Silicon carbide (SiC) is a typical, difficult-to-machine material that has been widely used in the fabrication of optical elements and structural and heat-resistant materials. Parallel grinding has been frequently adopted to produce a high-quality surface finish. Surface generation is a vital issue for assessing surface quality, and extensive modeling has been developed. However, most of the models were based on a disc wheel with a cylindrical surface, whereas the surface topography generation based on an arc-shaped tool has been paid relatively little attention. In this study, a new theoretical model for surface generation in ultra-precision parallel grinding has been established by considering the arc-shaped effect, synchronous vibration of the wheel, and cutting profile interference in the tool feed direction. Finally, the ground surface generation mechanism and grinding ductility were analyzed in the grinding of SiC ceramics. The results showed that the spiral and straight-line mode vibration patterns were the main feature of the machined surface, and its continuity was mainly affected by the phase shift. Furthermore, for the in-phase shift condition, the grinding ductility was more significant than for the out-of-phase shift due to the continuously decreasing relative linear speed between the wheel and workpiece.
Nano-steps, as classical nano-geometric reference materials, are very important for calibrating measurements in the semiconductor industry; therefore, controlling the height of nano-steps is critical for ensuring accurate measurements. Accordingly, in this study nano-steps with heights of 1, 2, 3 and 4 nm were fabricated with good morphology using atomic layer deposition (ALD) combined with wet etching. The roughness of the fabricated nano-steps was effectively controlled by utilizing the three-dimensional conformal ALD process. Moreover, the relationship between the surface roughness and the height was studied using a simulation-based analysis. Essentially, roughness control is crucial in fabricating nano-steps with a critical dimension of less than 5 nm. In this study, the minimum height of a nano-step that was successfully achieved by combining ALD and wet etching was 1 nm. Furthermore, the preconditions for quality assurance for a reference material and the influencing factors of the fabrication method were analyzed based on the 1 nm nano-step sample. Finally, the fabricated samples were used in time-dependent experiments to verify the optimal stability of the nano-steps as reference materials. This research is instructive to fabricate nano-geometric reference materials to within 5 nm in height, and the proposed method can be easily employed to manufacture wafer-sized step height reference materials, thus enabling its large-scale industrial application for in-line calibration in integrated circuit production lines.
21 July 2021 in The International Journal of Advanced Manufacturing Technology
Subsurface damage of fused silica optics is one of the major factors restricting the performance of optical systems. The densification-affected deformation and fracture in fused silica under a sliding contact are investigated in this study, via three-dimensional finite element analysis (FEA). The finite element models of scratching with 70.3° conical and Berkovich indenters are established. A refined elliptical constitutive model is used to consider the influence of densification. The finite element models are experimentally verified by elastic recovery, and theoretically verified by hardness ratio. Results of densification and plastic deformation distributions indicate that the accuracy of existent sliding stress field models may be improved if the spherical/cylindrical yield region is replaced by an ellipsoid/cylindroid, and the embedding of the yield region is considered. The initiation sequence, and the locations and stages of radial, median, and lateral cracks are discussed by analyzing the predicted sliding stress fields. Median and radial cracks along the sliding direction tend to be the first cracks that emerge in the sliding and unloading stages, respectively. They coalesce to form a big median–radial crack that penetrates through the entire yield region. The fracture behavior of fused silica revealed in this study is essential in the low-damage machining of fused silica optics.
Advanced manufacturing technology and systems (AMTS) combine the principles of mechanical engineering with innovative design to create products and processes that are better, faster, and more precise