The aerobic granular sludge (AGS) process is an effective wastewater treatment technology for organic matter and nutrient removal that has been introduced in the market rapidly. Until now, limited information is available on AGS regarding the removal of bacterial and viral pathogenic organisms present in sewage. This study focussed on determining the relation between reactor operational conditions (plug flow feeding, turbulent aeration and settling) and physical and biological mechanisms on removing two faecal surrogates, Escherichia coli and MS2 bacteriophages. Two AGS laboratory-scale systems were separately fed with influent spiked with 1.0 × 106 CFU/100 mL of E. coli and 1.3 × 108 PFU/100 mL of MS2 bacteriophages and followed during the different operational phases. The reactors contained only granular sludge and no flocculent sludge. Both systems showed reductions in the liquid phase of 0.3 Log10 during anaerobic feeding caused by a dilution factor and attachment of the organisms on the granules. Higher removal efficiencies were achieved during aeration, approximately 1 Log10 for E. coli and 0.6 Log10 for the MS2 bacteriophages caused mainly by predation. The 18S sequencing analysis revealed high operational taxonomic units (OTUs) of free-living protozoa genera Rhogostoma and Telotrochidium concerning the whole eukaryotic community. Attached ciliates propagated after the addition of the E. coli, an active contribution of the genera Epistylis, Vorticella, and Pseudovorticella was found when the reactor reached stability. In contrast, no significant growth of predators occurred when spiking the system with MS2 bacteriophages, indicating a low contribution of protozoa on the phage removal. Settling did not contribute to the removal of the studied bacterial and viral surrogates.
1 September 2021 in Journal of Water Supply: Research and Technology—AQUA
This study employs a novel combined pilot plant consisting of an anaerobic reactor followed by a membrane electrochemical bioreactor (eMBR) to treat domestic water containing selected contaminants of emerging concern (CECs) [ibuprofen (IB), carbamazepine (CBZ), diclofenac (DCF) and 17α-ethinylestradiol (EE2)]. The first phase operated as a conventional membrane bioreactor to achieve the removal of organic matter [chemical oxygen demand (COD)], the CECs and phosphorus. A removal rate of 96.3% for COD, 94.5% for IB, 37.1% for CBZ, 87.1% for DCF and 96% for EE2 was obtained. In the three subsequent phases, current density (CD) of 5, 10 and 15 A/m2 was applied successively in the eMBR with the aim of investigating the effects on the removal of the former components and the fouling of the membrane. After the application of 5 and 10 A/m2 CD, the removal rate of COD decreased. Regarding phosphorus, a CD of 5 A/m2 was enough to achieve the rate of 97% and the membrane fouling suffered a substantial reduction too. Finally, the experimental results were subject to statistical analysis using the Kruskal–Wallis and Wilcoxon tests to validate the influence of each CD.
COVID-19 is a terrible virus that has impacted human health and the economy on a global scale. The detection and control of the pandemic have become necessities that require appropriate monitoring strategies. One of these strategies involves measuring and quantifying the virus in water at different stages of the Urban Water Cycle (UWC). This article presents a comprehensive literature review of the analyses and quantifications of SARS-CoV-2 in multiple UWC components from 2020 to June 2021. More than 140 studies worldwide with a focus on industrialized nations were identified, mainly in the USA, Australia, and Asia and the European Union. Wastewater treatment plants were the focus of most of these studies, followed by city sewerage systems and hospital effluents. The fewest studies examined the presence of this virus in bodies of water. Most of the studies were conducted for epidemiological purposes. However, a few focused on viral load and its removal using various treatment strategies or modelling and developing strategies to control the disease. Others compared methodologies for determining if SARS-CoV-2 was present or included risk assessments. This is the first study to emphasize the importance of the various individual components of the UWC and their potential impacts on viral transmission from the source to the public.
4 March 2021 in Journal of Applied Water Engineering and Research
In this study, the potential utilization of sediments deposited in pluvial sanitation systems for engineering applications was investigated using the pluvial sub-basin occupied by the town of Puente Aranda for residential, commercial, and industrial land use in Bogotá city as a case study. The sediment samples were collected at different locations during three different climatic seasons to assess their physical and chemical characteristics. All samples contained more than 70% silt. The highest content ruthenium oxide, phosphorus oxide, potassium oxide, and titanium oxide corresponded with residential land use. Silica and calcium oxide dominate in areas of commercial land use. The results of this study demonstrate that sewer sediments can be used to manufacture Portland cement and pozzolans; however, the addition of calcium carbonate is necessary to increase the lime content in the extracted solids.