The dynamics of high-pressure gas flow injected through a nozzle during a thermal cutting process has an important effect on cutting performance. In this study, an actual gas flow condition inside a cut kerf of a plasma cut sample was simulated by considering various geometric features of the cut kerf, such as kerf width difference and cutting length difference between the top and bottom surfaces. A prototype cut kerf shape was fabricated using a transparent material. A gas flow shadowgraph from inside the fabricated cut kerf was observed using the Schlieren method. In addition, image processing was performed on images obtained with the Schlieren method before and after gas injection, which were used to validate the numerical simulation models. The effect of turbulent viscosity in various turbulent models was studied using computational fluid dynamics analyses. The results confirmed that the k–ω turbulent model was the most suitable turbulent model for the geometry used in this study. The simulation results for this model were qualitatively consistent with the reported experimental measurements.
Consistency in gas flow behavior under various operating conditions is expected for uniform cutting performance in the thermal cutting process. The slope of the cut front in the kerf slot of a sample cutting material varies with the operating condition which affects the gas flow pattern. Therefore, how the nozzle exit diameter and the slope of the cut front effects gas flow behavior has been studied using the Reynolds averaged Navier–Stokes (RANS) based k–ω turbulence model. Convergent–straight-type nozzles with exit diameters φexit of 1.5 mm, 2 mm and 2.5 mm were used to study the flow patterns through the kerf slots of variable cut front slopes. The numerical simulation results were then compared with the results obtained from the Schlieren experiments. In addition, image processing was performed in the Schlieren images for clear visualization and precise comparison of the numerical and experimental data. The results confirm that a nozzle with an exit diameter of 2 mm shows a higher consistency in flow behavior in variable operating conditions.
A feasibility study on the mass production of a small wind turbine blade using an injection molding process was conducted. The blade was divided into three sections suitable for injection molding, and the mold was designed and analyzed using Moldflow CAE S/W. The optimal feedstock material was selected through comparison and analysis of three candidate materials. A mold was manufactured to test the injection molding process and evaluate related parameters. The resulting blade was assembled with other components, and a generator was installed to assess its durability, safety, and performance under various conditions. The results indicated the feasibility of producing a blade for a small wind turbine through injection molding, which predicted higher productivity and lower costs compared to traditional manufacturing methods that rely heavily on manual labor.
31 December 2022 in Journal of Welding and Joining
To secure remote monitoring technology essential for dismantling nuclear power plants, this study measures the vibration signal of a base material using an accelerometer during the plasma arc cutting process, with the current and cutting speed used as variables. Following cutting, root mean square values and a spectrogram are obtained and power spectral density analysis is conducted on the time-series acceleration data. A longitudinal cross-sectional comparison of the base material is also performed. The success or failure of cutting is determined by the vibrational characteristics derived from the cutting process.