The Effect of Concentration and Type of Plasticizer on the Mechanical Properties of Cellulose Acetate Butyrate Organic-Inorganic Hybrids | InTechOpen, Published on: 2012-03-21. Authors: Patrycja Wojciechowska

Novel gelatin-siloxane hybrid monoliths for heavy metal removal were prepared in the chemical reaction of gelatin with organomodified silicone containing epoxy group. Obtained porous hybrid materials were applied for adsorption of Cu(II), Cd(II) and Pb(II) from aqueous solutions. In this paper, the influence of siloxane amount used for the modification of gelatin on adsorbent stability and heavy metal removal was examined. The effect of pH values of the immersion liquid, as well as the contact time, was studied. Morphology, compressive strength and water absorption of hybrid monoliths were investigated. Desorption tests were also performed. The results showed that the higher the amount of the siloxane, the better stability of the hybrid monoliths in aqueous solutions. The highest values of adsorption capacity were observed for Pb(II) ions. The experimental maximum adsorption capacity determined for hybrid monoliths was 3.75 mg/g for Pb(II), 1.76 mg/g for Cu(II) and 1.5 mg/g for Cd(II). The desorption of metal ions for hybrid monoliths stable in aqueous solutions reached 70%.

Degradability of organic-inorganic cellulose acetate butyrate hybrids in sea water: Environmental degradability of novel organic-inorganic cellulose acetate butyrate hybrids obtained via solgel process was investigated. The degradation of hybrids was studied under marine exposure conditions in the Baltic Sea for a period of 25 weeks. The influence of characteristic parameters of sea water on the degree of degradation monitored by changes of weight and optical microscopy was discussed. The degraded samples were also examined by FT-IR spectroscopy. It has been established that the CAB/silica hybrids are more susceptible to biodegradation in sea water environment than pure cellulose acetate butyrate.

Radiation is an example of one of the techniques used for pasteurization and sterilization in various packaging systems. There is a high demand for the evaluation of the possible degradation of new composites, especially based on natural raw materials. The results of experimental research that evaluated the impact of radiation technology on biodegradable and compostable packaging materials up to 40 kGy have been presented. Two commercially available flexible composite films based on aliphatic–aromatic copolyesters (AA) were selected for the study, including one film with chitosan and starch (AA-CH-S) and the other with thermoplastic starch (AA-S). The materials were subjected to the influence of ionizing radiation from 10 to 40 kGy and then tests were carried out to check their usability as packaging material for the food industry. The results showed that the mechanical properties of AA-S films improved due to the radiation-induced cross-linking processes, while in the case of AA-CH-S films, a considerable decrease in the elongation at break was observed. The results also showed a decrease in the WVTR in the case of AA-S and no changes in barrier properties in the case of AA-CH-S. Both materials revealed no changes in the odor analyzed by sensory analysis. In the case of the AA-S films, the higher the radiation dose, the faster the biodegradation rate. In the case of the AA-CH-S film, the radiation did not affect biodegradation. The performed research enables the evaluation of the materials intended for direct contact with food. AA-CH-S was associated with unsatisfactory parameters (exceeding the overall migration limit and revealing color change during storage) while AA-S showed compliance at the level of tests carried out. The study showed that the AA-CH-S composite did not show a synergistic effect due to the presence of chitosan.