Ulises ZAVALA-MORAN

Mr. Ulises ZAVALA-MORAN

Universidad Autónoma de San Luis Potosí - IICO
+1

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 September 2020 in Photonics
Verified
Journal Article
Open access
PDF file
UZUlises ZAVALA-MORAN
Ulises ZAVALA-MORAN
MBM. Bouschet
M. Bouschet
JPJean-Philippe Perez
Jean-Philippe Perez
RARodolphe Alchaar
Rodolphe Alchaar
SBS. Bernhardt
S. Bernhardt
PCPhilippe Christol
Philippe Christol
In this paper, a full set of structural, optical and electrical characterizations performed on midwave infrared barrier detectors based on a Ga-free InAs/InAsSb type-II superlattice, grown by molecular beam epitaxy (MBE) on a GaSb substrate, are reported and analyzed. a Minority carrier lifetime value equal to 1 µs at 80 K, carried out on dedicated structure showing photoluminescence peak position at 4.9 µm, is extracted from a time resolved photoluminescence measurement. Dark current density as low as 3.2 × 10−5 A/cm2 at 150 K is reported on the corresponding device exhibiting a 50% cut-off wavelength around 5 µm. A performance analysis through normalized spectral response and dark current density-voltage characteristics was performed to determine both the operating bias and the different dark current regimes.

30 May 2021 in Photonics
Verified
Journal Article
Open access
PDF file
MBMaxime Bouschet
Maxime Bouschet
UZUlises ZAVALA-MORAN
Ulises ZAVALA-MORAN
VAVignesh Arounassalame
Vignesh Arounassalame
RARodolphe Alchaar
Rodolphe Alchaar
CBClara Bataillon
Clara Bataillon
PCPhilippe Christol
Philippe Christol
In this paper, the influence of etching depth on the dark current and photo-response of a mid-wave infrared Ga-free T2SL XBn pixel detector is investigated. Two wet chemical etching depths have been considered for the fabrication of a non-passivated individual pixel detector having a cut-off wavelength of 5 µm at 150 K. This study shows the strong influence of the lateral diffusion length of a shallow-etched pixel on the electro-optical properties of the device. The lowest dark current density was recorded for the deep-etched detector, on the order of 1 × 10−5 A/cm2 at 150 K and a bias operation equal to −400 mV. The corresponding quantum efficiency was measured at 60% (without anti-reflection coating) for a 3 µm thick absorbing layer. A comparison of experimental results obtained on the two kinds of etched pixels demonstrates the need for a deep-etching process combined with efficient passivation for FPA manufacturing.