Currently there are many applications for the use of composites reinforced with fiberglass mat and fabrics with polyester resin: automotive, aerospace, construction of wind turbines blades, sanitary ware, furniture, etc. The structures made of composites have a complex geometry, can be simultaneously subjected to tensile–compression, shear, bending and torsion. In this paper we analyzed the mechanical properties of a polyester composite material reinforced with glass fiber (denoted GFRP) of which were carried out two types of samples: The former contains four layers of plain fabric (GFRP-RT500) and the second type contains three layers of chopped strand mat (GFRP-MAT450). The samples were subjected to tensile, compression and tensile–tensile cyclic loading. The results highlight the differences between the two types of GFRP in terms of initial elastic modulus, post yield stiffness and viscoelastic behavior under cyclic loading. Thus, it was observed that the value of the modulus of elasticity and the value of ultimate tensile stress are approximately twice higher in the case of GFRP-RT500 than for the composite reinforced with short fibers type GFRP-MAT450. The tensile–tensile cyclic test highlights that the short glass fiber-reinforced composite broke after the first stress cycle, compared to the fabric-reinforced composite in which rupture occurred after 15 stress cycles. The elasticity modulus of GFRP-RT500 decreased by 13% for the applied loading with the speed of 1 mm/min and by 15% for a loading speed of 20 mm/min.

The purpose of the study was to analyze the influence of the quality class and the orthotropy of wood upon the sound absorption coefficient, the reflection and the impedance ratio of two species widely used for stringed musical instruments, namely spruce (Picea abies L. Karst) and maple (Acer pseudoplatanus L.). An impedance tube for the frequency range 100–6400 Hz was used in these experimental determinations. Knowing the influence of porosity and tortuosity on the acoustic absorption, these properties were also determined, as well as the sound reduction coefficient and the maximum values of the acoustic absorption coefficients in relation to frequency. The main results highlighted the differences between the anatomical quality class of the wood within each species, but also concerning the sound direction relative to the three main sections of wood, as an orthotropic material. The article highlights the acoustic performance parameters related to the frequency of the wooden material and its relationship to density, porosity and quality class. The results represent useful information for musical instruments manufacturers and more.

The vibrations developed during the work represent one of the main mechanical problems of the electric motors. Their frequencies and levels can cause large damages of different electrical motors parts. This is the reason why even in the design phase it is useful to be known the values of the natural frequencies of the parts. This can be made in two different ways: using modern capabilities of finite element method (FEM) or doing experimental modal analysis. The study developed in the present paper refers to the modal analysis of a three-phase squirrel cage induction of 1.5 kW, for both, for its elements and, for motor and the electric motor as an assembly. The FEM modal analysis was applied using ABAQUS software for assembly of the 7 elements of the motor. The 3D model was developed, mechanical connections being of screw type. The theoretical model was validated by experiments, with impact hammer test method. The validation confirms the assumptions made for the 3D model and the designed model can be use, as example, for other FEM based modal analysis. The natural frequencies obtained both by FEM and experimental method does not overlap on the working frequencies.