In this study, a four-stroke, naturally aspirated, single-cylinder, spark ignition engine was operated with neat gasoline fuel. In-cylinder pressure, performance, and emission values were obtained at full load and 2400-r/min constant engine speed. Using these values, a single-dimensional theoretical model was calibrated. A Kistler spark plug–type pressure sensor was used to obtain in-cylinder pressure. After validation of this single-dimensional theoretical model obtained by the help of a commercial engine analysis software (AVL-Boost), different levels of ethanol addition (2.5%, 5%, 10%, 15%, and 20%) into gasoline were analyzed and compared with neat gasoline fueled conditions. According to obtained results, NO x emissions increased with incremental amount of ethanol. The CO and total hydrocarbons emissions decreased; however, they can be controlled using after-treatment systems such as three-way catalyst.
3 February 2022 in Case Studies in Thermal Engineering
The present study experimentally investigates and compares the performance of a radiator system cooled by a water-ethylene glycol (70:30) based Al2O3-SiO2-TiO2 nanofluid, with that of a radiator cooled by a water/EG mixture. The equal pumping power criterion of the pump with an equal mass flow rate was used for comparison. Mass flow rate and nanoparticle volume fraction on a radiator cooling system and the radiator's capacity have been studied. Five different nanofluids were prepared with different composition ratios of Al2O3-SiO2-TiO2 with a total of 0.45 % nanoparticles. The flowrate changed in the range of 0.02–0.032 kg/s. The results showed that the increase in heat transfer is mainly due to the flow velocity and the nanoparticles added in different proportions to the base liquid. The UA value and enhancement ratio of NF1 compared to EG/W is 14–18.5 %, for NF2 it is 14.9–21.8 %, for NF3 it is 15.1–23.4 %, for NF4 it is 15.6–27.5 %, and for NF5 it is 15.9–30 % at 0.02 kg/s and 0.032 kg/s. According to the experimental study results, nanofluids with low concentrations of nanoparticles can enhance the heat transfer rate up to 30 % as a comparison with water/EG.
The typical meteorological year (TMY) method has common applications in building energy performance and solar energy studies. However, there is not any well accepted method for the wind energy applications such as the TMY. In the present study, a new reference year approach is proposed for wind energy applications. By using the proposed method, the reference wind year (RWY) datasets may be generated as in the TMY methodology for any measurement station which has the possibility to be used as a reference station in the measure-correlate-predict (MCP) analyses. The MCP calculations are so significant to estimate the long term wind conditions for a candidate wind farm site. In this study, a case study is performed for Turkey after giving the details of the proposed method. The results for the RWY approach has a good agreement with the long term data as in the TMY method. Therefore, the RWY concept has the possibility to make the MCP studies easier and faster.
1 January 2024 in International Journal of Energy Research
In recent years, the implementation of Tier 5 emission regulations for tractors has compelled manufacturers to conduct new research. Additionally, the process of hybridization has impacted the agricultural vehicle industry. This study focuses on the design and implementation of an energy management strategy (EMS) for a diesel–electric hybrid electric agricultural vehicle, based on real‐time optimization. Tractor drive systems, including both conventional and hybrid options, were introduced. Simulations were performed to compare fuel consumption and CO2 emissions between the two types of tractors. The data shows that hybrid vehicles produce 8.93% less CO2 than conventional vehicles. Furthermore, the fuel consumption of the tractor decreased from 1,880.2 to 1,712.5 g/km under hybrid operating conditions.
15 October 2025 in International Journal of Hydrogen Energy