Maha Almoneef

Dr. Maha Almoneef

Princess Nourah bint Abdulrahman University
orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 March 2022 in Nanomaterials
Verified
Journal Article
Open access
PDF file
Muhammad AmjadMuhammad Amjad
Muhammad Amjad
MIMuhammad Iftikhar
Muhammad Iftikhar
NANorah Mohammed alwadai
Norah Mohammed alwadai
MIMuhammad Irfan
Muhammad Irfan
IHIKRAM UL HAQ
IKRAM UL HAQ
MIMunawar Iqbal
Munawar Iqbal
In the present investigation, ZnO films co-doped with Mn and La were synthesized by the sol–gel technique. XRD analysis revealed that ZnO had a hexagonal structure. Mixed hexagonal and cubic phases appeared in ZnO containing Mn (1%) and La (1.5%). The grain size, d-spacing, unit cell, lattice parameters, atomic packing fraction, volume, strain, crystallinity, and bond length of co-doped ZnO films were determined as a function of doped ion contents. Through UV analysis, it was found that pristine ZnO had Eg = 3.5 eV, and it decreased when increasing the doping concentration, reaching the minimum value for the sample with 1% Mn and 1% La. The optical parameters of the films, such as absorption, transmittance, dielectric constants, and refractive index, were also analyzed. DSSCs were fabricated using the prepared ZnO films. For pure ZnO film, the values were: efficiency = 0.69%, current density = 2.5 mAcm−2, and open-circuit voltage = 0.56 V. When ZnO was co-doped with Mn and La, the efficiency increased significantly. DSSCs with a ZnO photoanode co-doped with 1% Mn and 1% La exhibited maximum values of Jsc = 4.28 mAcm−2, Voc = 0.6 V, and efficiency = 1.89%, which is 174% better than pristine ZnO-based DSSCs. This material is good for the electrode of perovskite solar cells.

13 June 2024 in Heliyon
Verified
Journal Article
Open access
MAMaha Almoneef
Maha Almoneef
MAManal Ahmed Awad
Manal Ahmed Awad
AAAldosari Aldosari
Aldosari Aldosari
AHAwatif A. Hendi
Awatif A. Hendi
HAHoriah Abdulaziz ALdehaish
Horiah Abdulaziz ALdehaish
SASaad Alshammari
Saad Alshammari
This research describes the methodology for synthesizing zinc oxide nanoparticles (ZnO-NPs). It demonstrates a unique, cost-effective, and non-toxic chemical technique for producing ZnO-NPs using the precipitation method with NaOH as reducing and capping agents. The formed nanoparticles have been characterized and analyzed using numerous techniques such as; Fluorescence emission spectroscopy (FL), X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), energy-dispersive X-ray Spectroscopy (EDX), ultraviolet-visible optical absorption (UV-Vis), Fourier transform infrared spectroscopy (FTIR), and Thermal gravimetric analysis (TGA). Also, the analytical technique X-ray diffraction studies has been used which showed that the ZnO-NPs had a Wurtzite hexagonal crystal structure with an average crystallite size of 34.27 nm. The form and the size of the synthesized ZnO-NPs have been seen in SEM and TEM photographs. Using J-image, particle size has been obtained at 13.33 nm, and the grain boundaries were all approximately spherical. Peaks in the FT-IR spectrum of the NPs indicate the presence of carboxylate (COO) and hydroxyl (O-H) functional groups. According to these findings, Zn interstitial defects are responsible for the 380 nm emission peak. Since EDX could not identify any impurities below the detection threshold, we may be sure that Zn and O are the principal components of the synthesized sample. ZnO-NPs cause an absorption band at 350.34 nm in the UV-Vis spectrum and a band gap of 3.24 eV. The catalytic activity of the synthesized ZnO nanoparticles (NPs) was evaluated by investigating their effectiveness in degrading crystal violet (CV) and methylene blue (MB) dyes, along with assessing the degradation rates. The results demonstrated a high degradation efficiency, with ZnO NPs achieving approximately 96.72 % degradation for CV and 97.169 % for MB dyes, underscoring their remarkable efficacy in the degradation process. As for antimicrobial activity assessment, the results revealed that the ZnO-NPs had negligible impact on Gram-negative bacteria, whereas they exhibited a discernible effect on Gram-positive bacteria. Additionally, it showed anti-cancer potential against colon (SW480), breast (MDA-231), and cervix (HELA) lines cells as seen by (MTT) assay. Hence, due to its simplified processes and cheaper chemicals, our synthesis technique may use in industrial settings for various applications.

