Thanks to the continuous development of light-curing resin composites it is now possible to print permanent single-tooth restorations. The purpose of this study was to compare resin composites for milling -Gandio Blocks (GR), Brilliant Crios (CR) and Enamic (EN) with resin composite for 3D printing—Varseo Smile Crown plus (VSC). Three-point bending was used to measure flexural strength (σ_f) and flexural modulus (E_f). The microhardness was measured using a Vickers method, while fractographic, microstructural, texture and fractal dimension (FD) analyses were performed using SEM, optical microscope and picture analysis methods. The values of σ_f ranged from 118.96 (±2.81) MPa for EN to 186.02 (±10.49) MPa for GR, and the values of E_f ranged from 4.37 (±0.8) GPa for VSC to 28.55 (±0.34) GPa for EN. HV01 ranged from 25.8 (±0.7) for VSC to 273.42 (±27.11) for EN. The filler content ranged from 19–24 vol. % for VSC to 70–80 vol. % for GR and EN. The observed fractures are typical for brittle materials. The correlation between FD of materials microstructure and E_f was observed. σ_f of the printed resin depends on layers orientation and is significantly lower than σ_f of GR and CR. E_f of the printed material is significantly lower than E_f of blocks for milling.

There are significant discrepancies in the reported prevalence of condylar process fractures among all mandibular fractures (16.5–56%) in the available literature. In addition, it seems that the actual number of difficult-to-treat fractures of the mandibular head is unknown. The purpose of this study is to present the current incidence of the different types of mandibular process fractures with a special focus on mandibular head fractures. The medical records of 386 patients with single or multiple mandibular fractures were reviewed. Of the fractures found, 58% were body fractures, 32% were angle fractures, 7% were ramus fractures, 2% were coronoid process fractures, and 45% were condylar process fractures. The most common fracture of the condylar process was a basal fracture (54% of condylar fractures), and the second most common fracture was a fracture of the mandibular head (34% of condylar process fractures). Further, 16% of patients had low-neck fractures, and 16% had high-neck fractures. Of the patients with head fractures, 8% had a type A fracture, 34% had a type B fracture, and 73% had a type C fracture. A total of 89.6% of the patients were surgically treated with ORIF. Mandibular head fractures are not as rare as previously thought. Head fractures occur twice as often in the pediatric population than in adults. A mandibular fracture is most likely related to a mandible head fracture. Such evidence can guide the diagnostic procedure in the future.