ishath harshika hewa maddumage

Dr. ishath harshika hewa maddumage


Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 May 2026 in Electronics
Verified
Journal Article
Open access
PDF file
SJSEONGHUN JO
SEONGHUN JO
ishath harshika hewa maddumageishath harshika hewa maddumage
ishath harshika hewa maddumage
Jaehun LeeJaehun Lee
Jaehun Lee
Gwanghyeon JeongGwanghyeon Jeong
Gwanghyeon Jeong
DLDong-Ho Lee
Dong-Ho Lee
This paper presents the design and fabrication of a wideband low-noise amplifier (LNA) covering C-band, using the 0.15 µm GaAs pHEMT process. To achieve both low noise performance and wide matching characteristics, a two-stage cascaded architecture is implemented. In the first stage, circular inductors and an inductive source degeneration technique are employed to minimize the noise figure (NF) while ensuring wideband input matching. Furthermore, an RC feedback structure is incorporated to effectively enhance the stability of the amplifier. The proposed LNA operates under a supply voltage of 3.3 V and a gate bias of 0.35 V, with a total DC power consumption of 69.3 mW. The fabricated MMIC occupies a total chip area of 1.98 mm2, including the probing pads. Measurement results demonstrate that the LNA achieves an NF of 0.81–1.09 dB and a gain of over 20.1 dB in the frequency range of 3.3–8.0 GHz. The input and output return losses are maintained over 10 dB and 9.7 dB, respectively.

16 October 2026 in Electronics
Verified
Journal Article
Open access
PDF file
ishath harshika hewa maddumageishath harshika hewa maddumage
ishath harshika hewa maddumage
JLJiyoung Lee
Jiyoung Lee
Jaehun LeeJaehun Lee
Jaehun Lee
Gwanghyeon JeongGwanghyeon Jeong
Gwanghyeon Jeong
DLDong-Ho Lee
Dong-Ho Lee
This paper presents a 6–11 GHz monolithic microwave integrated circuit (MMIC) low-noise amplifier (LNA) with an integrated input limiter for broadband microwave receiver protection. The proposed limiter–LNA employs a three-stage common-source topology and an anti-parallel diode pair at the radio frequency (RF) input, and it is fabricated using a 0.25 μm GaAs pHEMT process. The limiter–LNA achieves a gain of 24.6–28.0 dB and a noise figure of 1.19–1.80 dB while consuming 34 mA from a 3.0 V supply in measurement. Its saturated output power is 12–13 dBm, with input and output third-order intercept points of −8 and 20 dBm, respectively. To evaluate the effect of the integrated limiter, the measurement results are compared with those of a standalone LNA employing the same amplifier topology. The main contribution is the realization of a favorable trade-off between limiter simplicity and broadband LNA performance using only a simple anti-parallel Schottky-diode pair, together with a direct experimental evaluation of the limiter-induced performance penalty and protection benefit. The comparison shows that the limiter introduces only a minor noise-figure penalty. High-input-power testing showed that the maximum input-power level without permanent characteristic changes increased from approximately 24 dBm for the standalone LNA to 29 dBm for the limiter–LNA. These results demonstrate that the integrated limiter improves the input-power survivability of the LNA while preserving its broadband gain and low-noise performance. The fabricated limiter–LNA occupies a chip dimension of 1.222 × 1.200 mm2.

27 May 2025 in Electronics
Verified
Journal Article
Open access
PDF file
ishath harshika hewa maddumageishath harshika hewa maddumage
ishath harshika hewa maddumage
Gwanghyeon JeongGwanghyeon Jeong
Gwanghyeon Jeong
Jusung KimJusung Kim
Jusung Kim
DLDong-Ho Lee
Dong-Ho Lee
In this article, we present a triple-band Doherty power amplifier (DPA) with a Schiffman phase shifter, which achieved a 90-degree phase shift to facilitate broad frequency range operations. As the cornerstone of the triple-band DPA, the Schiffman phase shifter enabled simultaneous triple-band operations. Furthermore, the entire triple-band Doherty amplifier was designed and fabricated using GaN on SiC HEMT devices, confirming its practical applicability and robust performance. It achieved an output power of 34 dBm at the low-band (LB) frequency of 0.8 GHz, accompanied by a peak drain efficiency (DE) of 53%. Similarly, at the mid-band (MB) frequency of 1.6 GHz, the amplifier maintained an output power of 32 dBm with an identical peak DE of 45%. At the high-band (HB) frequency of 2.2 GHz, the DPA continued to deliver an output power of 33 dBm, again with a peak DE of 50%.