The plasma-activated gas is capable of decontaminating surfaces of different materials in remote distances. The effect of plasma-activated water vapor on Staphylococcus epidermidis, methicillin-resistant Staphylococcus aureus, Pseudomonas aeruginosa, and Escherichia coli biofilm contamination was investigated on the polypropylene nonwoven textile surface. The robust and technically simple multi-hollow surface dielectric barrier discharge was used as a low-temperature atmospheric plasma source to activate the water-based medium. The germicidal efficiency of short and long-time exposure to plasma-activated water vapor was evaluated by standard microbiological cultivation and fluorescence analysis using a fluorescence multiwell plate reader. The test was repeated in different distances of the contaminated polypropylene nonwoven sample from the surface of the plasma source. The detection of reactive species in plasma-activated gas flow and condensed activated vapor, and thermal and electrical properties of the used plasma source, were measured. The bacterial biofilm decontamination efficiency increased with the exposure time and the plasma source power input. The log reduction of viable biofilm units decreased with the increasing distance from the dielectric surface.

Biaxially oriented polypropylene (BOPP) is a highly transparent polymer defined by excellent mechanical and barrier properties applicable in the food packaging industry. However, its low surface free energy restricts its use in many industrial processes and needs to be improved. The presented study modifies a BOPP surface using two different atmospheric-pressure plasma sources operating in ambient air and capable of inline processing. The volume dielectric barrier discharge (VDBD) and diffuse coplanar surface barrier discharge (DCSBD) were applied to improve the wettability and adhesion of the 1–10 s treated surface. The changes in morphology and surface chemistry were analyzed by SEM, AFM, WCA/SFE, and XPS, and adhesion was evaluated by a peel force test. Comparing both plasma sources revealed their similar effect on surface wettability and incorporation of polar functional groups. Additionally, higher surface roughness in the case of VDBD treatment contributed to slightly more efficient adhesion in comparison to DCSBD. Although we achieved comparable results for both plasma sources in the term of enhanced surface wettability, degree of oxidation, and stability of induced changes, DCSBD had less effect on the surface deterioration than VDBD, where surface structuring caused an undesirable haze.

A study of plasma treatment of clay-coated paper is presented. The wettability of the paper surface before and after the plasma treatment was determined by measuring the water contact angle and surface free energy. The appearance of the surface-functional groups was determined by using high-resolution X-ray photoelectron spectroscopy, while changes in the surface morphology were monitored by scanning electron microscopy. Already after 0.25 s of the plasma treatment, the paper surface improved its wettability. The X-ray photoelectron spectroscopy analyses showed a gradual increase of oxygen-rich functional groups on the surface while scanning electron microscopy analyses did not show a significant modification of the morphology and no alternation of the surface structure after the plasma treatment.

In the current work, we studied the effect of multiphasic dielectric material on coplanar dielectric barrier discharge. To enhance the application potential of standard alumina ( A l 2 O 3 ) ceramic barriers, composite materials composed of immiscible A l 2 O 3 and Mg-spinel ( M g A l 2 O 4 ) phases were prepared and investigated. The effect on coplanar dielectric barrier discharge was studied in a broad concentration profile of the composite materials ranging from 0 to 100 vol.% M g A l 2 O 4 in an alumina matrix. The study was mainly focused on the determination of ignition voltage as a crucial parameter for industrial applications. The minimum ignition voltage was found in the ceramic composite with 15 vol.% M g A l 2 O 4 . We also noticed differences in plasma filament localization on the ceramic surfaces of different composites. This work also brings comprehensive investigation of the electrical and microstructural properties of this biphasic barrier material. Detailed investigation revealed that the ignition voltage was a nontrivial combination of both bulk (phase and chemical compositions) as well as surface (phase distribution, grain size, surface roughness) properties of the barrier materials.