Farhad Salek

Mr. Farhad Salek

Faculty of Mechanical and Mechatronics Engineering, Shahrood University of Technology, Shahrood, Iran

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 February 2021 in Applied Sciences
Verified
Journal Article
Open access
PDF file
Farhad SalekFarhad Salek
Farhad Salek
Meisam BabaieMeisam Babaie
Meisam Babaie
ASAmin Shakeri
Amin Shakeri
SHSeyed Vahid Hosseini
Seyed Vahid Hosseini
Timothy BodiscoTimothy Bodisco
Timothy Bodisco
AZAli Zare
Ali Zare
This study aims to investigate the effect of the port injection of ammonia on performance, knock and NOx emission across a range of engine speeds in a gasoline/ethanol dual-fuel engine. An experimentally validated numerical model of a naturally aspirated spark-ignition (SI) engine was developed in AVL BOOST for the purpose of this investigation. The vibe two zone combustion model, which is widely used for the mathematical modeling of spark-ignition engines is employed for the numerical analysis of the combustion process. A significant reduction of ~50% in NOx emissions was observed across the engine speed range. However, the port injection of ammonia imposed some negative impacts on engine equivalent BSFC, CO and HC emissions, increasing these parameters by 3%, 30% and 21%, respectively, at the 10% ammonia injection ratio. Additionally, the minimum octane number of primary fuel required to prevent knock was reduced by up to 3.6% by adding ammonia between 5 and 10%. All in all, the injection of ammonia inside a bio-fueled engine could make it robust and produce less NOx, while having some undesirable effects on BSFC, CO and HC emissions.

27 September 2020 in Processes
Verified
Journal Article
Open access
PDF file
Farhad SalekFarhad Salek
Farhad Salek
Meisam BabaieMeisam Babaie
Meisam Babaie
María Dolores Redel-MacíasMaría Dolores Redel-Macías
María Dolores Redel-Macías
AGAli Ghodsi
Ali Ghodsi
SHSeyed Vahid Hosseini
Seyed Vahid Hosseini
AZAli Zare
Ali Zare
It has been proven that vehicle emissions such as oxides of nitrogen (NOx) are negatively affecting the health of human beings as well as the environment. In addition, it was recently highlighted that air pollution may result in people being more vulnerable to the deadly COVID-19 virus. The use of biofuels such as E5 and E10 as alternatives of gasoline fuel have been recommended by different researchers. In this paper, the impacts of port injection of water to a spark ignition engine fueled by gasoline, E5 and E10 on its performance and NOx production have been investigated. The experimental work was undertaken using a KIA Cerato engine and the results were used to validate an AVL BOOST model. To develop the numerical analysis, design of experiment (DOE) method was employed. The results showed that by increasing the ethanol fraction in gasoline/ethanol blend, the brake specific fuel consumption (BSFC) improved between 2.3% and 4.5%. However, the level of NOx increased between 22% to 48%. With port injection of water up to 8%, there was up to 1% increase in engine power whereas NOx and BSFC were reduced by 8% and 1%, respectively. The impacts of simultaneous changing of the start of combustion (SOC) and water injection rate on engine power and NOx production was also investigated. It was found that the NOx concentration is very sensitive to SOC variation.