Bo Wang

Dr. Bo Wang

Northeastern University, Shenyang 110819, Liaoning Province, China
orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 December 2020 in Metals
Verified
Journal Article
Open access
PDF file
BWBo Wang
Bo Wang
XDXueyong Ding
Xueyong Ding
TJTianhua Ju
Tianhua Ju
XZXiaofei Zhang
Xiaofei Zhang
Gongjin ChengGongjin Cheng
Gongjin Cheng
A novel smelting reduction process called pre-reduction in rotary kiln and total oxygen melting pool is a promising route to reduce environmental pollution from the ironmaking industry. In this paper, the process parameters and appropriate efficiency of reduction in the pre-reduction process of the rotary kiln were investigated via the detection of the metallization rate, phase composition, and internal morphology of the product combining with the analysis of the off-gas. The results indicated that the parameters of reduction temperature, reduction holding time, and coal ratio have a remarkable influence on the metallization rate. The reduction temperature has the most significant effect, followed by the reduction time and the coal ratio. Furthermore, under the condition of reduction temperature 1000 °C, holding time 30 min, coal ratio = 1, a product with a metallization rate of more than 70% can be obtained, which meets the requirements of the rotary kiln process, and its CO2/CO value of the pre-reduction endpoint is appropriate. Continue to increase the temperature, holding time, and coal ratio can raise the metallization rate of the pellets, but only a little improvement and may cause reoxidation of the product.

22 October 2018 in Entropy
Verified
Journal Article
Open access
PDF file
TJTianhua Ju
Tianhua Ju
XDXueyong Ding
Xueyong Ding
Yingyi ZhangYingyi Zhang
Yingyi Zhang
WCWeiliang Chen
Weiliang Chen
XCXiangkui Cheng
Xiangkui Cheng
XYXinlin Yan
Xinlin Yan
It is important to know the activity interaction parameters between components in melts in the process of metallurgy. However, it’s considerably difficult to measure them experimentally, relying still to a large extent on theoretical calculations. In this paper, the first-order activity interaction parameter ( e s j ) of j on sulphur in Fe-based melts at 1873 K is investigated by a calculation model established by combining the Miedema model and Toop-Hillert geometric model as well as considering excess entropy and mixing enthalpy. We consider two strategies, with or without using excess entropy in the calculations. Our results show that: (1) the predicted values are in good agreement with those recommended by Japan Society for Promotion of Science (JSPS); and (2) the agreement is even better when excess entropy is considered in the calculations. In addition, the deviations of our theoretical results from experimental values | e S ( exp ) j − e S ( cal ) j | depend on the element j’s locations in the periodic table.