The separation of Rare Earth Elements (REEs) is an important step in the valorization of REE ore and aims at producing individual rare earth compounds for the market. The separation is carried out industrially by solvent extraction (SX) using interconnected circuits consisting of cascades of mixer-settlers. The design of a REE separation circuit implies the selection of the operating conditions and of the number of mixer-settlers required to achieve a target degree of purity for the separated elements. This design work is either carried out by piloting a circuit or using a mathematical simulation. Independent of the method, the world expertise in this area is limited. This paper describes a simulation method requiring a minimum of calibration effort, which can be used to design a complete REE separation plant. The simulation enables assessment of the effect of the number of mixer-settlers per extraction, the scrubbing and stripping stage, as well as the pH of the aqueous solution and organic-phase contents of free and loaded extractant on the purity of the separated REEs. The simulation tool presented here has been developed from a fundamental analysis of the chemical reactions involved in the solvent extraction process. Unlike most of the simulation methods documented in the literature, the method requires no empirical calibration. The proposed method is validated using data from laboratory batch tests and with published data from continuous pilot and industrial REE separation circuits. The application of the simulation tool is illustrated with the planning of the test conditions for a forthcoming pilot test work and with the simulation of a 9-REE product SX separation plant.
A full factorial experimental design was conducted to investigate the effect of temperature and depressants on the flotation of monazite and bastnaesite from carbonate gangue minerals. Temperature, sodium silicate, and guar gum dosage were examined. Mineral reconstruction from energy-dispersive x-ray fluorescence (EDXRF) data was performed to quantify bastnaesite, monazite, and gangue mineral recoveries. Bastnaesite and monazite both follow first-order rates of recovery, with bastnaesite recovering faster and to a larger extent than monazite. The main gangue minerals were depressed together. Optimal separation efficiency was achieved using a larger Na2SiO3 dosage (2400 g/t), no guar gum addition, and a high temperature (75 °C). The rate of bastnaesite recovery increased with the temperature, while sodium silicate improved the ultimate recovery. An economic analysis was performed to evaluate the impact of increasing Rare Earth Element (REE) recovery by allowing a lower grade concentrate to be generated. Despite the high value of REEs, increasing recovery by producing a concentrate bearing more than 68 wt % carbonaceous gangue was uneconomical.
The electrolytic production of metallic zinc from processing zinc sulfide concentrates generates a residue containing cadmium, copper, and cobalt that need to be removed from the electrolytic zinc solution because they are harmful to the zinc electro-winning process. This residue is commonly sent to other parties that partly recover the contained elements. These elements can generate revenues if recovered at the zinc plant site. A series of laboratory tests were conducted to evaluate a method to process a zinc plant residue with the objective of recovering cobalt into a salable product. The proposed process comprises washing, selective leaching, purifying and precipitation of cobalt following its oxidation. The process allows the production of a cobalt rich hydroxide precipitate assaying 45 ± 4% Co, 0.8 ± 0.2% Zn, 4.4 ± 0.7% Cu, and 0.120 ± 0.004% Cd at a 61 ± 14% Co recovery. Replicating the whole process with different feed samples allowed the identification of the critical steps in the production of the cobalt product; one of these critical steps being the control of the oxidation conditions for the selective precipitation step.
Laboratory flotation tests carried out using an ore sample containing Rare Earth Elements (REEs) present as monazite and bastnaesite show that the flotation of monazite is slower and yielded lower recovery than that of bastnaesite. Results show that when studying the performances of a concentration process for an REE ore, it is essential to not look only at the behavior of the individual REEs but to convert elemental assays into mineral assays to obtain the mineral’s actual response to the concentration process. The results of the laboratory flotation tests are used to calibrate a flotation simulator applied to study different circuit configurations for the concentration of the REE minerals. Indeed, it is shown that for the studied ore, two cleaning stages of a rougher concentrate are sufficient to produce a concentrate with a Total Rare Earth Oxide (TREO) grade above 40%, which is acceptable for the subsequent hydrometallurgical process. The simulation also shows that it may be feasible, if required for the hydrometallurgy step, to separate bastnaesite and monazite by taking advantage of the different flotation kinetics of the two minerals.
This paper investigates the applicability of time‐gated Raman spectroscopy (TRS) for online mineralogy identification, focusing on a Li‐bearing spodumene ore. The study provides an overview of existing online mineralogy tools and points out some limitations of elemental analysis techniques. Dense media separation concentrate and tailing samples used originated from a deposit in Quebec, Canada. Various techniques, including ICP‐AES, XRD, laser diffraction, and specific gravity determination, were used for detailed sample characterization. Samples and their mixtures at known ratios were prepared as powder and slurries, before being analyzed using TRS, followed by spectrum quantitative analysis. Results show a linear correlation between spodumene percentage by weight and the main Raman peak height or area, in both dry and slurry form, with a higher determination coefficient in slurry form. TRS also provided indications as to the gangue minerals present in the samples. This study shows the potential for TRS as a tool for online mineralogical assessment of spodumene ores, and further work should target the determination of detection limits and quantification of both valuable and gangue minerals.