A two-stage fully differential CMOS amplifier comprising inverters as input structures and employing self-biasing techniques is presented. The proposed amplifier benefits from an optimum compensation through time-domain optimization which permits achieving high energy efficiency. Moreover, it achieves the highest efficiency of its class and although it relies on a quasi-class-A topology, it is comparable to class-AB amplifiers. Detailed circuit analyses such as differential-mode, common-mode feedback, noise, slew rate, and input/output range are carried out. Based on these analyses, a manual design methodology and a genetic algorithm based optimization are presented. Finally, the most relevant experimental results for an integrated circuit prototype designed in a 0.13 μm 1.2 V standard CMOS technology are shown.

This paper describes the design and experimental evaluation of a multibit Sigma-Delta (ΣΔ) modulator (ΣΔM) with enhanced dynamic range (DR) through the use of nonlinear digital-to-analog converters (DACs) in the feedback paths. This nonlinearity imposes a trade-off between DR and distortion, which is well suited to the intended hearing aid application. The modulator proposed here uses a fully-differential self-biased amplifier and a 4-bit quantizer based on fully dynamic comparators employing MOS parametric pre-amplification to improve both energy and area efficiencies. A test chip was fabricated in a 130 nm digital CMOS technology, which includes the proposed modulator with nonlinear DACs and a modulator with conventional linear DACs, for comparison purposes. The measured results show that the ΣΔM using nonlinear DACs achieves an enhancement of the DR around 8.4 dB (to 91.4 dB). Power dissipation and silicon area are about the same for the two cases. The performance achieved is comparable to that of the best reported multibit ΣΔ ADCs, with the advantage of occupying less silicon area (7.5 times lower area when compared with the most energy efficient ΣΔM).

This paper presents an improved low-voltage low-power CMOS comparator suitable for high-speed pipeline ADCs. Simulated results of the proposed circuit in a 0.35 /spl mu/m standard CMOS technology operating at supply voltages within the range of 1.0-1.5 V show that this comparator achieves low offset, reduced kickback noise, high mean-time to failure and exhibits low-power dissipation at very high-speed operation.