Works of art are sensitive to environmental factors—mainly temperature and relative humidity—which, when stable, are generally recommended as ideal protection conditions, but in historical museum buildings, the required conditions are difficult to maintain, due to a lack of adequate heating, ventilation and air-conditioning systems. The paper presents the analysis of one-year measurements of temperature and relative humidity in three different museums in Poland. The aim of the research was to identify the risk to museum collections, due to unbalanced moisture loads and unstable indoor air temperatures, as well as to identify possible causes of fluctuations in these parameters. This article focuses on assessing the impact of variable external and internal loads on the hygrothermal parameters of indoor air. The profile of internal hygrothermal loads in exhibition halls varied over time, which resulted in a temporary variation of the indoor environmental parameters. The lack of appropriate systems, shaping the microclimate in the analyzed museums, and the lack of automatic control in existing devices did not allow to maintain the temperature and relative humidity within appropriate limits. In the museums, the maximum indoor temperature values were higher than those recommended in the requirements. Relative humidity values in all museums exceeded the recommended range both above and below.

The paper presents the requirements and functions of ventilation in ice rink arenas and discusses difficulties and problems of ventilation in such objects. Particular attention has been paid to two types of inside used air distribution systems – traditional-integrated and modern-separated where the functions of tribune ventilation and dehumidification of the air over the ice surface were separated. The flow of humid air and heat in the designed hall was modelled numerically using the ANSYS CFX code based on computational fluid dynamics (CFD) technique. Air distribution systems in the ice rink arena were compared based on the results of numerical calculations.

In addition to looking for effective drugs and a vaccine, which are necessary to save and protect human health, it is also important to limit, or at least to slow, the spread of coronavirus. One important element in this action is the use of individual protective devices such as filtering facepiece masks. Currently, masks that use a mechanical filter, such as a HEPA (High Efficiency Particulate Air) filter, are often used. In some countries that do not have a well-developed healthcare system or in exceptional situations, there is a real and pressing need to restore filters for reuse. This article presents technical details for a very simple device for sterilization, including of HEPA polymer filters. The results of biological and microscopic tests confirming the effectiveness of the sterilization performed in the device are presented. The compact and portable design of the device also allows its use to disinfect other small surfaces, for example a small fragment of a floor, table, or bed.