13 páginas, 9 figuras, 2 tablas.-- et al.-- El pdf del artículo es la versión pre-print.Presently, dynamic surface-based models are required to contain increasingly larger numbers of points and to propagate them over longer time periods. For large numbers of surface points, the octree data structure can be used as a balance between low memory occupation and relatively rapid access to the stored data. For evolution rules that depend on neighborhood states, extended simulation periods can be obtained by using simplified atomistic propagation models, such as the Cellular Automata (CA). This method, however, has an intrinsic parallel updating nature and the corresponding simulations are highly inefficient when performed on classical Central Processing Units (CPUs), which are designed for the sequential execution of tasks. In this paper, a series of guidelines is presented for the efficient adaptation of octree-based, CA simulations of complex, evolving surfaces into massively parallel computing hardware. A Graphics Processing Unit (GPU) is used as a cost-efficient example of the parallel architectures. For the actual simulations, we consider the surface propagation during anisotropic wet chemical etching of silicon as a computationally challenging process with a wide-spread use in microengineering applications. A continuous CA model that is intrinsically parallel in nature is used for the time evolution. Our study strongly indicates that parallel computations of dynamically evolving surfaces simulated using CA methods are significantly benefited by the incorporation of octrees as support data structures, substantially decreasing the overall computational time and memory usage.This work has been supported by Programa\ud de Becas de Excelencia de la Universidad Politécnica de Valencia\ud (PAID-09-09), MEXT Grant in Aid Research (Kakenhi: Silicon etching\ud (A) 19201026), and the Global COE program of Japan (GCOE,\ud Wakate JSPS Young Scientist Fund).Peer reviewe

This paper is framed into the Positron Emission Mammography (PEM) project, whose aim is to develop an innovative gamma ray sensor for early breast cancer diagnosis. Currently, breast cancer is detected using low-energy X-ray screening. However, functional imaging techniques such as PET/FDG could be employed to detect breast cancer and track disease changes with greater sensitivity. Furthermore, a small and less expensive PET camera can be utilized minimizing main problems of whole body PET. To accomplish these objectives, we are developing a new gamma ray sensor based on a newly released photodetector. However, a dedicated PEM detector requires an adequate data acquisition (DAQ) and processing system. The characterization of gamma events needs a free-running analog-to-digital converter (ADC) with sampling rates of more than 50 Ms/s and must achieve event count rates up to 10 MHz. Moreover, comprehensive data processing must be carried out to obtain event parameters necessary for performing the image reconstruction. A new generation digital signal processor (DSP) has been used to comply with these requirements. This device enables us to manage the DAQ system at up to 80 Ms/s and to execute intensive calculi over the detector signals. This paper describes our designed DAQ and processing architecture whose main features are: very high-speed data conversion, multichannel synchronized acquisition with zero dead time, a digital triggering scheme, and high throughput of data with an extensive optimization of the signal processing algorithms.

Every year, thousands of people undergo amputations due to trauma or medical conditions. The loss of an upper limb, in particular, has profound physical and psychological consequences for patients. One potential solution is the use of externally powered prostheses equipped with motorized artificial hands. However, these commercially available prosthetic hands are prohibitively expensive for most users. In recent years, advancements in 3D printing and sensor technologies have enabled the design and production of low-cost, externally powered prostheses. This paper presents a pattern-recognition-based human–prosthesis interface that utilizes surface electromyography (sEMG) signals, captured by an affordable device, the Myo armband. A Support Vector Machine (SVM) algorithm, optimized using Bayesian techniques, is trained to classify the user’s intended grasp from among nine common grasping postures essential for daily life activities and functional prosthetic performance. The proposal is viable for real-time implementations on low-cost platforms with 85% accuracy in grasping posture recognition.