Bartosz Matyjewicz

Mr. Bartosz Matyjewicz

orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 January 2022 in Materials
Verified
Journal Article
Open access
PDF file
Kacper ŚwiechowskiKacper Świechowski
Kacper Świechowski
BMBartosz Matyjewicz
Bartosz Matyjewicz
PTPaweł Telega
Paweł Telega
Andrzej BialowiecAndrzej Bialowiec
Andrzej Bialowiec
The proof-of-the-concept of application of low-temperature food waste biochars for the anaerobic digestion (AD) of food waste (the same substrate) was tested. The concept assumes that residual heat from biogas utilization may be reused for biochar production. Four low-temperature biochars produced under two pyrolytic temperatures 300 °C and 400 °C and under atmospheric and 15 bars pressure with 60 min retention time were used. Additionally, the biochar produced during hydrothermal carbonization (HTC) was tested. The work studied the effect of a low biochar dose (0.05 gBC × gTSsubstrate−1, or 0.65 gBC × L−1) on AD batch reactors’ performance. The biochemical methane potential test took 21 days, and the process kinetics using the first-order model were determined. The results showed that biochars obtained under 400 °C with atmospheric pressure and under HTC conditions improve methane yield by 3.6%. It has been revealed that thermochemical pressure influences the electrical conductivity of biochars. The biomethane was produced with a rate (k) of 0.24 d−1, and the most effective biochars increased the biodegradability of food waste (FW) to 81% compared to variants without biochars (75%).

14 September 2020 in Energies
Verified
Journal Article
Open access
PDF file
BMBartosz Matyjewicz
Bartosz Matyjewicz
Kacper ŚwiechowskiKacper Świechowski
Kacper Świechowski
Jacek A. KozielJacek A. Koziel
Jacek A. Koziel
Andrzej BialowiecAndrzej Bialowiec
Andrzej Bialowiec
This paper provides a comprehensive description of the new approach to biomass torrefaction under high-pressure conditions. A new type of laboratory-scale high-pressure reactor was designed and built. The aim of the study was to compare the high-pressure torrefaction with conventional near atmospheric pressure torrefaction. Specifically, we investigated the torrefaction process influence on the fuel properties of wooden-pellet for two different pressure regimes up to 15 bar. All torrefaction processes were conducted at 300 °C, at 30 min of residence time. The initial analysis of the increased pressure impact on the torrefaction parameters: mass yields, energy densification ratio, energy yield, process energy consumption, the proximate analysis, high heating value, and energy needed to grind torrefied pellets was completed. The results show that high-pressure torrefaction needed up to six percent less energy, whereas energy densification in the pellet was ~12% higher compared to conventional torrefaction. The presence of pressure during torrefaction did not have an impact on the energy required for pellet grinding (p < 0.05).

6 December 2021 in Preprints.org
Verified
Preprint
Open access
Kacper ŚwiechowskiKacper Świechowski
Kacper Świechowski
Andrzej BialowiecAndrzej Bialowiec
Andrzej Bialowiec
BMBartosz Matyjewicz
Bartosz Matyjewicz
PTPaweł Telega
Paweł Telega
The proof-of-the-concept of application of low-temperature food waste biochars for the anaerobic digestion (AD) of food waste (the same substrate) was tested. The concept assumes that residual heat from biogas utilization may be reused for biochar production. Four low-temperature biochars produced under two pyrolytic temperatures 300 °C and 400 °C and under atmospheric and 15 bars pressure with 60 minutes retention time were used. Additionally, the biochar produced during hydrothermal carbonization (HTC) was tested. The work studied the effect of a low biochar dose (0.05 gBC x gTSsubstrate-1, or 0.65 gBC x L-1) on AD batch reactors’ performance. The biochemical methane potential test took 21 days and the process kinetics using the first-order model were determined. The results showed that biochars obtained under 400°C with atmospheric pressure and under HTC conditions improve methane yield by 3.6%. It has been revealed that thermochemical pressure influences the electrical conductivity of biochars. The biomethane was produced with a rate (k) of 0.24 d-1, and the most effective biochars increased the biodegradability of FW to 81% in comparison to variants without biochars (75%).