In this paper, a full set of structural, optical and electrical characterizations performed on midwave infrared barrier detectors based on a Ga-free InAs/InAsSb type-II superlattice, grown by molecular beam epitaxy (MBE) on a GaSb substrate, are reported and analyzed. a Minority carrier lifetime value equal to 1 µs at 80 K, carried out on dedicated structure showing photoluminescence peak position at 4.9 µm, is extracted from a time resolved photoluminescence measurement. Dark current density as low as 3.2 × 10−5 A/cm2 at 150 K is reported on the corresponding device exhibiting a 50% cut-off wavelength around 5 µm. A performance analysis through normalized spectral response and dark current density-voltage characteristics was performed to determine both the operating bias and the different dark current regimes.
In this paper, the influence of etching depth on the dark current and photo-response of a mid-wave infrared Ga-free T2SL XBn pixel detector is investigated. Two wet chemical etching depths have been considered for the fabrication of a non-passivated individual pixel detector having a cut-off wavelength of 5 µm at 150 K. This study shows the strong influence of the lateral diffusion length of a shallow-etched pixel on the electro-optical properties of the device. The lowest dark current density was recorded for the deep-etched detector, on the order of 1 × 10−5 A/cm2 at 150 K and a bias operation equal to −400 mV. The corresponding quantum efficiency was measured at 60% (without anti-reflection coating) for a 3 µm thick absorbing layer. A comparison of experimental results obtained on the two kinds of etched pixels demonstrates the need for a deep-etching process combined with efficient passivation for FPA manufacturing.
In this paper, we report on temperature dependence performances of a midwave infrared (MWIR) Ga-free InAs/InAsSb type-II superlattice (T2SL) barrier (XBn) photodetector grown by molecular beam epitaxy on n-type GaSb substrate. The T2SL structure, with a 3 µm thick active region, was processed in a mesa device in order to perform dark current measurements and spectral photoresponse as a function of temperature. Analyses of these temperature dependence characterizations help us to improve the design of Ga-free T2SL MWIR XBn detectors.
17 November 2022 in IEEE Transactions on Nuclear Science
In this work, we present the influence of the irradiation temperature on electrical characterization of MidWave infrared (MWIR) InAs/GaSb type-II superlattice (T2SL) photodetector, showing cut-off wavelength equal to 5μm at 90K. The proton irradiations were performed with 60 MeV protons and fluences up to 8x10 11 H + /cm² at cryogenic (100K) or room temperature (300K). The gamma irradiation, from a Cobalt-60 source, allows to reach a dose up to 50 krad(Si). We observed that degradation of the dark current under proton or gamma irradiations is strongly dependent on the temperature of the detector during irradiation but also on the protection layer used during the detector’s technological process.