In recent years, the demand for lithium, essential to the high-tech and battery sectors, has increased rapidly. The majority of lithium carbonate is now sourced from continental brines in Latin America, owing to the lower production costs and reduced environmental impact. In Europe, often overlooked but promising lithium resources could include highly mineralized underground waters. Therefore, this study investigates the enrichment of these low-grade solutions (<100 mg/L Li) through evaporation followed by solvent extraction (SX) processes under specific conditions. The effectiveness and the technical feasibility of lithium extraction were evaluated using binary synthetic, multicomponent semi-synthetic, and real brine samples. The popular tributyl phosphate/methyl isobutyl ketone (TBP/MIBK) system, supplemented with FeCl₃ and AlCl₃ as co-extractants, was employed as the organic phase. Evaporation resulted in significant lithium losses (up to 80%), reduced to ~10% by washing the crystallisate obtained during evaporation with ethanol. The results from SX tests revealed differences between the synthetic and real brines. While the synthetic brines exhibited satisfactory lithium extraction yields (91%), the real brines showed a significantly lower extraction efficiency (~32%), rendering the tested system ineffective. Solid phase precipitation during the SX trials was observed for both the synthetic and real brines, which were concentrated before the SX stage, highlighting the challenges in lithium-recovery processes. However, semi-synthetic brine trials yielded promising results, with a satisfactory extraction efficiency (76%), and the absence of physical problems (emulsion, long disengagement, etc.). This reveals the importance of the chemical composition of brines and emphasizes the need for varied procedural approaches in lithium-recovery processes.

Three high temperature processes of the electronic waste processing: smelting/incineration, pyrolysis and gasification were shortly discussed. The most distinctive feature of electronic waste is complexity of components and their integration. This type of waste consists of polymeric materials and has high content of valuable metals that could be recovered. The purpose of thermal treatment of electronic waste is elimination of plastic components (especially epoxy resins) while leaving non-volatile mineral and metallic phases in more or less original forms. Additionally, the gaseous product of the process after cleaning may be used for energy recovery or as syngas.

Four procedures based on closed-vessel microwave-assisted wet digestion with different oxidative reagents, including HNO₃ (P1), HNO₃ + H₂O₂ (P2), aqua regia (P3) and Lefort aqua regia (P4), for preparation of calcium (Ca)-rich materials prior to determination of total concentrations of Al, Ca, Cd, Fe, Mg and P by inductively coupled optical emission spectrometry (ICP OES) were compared. It was found that digestion with Lefort aqua regia (P4) provided the best results for all examined elements, i.e., precision of 0.30–4.4%, trueness better than 2%, recoveries of added elements between 99.5–101.9%, and limits of detection within 0.08–1.8 ng g⁻¹. Reliability of this procedure was verified by analysis of relevant certified reference materials (CRMs), i.e., Natural Moroccan Phosphate Rock—Phosphorite (BCR-O32). Additionally, selection of appropriate analytical lines for measurements of element concentrations, linear dynamic ranges of calibration curves and matrix effects on the analyte response were extensively investigated. Finally, the selected procedure was successfully applied for routine analysis of other Ca-rich materials, i.e., CRMs such as NIST 1400 (Bone Ash), CTA-AC-1 (Apatite Concentrate Kola Peninsula) and NCS DC70308 (Carbonate Rock), and six natural samples, such as a dolomite, a phosphate rock, an enriched superphosphate fertilizer, pork bones, pork bones after incineration, and after steam gasification.