering three types of power electronics conversion configurations: the generally used Maximum Power Point Tracking (MPPT) configuration, the simple only-rectifier configuration and an intermediate configuration in terms of complexity called pseudo-MPPT. This general-purpose analysis is applied to a specific type of wind turbine, i.e., the Ayanz wind turbine with screw blades, which presents adequate characteristics for city locations such as; safety, reduced visual and acoustic impacts and bird casualties avoidance. Thus, a wide simulation and experimental tests-based analysis are carried out, identifying the main factors affecting the maximisation of energy production of small wind turbines in general and the Ayanz turbine in particular. It is concluded that the mechanical inertia of the wind turbine, often not even considered in the energy production analysis, is a key factor that can produce decrements of up to 25% in energy production. Then, it was also found that electric factors related to the power electronics conversion system can strongly influence energy production. Thus, it is found that an adequate design of a simple pseudo-MPPT power conversion system could extract even 5% more energy than more complex MPPT configurations, especially in quickly varying winds of cities.

19 March 2026 in IEEE Open Journal of the Industrial Electronics Society
Verified
Journal Article
Open access
ALAnder Plaza Lafuente
Ander Plaza Lafuente
GAGonzalo Abad
Gonzalo Abad
GKGorka Kerejeta
Gorka Kerejeta
This paper presents an analogy between micro-hydroelectric and small wind energy conversion systems, validating two commonly used power extraction methods. Although the paper focuses on the Pelton hydroelectric turbine, most of the analysis, methods, and results could also be extended to other types of hydroelectric turbines. First, the physical model of the Pelton turbine is described, and then it is adapted to the modeling methods applied to wind turbines. This shows the analogy between the models of Pelton and wind turbines. Based on this analogy, two simple and effective maximum power extraction methods developed for small wind turbines are applied to micro-hydroelectric power generation by Pelton turbines. The first tested method is the model-based maximum power point tracking (MPPT) algorithm, which is based on indirect speed control. This method effectively maximizes the power generation of the hydraulic turbine by using a simple power electronics conversion system. It minimizes the complexity and computational cost of the algorithm and requires few electric magnitude measurements. Thus, the necessity of using a position or speed sensor is avoided (sensorless). After that, the so called Pseudo-MPPT method is tested, which further simplifies the power conversion system, eliminates the necessity of a micro-processor and therefore, also avoids the use of sensors. Experimental validation of both maximum power extraction methods show that they effectively maximize the power generation of Pelton turbines, under both constant and variable flow rate conditions. Thus, while the MPPT method tends to extract more power than the Pseudo-MPPT method at constant flow rates, the Pseudo-MPPT method can be designed to be nearly as efficient as the MPPT method in contexts where the flow rate is well-defined and limited to a known range. It should be noted, however, that the Pseudo-MPPT method has a very fast dynamic response time to adapt to flow rate variations, and its simplicity makes it attractive in terms of practical implementation, low cost, and reduced design and commissioning complexity for engineers, as well as good reliability due to its minimized component needs. To conclude, several application scenarios for these micro-hydroelectric turbines are presented and described in detail.

11 September 2024 in Preprints.org
Verified
Preprint
Open access
PDF file
GAGonzalo Abad
Gonzalo Abad
ALAnder Plaza Lafuente
Ander Plaza Lafuente
GKGorka Kerejeta
Gorka Kerejeta
Small wind turbines placed at City locations are affected by variable speed winds that frequently also change the direction. Architectural constructions, buildings of different height and abrupt orography of Cities make the winds that occur at City locations, more variable than in flat lands or at sea. However, performance of Small-wind turbines under this type of variable winds is not deeply studied in specialized literature. Therefore, this article analyses this important issue, also considering three types of power conversion configurations utilized in small-wind turbines; the generally used Maximum Power Point Tracking (MPPT) configuration, the simple only-rectifier configuration and an intermediate configuration in terms of complexity called Pseudo-MPPT. This general-purpose analysis is applied to a specific type of wind turbine, i.e. the Ayanz wind turbine with screw blades, which presents very adequate characteristics for city locations such as; safety, reduced visual and acoustic impacts and birds’ casualties avoidance. Thus, a wide simulation and experimental tests-based analysis is carried out, identifying which are the main factors affecting to the maximization of energy production of small-wind turbines in general and the Ayanz turbine in particular. It is concluded that depending how the wind turbine is designed in terms of these identified main factors, the simple Pseudo-MPPT power conversion configuration could even extract more energy than more complex MPPT configurations, especially in quickly varying wind situations.