Jon Pinkham

Mr. Jon Pinkham

University of Maine, Orono, Maine, USA

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 April 2022 in Materials
Verified
Journal Article
Open access
PDF file
Jose Luis Colon QuintanaJose Luis Colon Quintana
Jose Luis Colon Quintana
LSLucinda Slattery
Lucinda Slattery
JPJon Pinkham
Jon Pinkham
JKJoanna Keaton
Joanna Keaton
Roberto A Lopez-AnidoRoberto A Lopez-Anido
Roberto A Lopez-Anido
KSKeith Sharp
Keith Sharp
Large format polymer extrusion-based additive manufacturing has been studied recently due to its capacity for high throughput, customizable bead size and geometry, and ability to manufacture large parts. Samples from three fiber-filled amorphous thermoplastic materials 3D printed using a Masterprint 3X machine from Ingersoll Machine Tools were studied, along with their neat counterparts. Characterization techniques included thermogravimetric analysis (TGA), differential scanning calorimetry (DSC), and thermo-mechanical analysis (TMA). TGA results showed that the fillers decreased the degradation temperature for most of the materials investigated, with a 30 °C decrease for polycarbonate (PC) and a 12 °C decrease for polyethylene terephthalate glycol (PETG). For all the materials used, heat capacity increases with increasing temperature. Moreover, results show that a highly conductive filler increases the heat capacity. In contrast, a material with a lower conductivity decreases the heat capacity indicated in the 15.2% and 2.54% increase for acrylonitrile butadiene styrene (ABS) and PC and a 27.68% decrease for PETG. The TMA data show that the printed bead exhibits directional properties consistent with an orthotropic material. Smaller strains and coefficient of thermal expansion (CTE) were measured along the bead direction and across the bead compared to the through bead thickness showing that fillers are predominantly oriented in the bead direction, which is consistent with the literature. CTE values through bead thickness and neat material are similar in magnitude, which corresponds to the CTE of the matrix material. The experimental results serve to characterize the effect of fiber filler on the part thermal strains in three principal directions and two-part locations during the extrusion and bead deposition of large-format polymer extrusion-based additive manufacturing technologies.

1 May 2024 in Journal of Bridge Engineering
Verified
Journal Article
Closed access
JPJon Pinkham
Jon Pinkham
WDWilliam G Davids
William G Davids
ASAndrew Philip Schanck
Andrew Philip Schanck