Min-Su Kim

Prof. Min-Su Kim

Mokpo National University, Muan, Jeonnam, Republic of Korea
orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 June 2023 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
BKByunghun Ko
Byunghun Ko
SLSunwoo Lee
Sunwoo Lee
WSWonwoo Seo
Wonwoo Seo
TSTaejoo Sim
Taejoo Sim
SKSunghyuk Kim
Sunghyuk Kim
JKJunghyun Kim
Junghyun Kim
This paper presents a switchless dual-band low-noise amplifier (LNA) that can be reconfigured to include n260 (37.40 GHz) and n262 (47.2.48.2 GHz) millimeter-wave (mm-Wave) dual bands. The proposed reconfigurable LNA is designed to separate and isolate two bands, using a common gate and coupled-line-based diplexer for the inter-stage of cascade amplifiers. A common gate amplifier has the advantage of simultaneously selecting the signal path and amplifying the signal power according to a band, using an impedance variation between the gon/offh conditions of gate bias. In addition, the coupled-line-based diplexer can be optimized to exhibit high isolation characteristics between frequencies using high and low-pass characteristics. The designed reconfigurable LNA is fabricated with the 0.15–μm GaAs pHEMT process. With the high frequency (HF) mode, the reconfigurable LNA achieves a measured gain of 19.2 dB at the center frequency, noise figure, and OP1dB of 48 GHz, 4.8 dB, and 6.88 dBm, respectively. In the low frequency (LF) mode, the reconfigurable LNA exhibits a measured gain of 24.8 dB at the center frequency, noise figure, and OP1dB of 39 GHz, 3.9 dB, and 6.80 dBm, respectively. The chip occupies a core area of 3.04 mm2, which consumes 61.4 mW and 64.7 mW in the HF and LF modes, respectively.

10 October 2023 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
SLSunwoo Lee
Sunwoo Lee
WSWonwoo Seo
Wonwoo Seo
SKSunghyuk Kim
Sunghyuk Kim
BKByunghun Ko
Byunghun Ko
SLSongjune Lee
Songjune Lee
JKJunghyun Kim
Junghyun Kim
This brief presents the design and fabrication of a concurrent 26/48 GHz low-noise amplifier (LNA) that includes a dual-band matching network for moderate gain and optimized noise performance. The proposed dual-band matching network achieve simultaneous dual-band impedance matching for noise figure (NF) optimization by utilizing series and parallel resonance methods. A cascode structure with inductive source degeneration is employed to simultaneously achieve both gain and noise performance optimization. The fabricated LNA has a small-signal gain of 12.5 dB at 26 GHz and 14.5 dB at 48 GHz, and the NF was measured at 2.61 dB at 26 GHz and 3.41 dB at 48 GHz, respectively. Moreover, the output 1 dB compression point (OP1dB) is 2.3 dBm at 26 GHz and -2.7 dBm at 48 GHz. The LNA was fabricated with an area of 1.34×0.7mm2 using a GaAs 0.15 μm pHEMT process.

17 May 2021 in IEEE Access
Verified
Journal Article
Open access
MKMin-Su Kim
Min-Su Kim
HJHeesauk Jhon
Heesauk Jhon
In this paper, we propose a double diode network including an additional stacked diode, which provides robustness against Electrostatic discharge (ESD) and high-frequency interference signals. The proposed stacked diode in the conventional double diode network protects the integrated circuit from instantaneous voltage events by providing an additional current path to the double diode network. Also, it can structurally minimize the parasitic capacitance generated in the diode. The general operating principle and limitation of the conventional double diode network for ESD events and high-frequency interference signals were analyzed and simulated. For experimental verification, a cascode LNA with inductive source degeneration was designed in a 130nm CMOS Silicon-on-insulator (SOI) process for the time-division long-term evolution (TD-LTE) application at the coexistence band. The LNA with the proposed double diode network provides a noise figure of 1.08 dB and a small-signal gain of 18.7 dB at 2.65 GHz (Band 41). And it was measured to be able to protect the internal circuit at 2000 V HBM event, and the RF performances were not affected even with a high-frequency interference signal close to 30 dBm.

