The aim of the study was to analyze the effect of the type of gelling substance on the selected physicochemical properties of oleogels. Rapeseed oil (RO) and 5% w/w of one of the following structuring compounds (SC) were used for their production waxes: sunflower (SUN), candelilla (CAN), bees white (BW), bees yellow (BY), or monoacylglycerols (MAG). The ability of SC to form a network in RO was assessed on the basis of an analysis of the texture of oleogels (hardness and spreadability test, stability determined by the centrifugal method). Oxidative stability was determined using the Rancimat test. In addition, the microstructure of an oleogel samples was observed at a magnification of 600 times in polarized light and in a bright field. Differences in the brightness and color of the samples were also assessed using the CIELab reflection method. The highest hardness (5.52 N) and physical stability (99.67%) were found in oleogel with candelilla wax. A higher value of the force causing deformation of the sample indicates a denser network of oil gel, which was confirmed by the microscopic images analyzed in the work. The organogel with CAN had the shortest (on average 8.49 nm) and the most regularly distributed crystals compared to other samples. The lowest values of organogel strength and spreadability test parameters (e.g., firmness, work of shear, stickness, work of adhesion), which were respectively 0.73 N, 4.39 N, and 9.74 N mm, while −4.87 N and −2.68 N mm were obtained with the variant, which was yellow beeswax. Considering the texture results obtained and the centrifugal stability, it was found that organogels with yellow beeswax were characterized by the worst structuring of rapeseed oil. Sunflower wax was considered the best among the analyzed gelling agents (under the conditions of the experiment). The organogel with its 5% w/w share was distinguished by the closest to the white color and texture most reminiscent of cream. In addition, it had the highest work of shear value and the longest induction time (6.8 h) in the Rancimat test.

Background: Shortenings are high in undesirable nutritionally saturated fatty acids. The aim of the study was to produce gluten-free muffins (GFM) of increased health quality and available to people intolerant to gluten, in which the shortenings were replaced with solid oleogels, consisting of 95% rapeseed oil. Methods: The dough and baked products were subjected to physical, textural, and structural analyses. Moreover, the fatty acids composition, chemical quality of fats extracted from muffins, and color of the products were determined. The dough was also observed at 600× magnification in bright field and polarized light microscopy, and microtomographic analysis of the structure of GTM was performed. Results: There was no effect of the type of lipids on physical properties, including water content in gluten-free muffins. However, the baked products differed in total porosity and brightness, as well as intensity of red and yellow colors. The use of rapeseed oil oleogels, instead of shortening in the muffin recipe, resulted in a decrease in the dietary undesirable SFA in lipid fractions (by approximately 40%), an increase in the content of MUFA (by approximately 30%), and an increase in the content of PUFA (by approximately 15%), with acceptable chemical quality. Conclusions: Research confirms the possibility of obtaining products with increased nutritional value available to consumers on a gluten-free diet.

Microorganisms can be a promising source of bioactive food ingredients derived from unconventional agricultural farms. The quality of batter and final products in which 20%–80% of the fat has been replaced by β-glucan, obtained from microorganisms, was analyzed. The instrumental texture measurements showed that β-glucan batter and muffins were harder than the control sample. Fat substitution over 40%, while enriching muffins with yeast β-glucan (over 2%), led to a decrease in the quality of products after baking and during 14-day storage. The incorporation of 3% or more β-glucan into the composition increased the hardness of the batter and deteriorated the quality of the muffin crumb, after baking and during storage. The sensory study revealed that fat replacement up to 40% with β-glucan provided acceptable biscuits, but higher replacement decreased the overall acceptability.

The goal of this study was to determine the effect of rice and hemp protein addition together with transglutaminase on the quality and fat content of fried instant noodles. The following parameters have been analyzed during this research: the amount of water, fat content, hydration time, color and texture parameters. The evaluation of sensory parameters before and after cooking of instant noodles has been performed. It can be concluded that the addition of TGase significantly decreased the fat content; the recipe with a 3% hemp protein addition with TGase in an amount of 2% was the most promising solution to obtain a low-fat product. On the other hand, the better consumer acceptance levels were observed for the rice protein addition (1%) with 2% TGase. It seems that the most promising product is the sample with a 5% addition of rice protein with 2% TGase-a reduction in the fat content by 30% (from 25% to 16%). The addition of rice protein, hemp protein and TGase reduced the fat content of the instant noodles in comparison to the control sample. The additives used had an impact on the L*, a* and b* color parameters. All instant noodles obtained during the research process were characterized by a short hydration time, which did not exceed 5 min. During the sensory evaluation, analyzed samples of the instant noodles obtained scores higher than 4.2 points on a five-point scale.