1 August 2022 in Materials
Verified
Journal Article
Open access
PDF file
SHSaddam Hussain
Saddam Hussain
NANorah Mohammed alwadai
Norah Mohammed alwadai
MIMuhammad Iftikhar
Muhammad Iftikhar
MIMuhammad Irfan
Muhammad Irfan
IHIKRAM UL HAQ
IKRAM UL HAQ
MIMunawar Iqbal
Munawar Iqbal
A competitive new technology, organic metallic halide perovskite solar cells feature a wide working area, low manufacturing costs, a long lifespan, and a significant amount of large efficacy of power conversion (PCE). The spin-coating technique was utilized for the fabrication of pure CH3NH3PbBr3 (MAPbBr3) thin films, and these films are implanted with 600 keV silver (Ag) ions at fluency rate of 6 × 1014 and 4 × 1014 ions/cm2. XRD analysis confirmed the cubic structure of MAPbBr3. A high grain size was observed at the fluency rate of 4 × 1014 ions/cm2. The UV-Vis spectroscopic technique was used to calculate the optical properties such as the bandgap energy (Eg), refractive index (n), extinction coefficients (k), and dielectric constant. A direct Eg of 2.44 eV was measured for the pristine film sample, whereas 2.32 and 2.36 eV were measured for Ag ion-implanted films with a 4 × 1014 and 6 × 1014 ions/cm2 fluence rate, respectively. The solar cells of these films were fabricated. The Jsc was 6.69 mA/cm2, FF was 0.80, Voc was 1.1 V, and the efficiency was 5.87% for the pristine MAPbBr3-based cell. All of these parameters were improved by Ag ion implantation. The maximum values were observed at a fluency rate of 4 × 1014 ions/cm2, where the Voc was 1.13 V, FF was 0.75, Jsc was 8.18 mA/cm2, and the efficiency was 7.01%.

15 March 2022 in Coatings
Verified
Journal Article
Open access
PDF file
MIMuhammad Iftikhar
Muhammad Iftikhar
AMAmna Mukhtar
Amna Mukhtar
NANorah Mohammed alwadai
Norah Mohammed alwadai
MIMuhammad Irfan
Muhammad Irfan
IHIKRAM UL HAQ
IKRAM UL HAQ
MIMunawar Iqbal
Munawar Iqbal
We prepared 1% Bi- and (0, 0.5%, 1% and 1.5%) Sb- co-doped MAPbBr3 films by a sol-gel spin coating technique. For the first time, the detailed structural properties including grain size, dislocation line density, d-spacing, lattice parameters, and volume of co-doped MAPbBr3 films have been investigated. XRD confirmed the cubic structure of MAPbBr3 with high crystallinity and co-doping of Bi and Sb. The 1% Bi and 1% Sb co-doping have a surprising effect in MAPbBr3 structures, such as large grain size (59.5 nm), d-space value (6.23 Å), small dislocation line dislocation (2.79 × 1018 m−2), and small lattice parameters (a = b = c = 6.3 Å) and volume of unit cell. The detailed optical properties, including energy band gap (Eg), refractive index (n), extinction coefficient (k) and dielectric constant (Ɛ), which are very important for optoelectronics applications, were investigated by UV-Vis spectroscopy. The film of 1% Bi and 1% Sb co-doped MAPbBr3 showed good optical response including small Eg, high n, low value of k, high real and low imaginary parts of dielectric constant, making it good for solar cell applications. Solar cells were fabricated from these films. The cell fabricated with pure MAPbBr3 has Jsc of 8.72 mA cm−2, FF of 0.66, Voc of 1.29 V, and η of 7.5%. All the parameters increased by co-doping of Bi and Sb in MAPbBr3 film. The cell fabricated with 1% Bi and 1% Sb co-doped MAPbBr3 film had high current density (12.12 mA-cm−2), open circuit voltage (Voc), fill factor (0.73), and high efficiency (11.6%). This efficiency was 65% larger than a pure MAPbBr3-based solar cell.

23 December 2022 in Materials
Verified
Journal Article
Open access
PDF file
Jahanzeb KhanJahanzeb Khan
Jahanzeb Khan
INIrsa Naseem
Irsa Naseem
SBSaiqa Bibi
Saiqa Bibi
SAshakeel Ahmed
shakeel Ahmed
FAFaizah Altaf
Faizah Altaf
KAKhalil Ahmad
Khalil Ahmad
The synthesis of nanoparticles (NPs) using the green route is environmentally harmonious and cost-effective compared to conventional chemical and physical methods. In this study, the green synthesis of silver NPs was carried out using an extract of Debregeasia salicifolia. The synthesized Ag NPs were characterized by means of different techniques i.e., UV-Vis spectroscopy, FTIR spectroscopy, SEM, and XRD. The XRD pattern exhibited distinctive Bragg’s peaks at (200), (111), (311), and (220). The XRD analysis confirmed the face-centered cubic geometry of the synthesized NPs and revealed that the nature of these NPs is crystalline. The synthesized NPs were verified for their antibacterial activities against Gram-negative Escherichia coli (E. coli) and Gram-positive Staphylococcus aureus (S. aureus) bacteria. It showed that antibacterial activity of synthesized silver (NPs) was increased with increasing concentrations of both calcined and non-calcined NPs. The antioxidant activities of Ag NPs were also determined against ABTS at different concentrations for both calcined and non-calcined Ag NPs. Non-calcined Ag NPs have greater antioxidant activity than calcined Ag NPs. This report has a significant medicinal application, and it might open up new horizons in this field.

6 March 2021 in International Journal of Energy Research
Verified
Journal Article
Closed access
PDF file
IBIsmat Bibi
Ismat Bibi
TNTahmina Naz
Tahmina Naz
FMFarzana Majid
Farzana Majid
SKShagufta Kamal
Shagufta Kamal
SASadia Ata
Sadia Ata
MIMunawar Iqbal
Munawar Iqbal