Herein, we reported the simulation study of lead (Pb)-free all-perovskite tandem solar cells using SCAPS-1D. Tandem solar cells are comprised of two different cells which are known as the top cell and the bottom cell. We simulated tandem solar cells using methyl ammonium germanium iodide (MAGeI₃) as the top subcell absorber layer due to its wide band gap of 1.9 eV. Further, FA_0.75MA_0.25Sn_0.25Ge_0.5I₃ = FAMASnGeI₃ was used as the bottom subcell absorber layer due to its narrow band gap of 1.4 eV. The tandem solar cells were simulated with MAGeI₃ as the top cell and FAMASnGeI₃ as the bottom subcell using SCAPS-1D. Various electro-transport layers (ETLs) i.e., titanium dioxide, tin oxide, zinc oxide, tungsten trioxide, and zinc selenide, were used to examine the impact of ETL on the efficiency of tandem solar cells. The observations revealed that TiO₂ and ZnSe have more suitable band alignment and better charge-extraction/transfer properties. A reasonably improved efficiency of 23.18% and 22.4% have been achieved for TiO₂ and ZnSe layer-based tandem solar cells, respectively.

The green synthesis of ZnO NPs is becoming increasingly valued for its cost-effectiveness and environmental benefits. This study successfully synthesized hexagonal ZnO NPs using a combination of clove (Syzygium aromaticum) and Thymus capitatus extracts. The use of both extracts significantly improved the antibacterial and antioxidant properties of the ZnO NPs. By optimizing synthesis conditions, including ZnCl₂ and extract concentrations, hexagonal wurtzite ZnO NPs were produced at room temperature with only drying at 80 °C without high-temperature annealing. The synthesized ZnO NPs exhibited a hexagonal morphology with an average particle size of 160 nm and a crystallite size of 30 nm. Energy-dispersive X-ray spectroscopy (SEM-EDX) confirmed the elemental composition of the ZnO NPs, showing a high carbon content (63.9 wt.%), reflecting the presence of phytochemicals from the extracts coated the ZnO NPs surface. The UV–Vis spectrum revealed an absorption peak at 370 nm and a bandgap energy of 2.8 eV due to lattice defects caused by organic impurities. The ZnO NPs demonstrated exceptional antioxidant activity, with a DPPH radical scavenging rate of 95.2%. They also exhibited strong antibacterial activity against both Gram-positive and Gram-negative bacteria, with inhibition zones of 25 mm against Bacillus subtilis, 26 mm against Escherichia coli, 24 mm against Salmonella typhimurium, 22 mm against Klebsiella pneumoniae, 21 mm against Staphylococcus aureus, 20 mm against Staphylococcus hominis, and 18 mm against Bacillus subtilis at 200 ppm. Furthermore, significant antifungal activity was observed against Candida albicans, with an inhibition zone of 35 mm at the same concentration. These findings underscore the effectiveness of using combined plant extracts for producing ZnO NPs with controlled morphology and enhanced biological properties, highlighting their potential for various biomedical applications.

Nanotechnology and nanomaterials have gained much attention in recent years due to their remarkable features. Among nanoparticles, photocatalytic material, such as zinc oxide, have shown tremendous applications in each and every field of science. In the present research, investigators have synthesized zinc oxide nanoparticles (ZnONPs) using Scallion’s peel extract. ZnONPs were both spherical and rod-shaped, where the size for spherical particles was 40–100 nm and rod-shaped, particles size was more than 200 nm as confirmed by microscopic techniques. The typical trademark bands of ZnONPs at 400–800 cm⁻¹ were revealed by infrared spectroscopy, which also showed bands of carbonyl and hydroxyl groups. The hydrodynamic size by particle size analyzer (PSA) shows a size near about 200 nm in diameter. Furthermore, the synthesized ZnONPs were used to assess their potential as a micronutrient for the plant and nano adsorbent for the removal of antibiotics (ampicillin) and methylene blue dye from the simulated wastewater. The antibiotic and dye removal were observed under UV light and visible light against contact time. In comparison to control seeds, seeds grown with ZnONPs have shown better germination and seedling. It could be concluded that ZnONPs acted as an important nanosized source of nutrition for agricultural applications. Thus, the effect of ZnONPs has been proven as a nano-based nutrient source for agricultural purposes. The remediation study found that remediation of both ampicillin and methylene blue dye was efficient under UV light under similar experimental parameters from the simulated wastewater by the ZnONPs.

The development of poly(lactic acid) (PLA) nanocomposites incorporating urchin-like WO₃ particles through a cost-effective solution-casting method has led to significant enhancements in structural, thermal, optical, and rheological properties. The incorporation of these WO₃ particles up to 7 wt% resulted in the formation of an irregular honeycomb-like morphology with broad pore sizes ranging from 14.1 to 24.7 µm, as confirmed by SEM and EDX analysis. The urchin-like WO₃ particles acted as effective nucleating agents, increasing the crystallinity of PLA from 40% to 50% and achieving an impressive overall crystallinity rate of 97%. Differential scanning calorimetry (DSC) revealed an 11 K reduction in the crystalline phase transition temperature while maintaining stable melting (Tm) and glass transition (Tg) temperatures. Thermal analysis indicated a significant decrease in the onset of degradation and maximum thermal stability (T_max), with a reduction of 21 K due to the incorporation of the WO₃ particles. Optical measurements showed enhancement of UV-blocking properties from 9% to 55% with the WO₃ particle loading. Rheological tests demonstrated substantial improvements in viscoelastic properties, including a remarkable 30-fold increase in storage modulus, suggesting enhanced gel formation. Although the nanocomposites showed minimal antibacterial activity against Escherichia coli and Staphylococcus aureus, they exhibited significant antifungal activity against Candida albicans. These results underscore the potential of the PLA/WO₃ nanocomposites for advanced material applications, particularly where enhanced mechanical, thermal, optical, and antifungal performance is required.

Cellulose nanoparticles are sustainable natural polymers with excellent application in environmental remediation technology. In this work, we synthesized cellulose nanoparticles and covalently functionalized them with a multi-functional group possessing ligands. The hybrid material shows excellent adsorption properties for the simultaneous extraction of multiple metal ions in the sample preparation technique. The sorbent shows excellent sorption capacity in the range of 1.8–2.2 mmol/g of material. The developed method was successfully employed for the simultaneous extraction of Pb(II), Cd(II) and Cu(II) from real-world samples (industrial effluent, river water, tap and groundwater) and subsequently determined by inductively coupled plasma optical emission spectroscopy (ICP-OES). The method shows a preconcentration limit of 0.7 ppb attributes to analyze the trace concentration of studied metal ions. The detection limit obtained for Pb(II), Cd(II) and Cu(II) is found to be 0.4 ppb.