The article discusses the selection of cables for power lines connecting wind turbine generators at the wind power plant. The screen cross-section of these cables should be selected considering the value of the screen current at double line-to-earth fault. To calculate this current, the dimensions of the cable should be known. However, these parameters are hidden and cannot be used during designing. Therefore, a highly simplified method is currently used in practice. It is shown that the errors from the highly simplified method are up to 33%. Authors propose a simplified method based on open data of cable manufacturers. The proposed method is compared with simulation results of a common model of cable power line and takes into account self and mutual inductances of the cores and screens. It is shown that the error of the proposed method is smaller than 4.0% for real cable power lines at wind power plants. However, for a long section of cable power line (2.5 km) the error of calculation might increase up to 6.3%. This allows us to use the proposed method for designing. In addition, the authors show how the results of the highly simplified method can be corrected to improve accuracy.

Joomla! - the dynamic portal engine and content management system

A new method for determining the location of single-phase-to-ground faults through pin insulation in power networks with isolated neutral with using smart technologies has been proposed. The developed device for determining the location of faults in the power network with an accuracy of transmission tower. The features of connecting developed devices to existing SCADA-systems of network companies are described.

Joomla! - the dynamic portal engine and content management system