This paper presents a novel high-gain transimpedance amplifier for flexible radiation sensing systems that can be used as large-area dosimeters. The circuit is implemented with Indium-Gallium-Zinc-Oxide (IGZO) thin-film-transistors (TFTs) and uses two stages for the amplification of the sensor signal (current). The first stage consists of cascode current mirrors with a diode connected load that performs current amplification and voltage conversion. Then, the first stage is followed by a voltage amplifier based on a positive feedback topology for gain enhancement. The proposed circuit converts nano-ampere (10nA) currents into hundreds of millivolts (280mV), showing a gain around 149dB and a power consumption of 0.45mW. The sensed radiation dose level, in voltage terms, can drive the next stages in the radiation sensing system, such as Analog to Digital Converters (ADCs). These radiation sensing devices can find potential applications in real-time, large area, flexible health and security systems.

This paper presents analog building blocks that find potential applications in display panels. A buffer (source-follower), subtractor, adder, and high-gain amplifier, employing only n-type enhancement amorphous gallium-indium-zinc-oxide thin-film transistors (a-GIZO TFTs), were designed, simulated, fabricated, and characterized. Circuit simulations were carried out using a neural model developed in-house from the measured characteristics of the transistors. The adder-subtractor circuit presents a power consumption of 0.26 mW, and the amplifier presents a gain of 34 dB and a power consumption of 0.576 mW, with a load of 10 M Ω//16 pF. To the authors' knowledge, this is the highest gain reported so far for a single-stage amplifier with a-GIZO TFT technology.

This paper focuses on the analysis of InGaZnO thin-film transistors (TFTs) and circuits under the influence of different temperatures and bias stress, shedding light into their robustness when used in real-world applications. For temperature-dependent measurements, a temperature range of 15 to 85 °C was considered. In case of bias stress, both gate and drain bias were applied for 60 min. Though isolated transistors show a variation of drain current as high as 56% and 172% during bias voltage and temperature stress, the employed circuits were able to counteract it. Inverters and two-TFT current mirrors following simple circuit topologies showed a gain variation below 8%, while the improved robustness of a cascode current mirror design is proven by showing a gain variation less than 5%. The demonstration that the proper selection of TFT materials and circuit topologies results in robust operation of oxide electronics under different stress conditions and over a reasonable range of temperatures proves that the technology is suitable for applications such as smart food packaging and wearables.

This paper reports on-chip rail-to-rail timing signals generation thin-film circuits for the first time. These circuits, based on a-IGZO thin-film transistors (TFTs) with a simple staggered bottom gate structure, allow row and column selection of a sensor matrix embedded in a flexible radiation sensing system. They include on-chip clock generator (ring oscillator), column selector (shift register) and row-selector (a frequency divider and a shift register). They are realised with rail-to-rail logic gates with level-shifting ability that can perform inversion and NAND logic operations. These logic gates are capable of providing full output swing between supply rails, VDD and VSS, by introducing a single additional switch for each input in bootstrapping logic gates. The circuits were characterised under normal ambient atmosphere and show an improved performance compared to the conventional logic gates with diode connected load and pseudo CMOS counterparts. By using these high-performance logic gates, a complete rail-to-rail frequency divider is presented from measurements using D-Flip Flop. In order to realize a complete compact system, an on-chip ring oscillator (output clock frequency around 1kHz) and a shift register are also presented from simulations, where these circuits show a power consumption of 1.5mW and 0.82mW at a supply voltage of 8V, respectively. While the circuit concepts described here were designed for an X-ray sensing system, they can be readily expanded to other domains where flexible on-chip timing signal generation is required, such as, smart packaging, biomedical wearable devices and RFIDs.

This paper characterizes transparent current mirrors with n-type amorphous gallium-indium-zinc-oxide (a-GIZO) thin-film transistors (TFTs). Two-TFT current mirrors with different mirroring ratios and a cascode topology are considered. A neural model is developed based on the measured data of the TFTs and is implemented in Verilog-A; then it is used to simulate the circuits with Cadence Virtuoso Spectre simulator. The simulation outcomes are validated with the fabricated circuit response. These results show that the neural network can model TFT accurately, as well as the current mirroring ability of the TFTs.