Philippe Christol

Prof. Dr. Philippe Christol

orcid

Research Focus & Metrics

Academic Career Length

33Years (1994-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2014 in Electronics Letters
Verified
Journal Article
Open access
PDF file
AEA. Evirgen
A. Evirgen
JAJ. Abautret
J. Abautret
JPJ.P. Perez
J.P. Perez
ACA. Cordat
A. Cordat
ANA. Nedelcu
A. Nedelcu
PCPhilippe Christol
Philippe Christol
The first demonstration of InSb photodetector with n B n design is reported. The n B n structure, grown by molecular beam epitaxy (MBE) on InSb substrate, is built by using n ‐type InSb as absorber layer and InAlSb alloy as barrier layer. The n B n detector, showing cut‐off wavelength of 5.4 µm at 77 K in photovoltaic mode, exhibits dark current density as low as 10 −9 A/cm 2 at −50 mV reverse bias, at least two decades lower than usual InSb photodiode.

3 April 2012 in Journal of Electronic Materials
Verified
Journal Article
Closed access
PDF file
CCC. Cervera
C. Cervera
IRI. Ribet-Mohamed
I. Ribet-Mohamed
RTR. Taalat
R. Taalat
JPJ.P. Perez
J.P. Perez
PCPhilippe Christol
Philippe Christol
JRJ.B. Rodriguez
J.B. Rodriguez

15 July 2009 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
CCC. Cervera
C. Cervera
JRJ. B. Rodriguez
J. B. Rodriguez
RCR. Chaghi
R. Chaghi
HAH. Aït-Kaci
H. Aït-Kaci
PCPhilippe Christol
Philippe Christol
We report on structural, electrical, and optical characterizations of midwave infrared InAs/GaSb superlattice (SL) p-i-n photodiodes. High-quality SL samples, with 1 μm thick active region (220 SL periods), exhibited a cut-off wavelength of 4.9 μm at 80 K. Using a capacitance-voltage measurement technique performed on mesa diode, the residual background concentration in the nonintentionally doped region was determined to be 3×1015 cm−3 at 80 K. Extracted from current-voltage characteristics, R0A products above 4×105 Ω cm2 at 80 K were measured, and the quantitative analysis of the J-V curves showed that the dark current density of SL photodiode is dominated by generation-recombination processes. Front-side illuminated photodiodes produced responsivity at 80 K equal to 360 mA/W at 4.5 μm .

15 October 1994 in Physical Review B
Verified
Journal Article
Closed access
PDF file
ABAbdsadek Bellabchara
Abdsadek Bellabchara
PLPierre Lefebvre
Pierre Lefebvre
PCPhilippe Christol
Philippe Christol
HMHenry Mathieu
Henry Mathieu
Binding energies and oscillator strengths of excitons in staggered-lineup heterostructures such as type-II quantum wells are calculated by a variational method, using a single parameter. This method involves the effective attractive potential imposed by the confined carrier to its unconfined companion. Contrary to previous comparable works, a three-dimensional trial function of the variable r (r=‖re-rh‖) is used, instead of a two-dimensional function of the in-plane projection ρ. Due to the large spatial extension along z of the wave function of the unconfined carrier, the latter approximation commonly used up to date, is too drastic, even though it works reasonably well for type-I systems. This is demonstrated by comparison of both hypotheses for GaAs-AlAs systems: when using the 3D function, binding energies are increased by up to 52%, while electron-hole overlap integrals can be enhanced by one order of magnitude.

18 September 2020 in Photonics
Verified
Journal Article
Open access
PDF file
UZUlises ZAVALA-MORAN
Ulises ZAVALA-MORAN
MBM. Bouschet
M. Bouschet
JPJean-Philippe Perez
Jean-Philippe Perez
RARodolphe Alchaar
Rodolphe Alchaar
SBS. Bernhardt
S. Bernhardt
PCPhilippe Christol
Philippe Christol
In this paper, a full set of structural, optical and electrical characterizations performed on midwave infrared barrier detectors based on a Ga-free InAs/InAsSb type-II superlattice, grown by molecular beam epitaxy (MBE) on a GaSb substrate, are reported and analyzed. a Minority carrier lifetime value equal to 1 µs at 80 K, carried out on dedicated structure showing photoluminescence peak position at 4.9 µm, is extracted from a time resolved photoluminescence measurement. Dark current density as low as 3.2 × 10−5 A/cm2 at 150 K is reported on the corresponding device exhibiting a 50% cut-off wavelength around 5 µm. A performance analysis through normalized spectral response and dark current density-voltage characteristics was performed to determine both the operating bias and the different dark current regimes.

30 May 2021 in Photonics
Verified
Journal Article
Open access
PDF file
MBMaxime Bouschet
Maxime Bouschet
UZUlises ZAVALA-MORAN
Ulises ZAVALA-MORAN
VAVignesh Arounassalame
Vignesh Arounassalame
RARodolphe Alchaar
Rodolphe Alchaar
CBClara Bataillon
Clara Bataillon
PCPhilippe Christol
Philippe Christol
In this paper, the influence of etching depth on the dark current and photo-response of a mid-wave infrared Ga-free T2SL XBn pixel detector is investigated. Two wet chemical etching depths have been considered for the fabrication of a non-passivated individual pixel detector having a cut-off wavelength of 5 µm at 150 K. This study shows the strong influence of the lateral diffusion length of a shallow-etched pixel on the electro-optical properties of the device. The lowest dark current density was recorded for the deep-etched detector, on the order of 1 × 10−5 A/cm2 at 150 K and a bias operation equal to −400 mV. The corresponding quantum efficiency was measured at 60% (without anti-reflection coating) for a 3 µm thick absorbing layer. A comparison of experimental results obtained on the two kinds of etched pixels demonstrates the need for a deep-etching process combined with efficient passivation for FPA manufacturing.