14 October 2024 in Sensors
Verified
Journal Article
Open access
PDF file
MKMin-Su Kim
Min-Su Kim
This paper presents a single-input multiple-output (SIMO) cascode low-noise amplifier with inductive degeneration for inter- and intra-band carrier aggregation. The proposed low-noise amplifier has two output ports for flexible operation in carrier aggregation combinations for band 30 and band 7. However, during inter- and intra-band operation, gain variation occurs depending on the output mode. To compensate for this, a switching circuit is proposed to adjust the degeneration inductor, optimizing gain performance for both modes. The switching operation can minimize the control for the dynamic range in the receiver system to support carrier aggregation. The designed low-noise amplifier was fabricated using a 65 nm CMOS process, occupying an area of 2.1 mm2. In inter-band operation, the small-signal gain was measured by 18.9 dB for band 30 and 18.6 dB for band 7, with the noise figures of 1.03 dB and 1.07 dB, respectively. For intra-band operation, the small-signal gain was 17.3 dB and 17.2 dB, with the noise figures of 1.3 dB and 1.41 dB. The IIP3 values were measured by −7.6 dBm and −6.7 dBm for inter-band, and −6.3 dBm and −6.2 dBm for intra-band. Power consumption was 8.04 mW and 7.68 mW in inter-band, and 17.04 mW and 17.64 mW in intra-band depending on the output configuration.

22 June 2023 in Sensors
Verified
Journal Article
Open access
PDF file
MKMin-Su Kim
Min-Su Kim
SYSang-Sun Yoo
Sang-Sun Yoo
This paper presents a low-noise amplifier (LNA) with an integrated input and output matching network designed using RF-SOI technology. This LNA was designed with a resistive feedback topology and an inductive peaking technology to provide 600 MHz of bandwidth in the N79 band (4.4 GHz to 5.0 GHz). Generally, the resistive feedback structure used in broadband applications allows the input and output impedance to be made to satisfy the broadband conditions through low-impedance feedback. However, feedback impedance for excessive broadband characteristics can degrade the noise performance as a consequence. To achieve a better noise performance for a bandwidth of 600 MHz, the paper provided an optimized noise performance by selecting the feedback resistor value optimized for the N79 band. Additionally, an inductive peaking technique was applied to the designed low-noise amplifier to achieve a better optimized output matching network. The designed low-noise amplifier simulated a gain of 20.68 dB and 19.94 dB from 4.4 to 5.0 GHz, with noise figures of 1.57 dB and 1.73 dB, respectively. The input and output matching networks were also integrated, and the power consumption was designed to be 9.95 mA at a supply voltage of 1.2 V.

16 January 2024 in Sensors
Verified
Journal Article
Open access
PDF file
MKMin-Su Kim
Min-Su Kim
SYSang-Sun Yoo
Sang-Sun Yoo
This paper presents the design of a low-noise amplifier (LNA) with a bypass mode for the n77/79 bands in 5G New Radio (NR). The proposed LNA integrates internal matching networks for both input and output, combining two LNAs for the n77 and n79 bands into a single chip. Additionally, a bypass mode is integrated to accommodate the flexible operation of the receiving system in response to varying input signal levels. For each frequency band, we designed a low-noise amplifier for the n77 band to expand the bandwidth to 900 MHz (3.3 GHz to 4.2 GHz) using resistive–capacitance (RC) feedback and series inductive-peaking techniques. For the n79 band, only the RC feedback technique was employed to optimize the performance of the LNA for its 600 MHz bandwidth (4.4 GHz to 5.0 GHz). Because wideband techniques can lead to a trade-off between gain and noise, causing potential degradation in noise performance, appropriate bandwidth design becomes crucial. The designed n77 band low-noise amplifier achieved a simulated gain of 22.6 dB and a noise figure of 1.7 dB. Similarly, the n79 band exhibited a gain of 21.1 dB and a noise figure of 1.5 dB with a current consumption of 10 mA at a 1.2 supply voltage. The bypass mode was designed with S21 of −3.7 dB and −5.0 dB for n77 and n79, respectively.