The only effective way to design, produce, analyse and optimise new and existing industrial thermal processes and also laser-based processes is to develop a quantitative knowledge and understanding of the dependence between temperature and time, which allow the desired forming of properties of the final products. The purpose of this paper was the performance of thermo-derivative analysis using the UMSA platform of aluminium alloy cooled at chosen rate, for obtaining characteristics used later for laser treatment and its influence on the microstructure and properties of the surface layer of heat-treated Al–Si–Cu cast aluminium alloys, using the high-power diode laser. The performed laser treatment involves remelting and feeding of ceramic powder into the aluminium surface. The carried out investigations allow to conclude that as a result of alloying of the heat-treated cast aluminium alloys with oxide ceramic powder, a surface layer was obtained with higher hardness compared to non-laser-treated material. The surface layer can be enriched with the powder particle, and in some cases a high-quality top layer is possible to obtain. Also a microstructure refinement of the surface layer was achieved due to the high laser power use and consequently high cooling rate during the crystallisation process. Concerning original practical implications of this work, there was important to investigate the appliance possibility of thermal analysis for further surface treatment for enhancement of the aluminium surface properties, especially the wear resistance and hardness. The scientific reason was also to describe microstructure changes and processes occurred in the laser remelted surface aluminium layer after laser treatment.
23 March 2022 in Advances in Science and Technology Research Journal
The subject of the research in this work was the S49 rail made of R260 rail steel (1.0623). The carried out investigations concern microstructure tests and tests of mechanical properties of rails after several years of exposure in the open air without usage. The purpose of the work was to...
1 May 2005 in Journal of Materials Processing Technology
The optimization of CuNi2Si1 alloy’s mechanical and electrical properties was achieved through a combination of experimental approaches and metaheuristic algorithms. Optimizing hardness and electrical conductivity through a variation in aging temperature (450–600 °C) and aging duration (1–420 min) was taken under consideration in the present work. Cold rolling with 50% strain after solution annealing aided in microstructure refinement and accelerated Ni2Si precipitates’ development, and property improvement increased. Optimum temperature and holding period were 450 °C and 30 min, respectively, with 266 HV and 13 MS/m and 167 HV and 11.2 MS/m for non-deformed samples, respectively. SPBO, genetic algorithm (GA), and particle swarm optimization (PSO) metaheuristic algorithms were considered, and SPBO exhibited the best prediction accuracy. SPBO predicted 450 °C for 61.75 min, and experimental testing exhibited 267 HV and 14 MS/m, respectively. Polynomial regressions with 0.98 and 0.96 values for R2 confirmed these values’ accuracy. According to this work, computational optimization proves effective in optimizing development and property tailoring for application in industries including aerospace and electrical engineering.