The Poza de la Sal diapir is a closed circular depression with Cretaceous Mesozoic materials, formed by gypsum, Keuper clays, and a large extension of salt in the center with intercalations of ophite. The low seismic activity of the area, the reduced permeability and porosity of the salt caverns, and the proximity to the Páramo de Poza wind park, make it a suitable place for the construction of a facility for underground storage of green hydrogen obtained from surplus wind power. The design of a cavern for hydrogen storage at a depth of 1000 m takes into account the differences in stresses, temperatures, and confining pressures involved in the salt deformation process. During the 8 months of the injection phase, 23.0 GWh can be stored in the form of hydrogen obtained from the wind energy surplus, to be used later in the extraction phase. The injection and extraction ratio must be developed under the conditions of geomechanical safety of the cavity, so as to minimize the risks to the environment and people, by conditioning the gas pressure inside the cavity to remain within a given range.
1 November 2018 in International Journal of Greenhouse Gas Control
The production of agricultural waste is associated with environmental problems and risks to public health. The general interest demands, as an ecological alternative, the proper management of waste generated by industrial activity through its transformation into value-added products. Carbonization/activation (2 h/2 h) at 700 °C in a vertical furnace (20 K/min), to produce biochar and activated carbon (AC) from bamboo, orange, and paulownia residue, was carried out in a laboratory facility with physical activation by CO2 and steam. The characterization of the carbonaceous material obtained was based on the determination of the N2 adsorption–desorption isotherms at 77 K, the specific surface area with the BET procedure, and its internal structure by means of SEM images. The BET surface area values obtained as a function of the CO2/steam agent used were 911/1182 m2/g, 248/388 m2/g, and 800/1166 m2/g for bamboo, orange, and paulownia, respectively. The range of variation of porosity in paulownia residue generated after steam activation was 485–1166 m2/g, varying depending on the degree of maturity of the biomass used. Research has shown that both the type of activation agent used to produce AC and the degree of plant maturation of the precursor residue affect the quality and characteristics of the final product.
1 November 2016 in International Journal of Greenhouse Gas Control
After the Paris Agreement in which 195 countries are involved, the Carbon Capture and Storage (CCS) is now an accepted technology in the United Nations Framework Convention on Climate Change (UNFCCC). In Spain, Fundación Ciudad de la Energía (CIUDEN) has successfully completed the full CCS chain, being CO2 captured in the Technology Development Centre in Cubillos del Sil (León, Spain) whereas that it is geologically stored in a deep saline aquifer, formed by fractured carbonates with poor matrix porosity, located in the Technology Development Plant (TDP) at Hontomín (Burgos, Spain). The results of the field tests, in which up to 150 tons of CO2 and synthetic air (5 %v of N2 and O2) were co-injected on site, are analyzed in this paper comparing the operational parameters gained during the injection of impure CO2 (pressures, temperatures and flow ranges) with its corresponding baseline previously determined (i.e. 1,500 tons of pure CO2 were injected during the reservoir hydraulic characterization). Besides that, the geochemical reactivity analysis of impure CO2 injected in this saline aquifer and its correlation with the results from laboratory tests were assessed. As main conclusions from laboratory scale results, a porosity diminution was measured after the injection of CO2 with 5 %v of SO2; apart from that, without SO2, the effluent pH was in the range of 7-8 whereas in case of CO2 and SO2, a pH of 1-2 was obtained. Otherwise and focused on field scale tests, a density decrease was detected comparing the base case (pure CO2) with the CO2 injection containing 5.1 %v of synthetic air. On the other hand, Ca2+, SO42-, Mg2+ and K+ migration effects in the rock were also detected and analyzed
The new international outlook for the gas sector suggests evaluating exploitable reserves in previously unconsidered areas including hydraulic fracturing technology. In order to estimate the amount of gas in the Jaca Flysch formation, the analysis of geological and geophysical logs and the volumetric method have been used. It has been taking into account the part of the formation likely to contain gas, the porosity (2.65%) calculated from sonic logs with Wyllie’s equation, the water saturation (35.3%) with Archie’s formula, and the initial gas formation volume factor (Bgi), estimated with MHA-P3 software with the reservoir pressure/temperature data 3600 psi/90 °C. The economic analysis of each well has been carried out based on three options, without stimulation, with 50% and 100% stimulation by fracking, and five possible construction costs (7.5–15 MM€). The impact of the use of the fracking technology on the production of the well is about 48%. The production rate and the economic impact that its exploitation would have on the domestic demand for natural gas has been analyzed, resulting in a significant contribution to the national energy mix of between 10–20% of consumption for several years.