Driving is a ubiquitous activity that requires both motor skills and cognitive focus. These aspects become more problematic for some seniors, who have underlining medical conditions and tend to lose some of these capabilities. Therefore, driving can be used as a controlled environment for the frequent, non-intrusive monitoring of bio-physical and cognitive status within drivers. Such information can then be utilized for enhanced assistive vehicle controls and/or driver health monitoring. In this paper, we present a novel multi-modal smart steering sleeve (S) system with an integrated sensing platform that can non-intrusively and continuously measure a driver’s physiological signals, including electrodermal activity (EDA), electromyography (EMG), and hand pressure. The sensor suite was developed by combining low-cost interdigitated electrodes with a piezoresistive force sensor on a single, flexible polymer substrate. Comprehensive characterizations on the sensing modalities were performed with promising results demonstrated. The sweat-sensing unit (SSU) for EDA monitoring works under a 100 Hz alternative current (AC) source. The EMG signal acquired by the EMG-sensing unit (EMGSU) was amplified to within 5 V. The force-sensing unit (FSU) for hand pressure detection has a range of 25 N. This flexible sensor was mounted on an off-the-shelf steering wheel sleeve, making it an add-on system that can be installed on any existing vehicles for convenient and wide-coverage driver monitoring. A cloud-based communication scheme was developed for the ease of data collection and analysis. Sensing platform development, performance, and limitations, as well as other potential applications, are discussed in detail in this paper.
7 February 2025 in Journal of the Mechanics and Physics of Solids
Elastocaloric polymers, whose performance typically relies on phase transformation between amorphous chains and crystalline domains, offer a promising alternative to traditional refrigeration technologies. While engineering polymer‐network architecture has shown the potential to boost elastocaloric performance, the role of topological defects remains unexplored despite their prevalence in real polymers. This study reports a defect‐engineering approach in end‐linked star polymers (ELSPs) that enables an adiabatic temperature change of up to 8.14 ± 1.76 °C at an ambient temperature above 65 °C, showing an enhancement of 39% compared to ELSPs with negligible defects. This defect‐regulated solid‐state cooling is attributed to two competing effects of dangling‐chain defects on strain‐induced crystallization (SIC) and temperature‐induced crystallization (TIC), synergistically regulating the adiabatic temperature change. Specifically, increasing dangling‐chain defects monotonically lowers ELSPs’ mechanical performance at high temperatures due to suppressed SIC, but nonmonotonically impacts the mechanical performance at low temperatures due to the competition between suppressed SIC and enhanced TIC.
Elastocaloric polymers, whose performance typically rely on phase transformation between amorphous chains and crystalline domains, offer a promising alternative to traditional refrigeration technologies. While engineering polymer-network architecture has shown the potential to boost elastocaloric performance, the role of topological defects remains unexplored despite their prevalence in real polymers. This study reports a defect-engineering approach in end-linked star polymers (ELSPs) that enables an adiabatic temperature change of up to 8.14± 1.6 °C at an ambient temperature of 60 °C, showing an enhancement of 39% compared to ELSPs with negligible defects. This defect-regulated solid-state cooling is attributed to two competing effects of dangling-chain defects on strain-induced crystallization (SIC) and temperature-induced crystallization (TIC), synergistically regulating the adiabatic temperature change. Specifically, increasing dangling-chain defects monotonically lowers ELSPs’ mechanical performance at high temperatures due to suppressed SIC, but nonmonotonically impacts the mechanical performance at low temperatures due to the competition between suppressed SIC and enhanced TIC.