Luigi Galotto Junior

Prof. Luigi Galotto Junior

Federal University of Mato Grosso do Sul (UFMS)
orcid

Research Focus & Metrics

Academic Career Length

22Years (2005-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 May 2012 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
MBMoacyr Aureliano Gomes de Brito
Moacyr Aureliano Gomes de Brito
LJLuigi Galotto Junior
Luigi Galotto Junior
LSLeonardo Poltronieri Sampaio
Leonardo Poltronieri Sampaio
GMGuilherme de Azevedo e Melo
Guilherme de Azevedo e Melo
CCCarlos Alberto Canesin
Carlos Alberto Canesin
This paper presents evaluations among the most usual maximum power point tracking (MPPT) techniques, doing meaningful comparisons with respect to the amount of energy extracted from the photovoltaic (PV) panel [tracking factor (TF)] in relation to the available power, PV voltage ripple, dynamic response, and use of sensors. Using MatLab/Simulink and dSPACE platforms, a digitally controlled boost dc-dc converter was implemented and connected to an Agilent Solar Array E4350B simulator in order to verify the analytical procedures. The main experimental results are presented for conventional MPPT algorithms and improved MPPT algorithms named IC based on proportional-integral (PI) and perturb and observe based on PI. Moreover, the dynamic response and the TF are also evaluated using a user-friendly interface, which is capable of online program power profiles and computes the TF. Finally, a typical daily insulation is used in order to verify the experimental results for the main PV MPPT methods.

19 February 2019 in IEEE Transactions on Industry Applications
Verified
Journal Article
Closed access
EMEmilio Tanowe Maddalena
Emilio Tanowe Maddalena
CMCaio Guilherme da Silva Moraes
Caio Guilherme da Silva Moraes
GBGuilherme Braganca
Guilherme Braganca
LJLuigi Galotto Junior
Luigi Galotto Junior
RGRuben Godoy
Ruben Godoy
JPJoao Onofre Pereira Pinto
Joao Onofre Pereira Pinto

8 September 2023 in IEEE Access
Verified
Journal Article
Open access
RRRenata Rezende C. Reis
Renata Rezende C. Reis
MKMarcio L. Magri Kimpara
Marcio L. Magri Kimpara
LJLuigi Galotto Junior
Luigi Galotto Junior
JPJoão Onofre Pereira Pinto
João Onofre Pereira Pinto
This work addresses the application of the Genetic Algorithm (GA) technique to optimize the commutation angles of a 2 kW 8/6 switched reluctance machine (SRM). The primary goal is to reduce the well-known drawback of SRMs: the torque ripple. Firstly, the machine was modeled in Matlab/Simulink® using lookup tables obtained via finite element method (FEM) simulations. Subsequently, the model was used to perform the GA routine aiming to find the optimal phase commutation angles that minimize the torque ripple factor. Notably, the torque performance of the SRM was significantly affected by the commutation angles during the search for the optimal solution. Afterwards, the GA results for four different operation points were verified experimentally through a developed drive platform with digital signal processor-based (DSP) control and an asymmetric bridge converter. As showed by the experiments, the proposed approach was suitable to reduce the torque ripple by more than 50% for one of the evaluated operating points. Furthermore, it was confirmed that the torque ripple mitigation led to acoustic noise improvement.

1 September 2011
Verified
Conference Paper
Closed access
LJLuigi Galotto Junior
Luigi Galotto Junior
MBMoacyr Aureliano Gomes de Brito
Moacyr Aureliano Gomes de Brito
LSLeonardo Poltronieri Sampaio
Leonardo Poltronieri Sampaio
CCCarlos A. Canesin
Carlos A. Canesin
The aim of this work is to present two topological simplified converters named Tri-state Boost and Tri-state Buck-Boost integrated single-phase inverters. An important operation capability can be achieved for these converters using a Tri-state Modulation control scheme. This is the inductive power decoupling and the independent input output control. These features are directly related with the photovoltaic micro-converter needs, improving efficiency, cost and mainly lifetime. These features for the proposed modulation are confirmed through experimental results.

1 September 2008 in Sba: Controle & Automação Sociedade Brasileira de Automatica
Verified
Journal Article
Open access
PDF file
CACristiano Quevedo Andrea
Cristiano Quevedo Andrea
JPJoão Onofre Pereira Pinto
João Onofre Pereira Pinto
EAEdvaldo Assunção
Edvaldo Assunção
MTMarcelo Carvalho Minhoto Teixeira
Marcelo Carvalho Minhoto Teixeira
LJLuigi Galotto Junior
Luigi Galotto Junior
Neste trabalho é proposta uma metodologia de rastreamento de sinais e rejeição de distúrbios aplicada a sistemas não-lineares. Para o projeto do sistema de rastreamento, projeta-se os controladores fuzzy M(a) e N(a) que minimizam o limitante superior da norma H∞ entre o sinal de referência r(t) e o sinal de erro de rastreamento e(t), sendo e(t) a diferença entre a entrada de referência e a saída do sistema z(t). No método de rejeição de distúrbio utiliza-se a realimentação dinâmica da saída através de um controlador fuzzy Kc(a) que minimiza o limitante superior da norma H∞ entre o sinal de entrada exógena w(t) e o sinal de saída z(t). O procedimento de projeto proposto considera as não-linearidades da planta através dos modelos fuzzy Takagi-Sugeno. Os métodos são equacionados utilizando-se inequações matriciais lineares (LMIs), que quando factíveis, podem ser facilmente solucionados por algoritmos de convergência polinomial. Por fim, um exemplo ilustra a viabilidade da metodologia proposta.A design method for tracking system with disturbance rejection applied to nonlinear systems using fuzzy control is proposed in this paper. Fuzzy feedforward controllers M(a) and N(a) are designed in order to obtain the tracking system. These controllers minimize the H∞-norm from the reference input signal r(t) to the tracking error signal e(t), where the tracking error signal is the difference between the reference input signal r(t) and the output signal z(t). A dynamic feedback fuzzy controller Kc(a) is designed in order to minimize the H∞-norm from the disturbance input w(t) to the output z(t). The designs are formulated in Linear Matrix Inequality (LMI) framework, such that the optimal solutions of the stated control problems are obtained. Simulation of a practical problem illustrates the effectiveness of the proposed method

2 October 2021 in Energies
Verified
Journal Article
Open access
PDF file
LSLarissa Souza
Larissa Souza
RGRuben Godoy
Ruben Godoy
MSMatheus Arakaki de Souza
Matheus Arakaki de Souza
LJLuigi Galotto Junior
Luigi Galotto Junior
MBMoacyr Aureliano Gomes de Brito
Moacyr Aureliano Gomes de Brito
This article presents a study of the sampling rate effect on electrical power measurements whose definitions are based on the Conservative Power Theory (CPT). The definitions of active power and reactive power of the CPT were applied in the MATLAB® software by varying the sampling rate and using a digital power meter as a reference. The measurements were performed in scenarios with linear and non-linear loads. Due to the usage of an integral in the CPT calculus, an error was verified associated with the reactive power being inversely proportional to the sampling rate. From the present study, it is possible to conclude that depending on the sample rate, the errors associated with the reactive power measurements are unacceptable and make the CPT implementation unfeasible. The results also presented effective information about the minimal sampling rate needed to make these errors neglected and to assist in choosing suitable microprocessors for the digital implementation of the CPT. It is worth mentioning that this paper was limited to assess how accurate the measurements of active and reactive powers were and important to highlight that the CPT has the additional contribution of dealing with distortion currents and consequently new portions of powers. For the latter, the influence of sampling rate may be crucial and new lines of investigation are motivated.