An alternative to mitigate the consumption of fossil fuels is the use of biomass as an energy source. In this sense, the rural sector in Latin America has great potential due to its multiple biomass sources. For this reason, this study aims to analyze potential technologies related to the production of energy from biomass and its application in the Latin American rural sector. To achieve this, four key processes are analyzed. First is biomass conditioning through solar dryers. Next are the thermochemical processes that allow for their transformation into biofuels, for which the pyrolysis and the hydrothermal methods were selected due to the flexibility of the products obtained. Subsequently, cogeneration is studied to produce electrical and thermal energy from biomass or its derivatives. Finally, to close the CO₂ cycle, a balance of CO₂ fixation in a forest plantation is presented as an example of carbon accumulated in biomass. The literature systematic review allowed us to determine that the technologies mentioned in this work have different degrees of implementation in the Latin American rural sector. However, they have great potential to be applied on a large scale in the region, making it possible to adapt energy production to climate change and improve the life quality of its inhabitants.

Tehuantepecers or Tehuanos are extreme winds produced in the Isthmus of Tehuantepec, blowing south through Chivela Pass, the mountain gap across the isthmus, from the Gulf of Mexico into the Pacific Ocean. They are the result of the complex interaction between large-scale meteorological conditions and local orographic forcings around Chivela Pass, and occur mainly in winter months due to cold air damming in the wake of cold fronts that reach as far south as the Bay of Campeche. Even though the name refers mostly to the intense mountain gap outflow, Tehuantepecer episodes can also generate other localized extreme wind conditions across the region, such as downslope windstorms and hydraulic jumps, which are strong turbulent flows that have a direct effect on the Pacific side of the isthmus and the Gulf of Tehuantepec. This study focuses on investigating these phenomena using high horizontal and vertical resolution WRF (Weather Research and Forecasting) model simulations. In particular, we employ a 4-nested grid configuration with up to 444 m horizontal spacing in the innermost domain and 70 hybrid-sigma vertical levels, 8 of which lie within the first 200 m above ground. We select one 36 h period in December 2013, when favorable conditions for a strong gap wind situation were observed. The high-resolution WRF experiment reveals a significant fine-scale structure in the strong Tehuano wind flow, beyond the well known gap jet. Depending on the Froude number upstream of the topographic barrier, different downslope windstorm conditions and hydraulic jumps with rotor circulations develop simultaneously at different locations east of Chivela Pass with varied crest height. A comparison with observations suggests that the model accurately represents the spatially heterogeneous intense downslope windstorm and the formation of mountain wave clouds for several hours, with low errors in wind speed, wind direction and temperature.

Solar energy capacity has increased significantly globally, with values above 800 GW produced by different systems. Among these, PVT panels can generate either electricity, heat, or both. As these systems present various issues associated with excessive temperature increases, cooling systems have been developed to control the temperature using fluids such as water. The article uses previous data from the Technologic Institute of Sonora, which analyzed various cooling device configurations and selected the best two options (B1 and B4) based on the panel efficiency. Using the boundary conditions and the predicted streamlines, a simulation was made in CFD programs, determining the correct parameters to replicate the system fluid dynamics. Several simulations were carried out using different turbulence models. After comparing the temperature contour diagram and the streamline, it was obtained that the k-ω turbulence model best describes the fluid's behavior. The transient analysis simulations allow us to determine that the B1 configuration delivers the best cooling effect as it presents the most homogeneous temperature profile. BIAS and RMSE were calculated to validate and contrast the results obtained experimentally, obtaining values of 0.8675 and 1.8981, respectively.

Among the most notable emerging hybrid technologies for water treatment are those that combine reverse osmosis (RO) membrane systems with alternative energy sources such as solar photovoltaic (PV). Solar PV modules can enable systems disconnected from the electricity grid, and in some locations can also be used for water heating as photovoltaic-thermal (PVT) units, a process in which water removes heat from the PV module, increasing its electrical generation efficiency. When combined with RO, the higher temperature feed water can increase RO permeate flux, improving recovery but decreasing the rejection of dissolved salts. Although the decrease in efficiency of PV modules at higher temperatures is a well-known issue, this is usually under conditions of uniform temperature. However, the temperature distribution in water-cooled PV modules is usually not uniform and, given the anisotropy of the distribution and electrical connection of the PV cells in the module, this factor has not been the focus of much study. In this context, a PVT unit that focuses on increasing the output water temperature with a high global heat transfer coefficient will not necessarily be the most electrically efficient system. This study experimentally assesses several proposed heat-exchange configurations for PVT systems where the PV modules are cooled by forced convective water flow. A simulation model of PVT performance is then validated and used to predict the productivity of the PVT-RO coupling, both in terms of electrical generation and permeate flux of the hybrid system under different conditions. The results suggest that water-cooled PV modules have several potential applications for off-grid and remote water treatment, as well as water transportation systems.