Yan Savitsky

Dr. Yan Savitsky


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
Verified
Journal Article
Open access
PDF file
EKEvgenii Vasilevich Kozhevnikov
Evgenii Vasilevich Kozhevnikov
MTMIKHAIL TURBAKOV
MIKHAIL TURBAKOV
EREvgenii Riabokon
Evgenii Riabokon
ZIZakhar Ivanov
Zakhar Ivanov
AGAndrei Mikhailovich Golosov
Andrei Mikhailovich Golosov
YSYan Savitsky
Yan Savitsky
Rapid prototyping has a wide range of applications across various fields, both in industry and for private use. It enables the production of individual parts in a short time, independent of supply chains, which is particularly important in remote locations. Among all 3D printing technologies, stereolithography using photo resins is the most accessible and offers the highest printing quality. However, the strength properties of parts made from photo resins remain a critical concern. In this study, we conducted experimental research to investigate the effect of load vector orientation under uniaxial compression on the elastic and mechanical properties of 3D-printed cylindrical samples. The results revealed that samples with layers oriented at 60° to the load vector exhibited the highest strength, while those with layers at 30° to the load vector showed the lowest strength. Samples with layers aligned parallel or perpendicular to the load vector demonstrated similar strength properties. Under quasi-elastic loading, samples with layers parallel to the load vector exhibited the highest Young’s modulus and the lowest Poisson’s ratio. Conversely, samples with layers oriented at 30° to the load vector displayed the highest Poisson’s ratio. Microstructural analysis revealed that the anisotropy in the mechanical properties of the 3D-printed samples is attributed to the layered, heterogeneous structure of the photoresin, which exhibits varying degrees of polymerization along the printing axes. The upper part of each layer, with a lower degree of polymerization, contributes to the ductile behavior of the samples under shear stresses. In contrast, the lower part of the layer, with a higher degree of polymerization, leads to brittle behavior in the samples.

AOAlexander Andreevich Oskolkov
Alexander Andreevich Oskolkov
AKAleksandr Kochnev
Aleksandr Kochnev
SKSergey Krivoshchekov
Sergey Krivoshchekov
YSYan Savitsky
Yan Savitsky
The multi-scale study of rock properties is a necessary step in the planning of oil and gas reservoir developments. The amount of core samples available for research is usually limited, and some of the samples can be distracted. The investigation of core reconstruction possibilities is an important task. An approach to the real-size reconstruction of porous media with a given (target) porosity and permeability by controlling the parameters of FFF 3D printing using CT images of the original core is proposed. Real-size synthetic core specimens based on CT images were manufactured using FFF 3D printing. The possibility of reconstructing the reservoir properties of a sandstone core sample was proven. The results of gas porometry measurements showed that the porosity of specimens No.32 and No.46 was 13.5% and 12.8%, and the permeability was 442.3 mD and 337.8 mD, respectively. The porosity of the original core was 14% and permeability was 271 mD. It was found that changing the layer height and nozzle diameter, as well as the retract and restart distances, has a direct effect on the porosity and permeability of synthetic specimens. This study shows that porosity and permeability of synthetic specimens depend on the flow of the material and the percentage of overlap between the infill and the outer wall.

30 July 2021 in Gornyi Zhurnal
Verified
Journal Article
Closed access
YSYan Savitsky
Yan Savitsky
SGS. V. Galkin
S. V. Galkin