This work focuses on the impact of carrier gas on the quantity and quality of pyrolytic products received from intermediate pyrolysis of the brewer’s spent grain. In this study, three types of carrier gases were tested: argon, nitrogen, and carbon dioxide at three temperatures of 500, 600, and 700 °C. On the basis of the process conditions, the yield of products was determined. The ultimate analysis of the char was performed, and for selected chars, the combustion properties were determined. Gas chromatography of the organic fraction of oil was performed, and the compounds were determined. Additionally, microscale investigation of the spent grain pyrolysis was performed by thermogravimetric analysis. The results showed that there were no significant differences in product yields in various atmospheres. Char yield changed only with temperature from 28% at 500 °C up to 19% at 700 °C. According to ultimate analysis, the char from CO2 pyrolysis was approximately 2% richer in carbon and this fact did not influence on the combustion properties of the char. The oil fraction was characterized mainly by acids with a maximum content of 68% at 600 °C in an argon atmosphere and the acid concentration depended on the carrier gas as follows line: Ar > N2 > CO2.
Forecasts to 2030 indicate that demand for electricity will increase from 2% to 3% per year, and due to the observed high rate of development of the world economy, energy demand will continue to increase. More efficient use of primary energy has influence on reduction emissions and consumption of fuel. Besides, reducing the amount of fuel burned, it reveals a beneficial effect on the environment. Since extraction-back pressure turbines have some limitations, including the restriction of electricity production due to limited heat consumption in summer. The paper discusses the possibilities of integrating the adsorption aggregate with a combined cycle gas turbine and its impact on the operation of all devices. Simulations are performed on Sim tech IPSEPro software. The obtained results confirm that the adsorption aggregate, using a low grade of thermal energy, does not affect the operation of the gas and steam cycle and allows the production of electricity at a constant level. The calculated chemical fuel energy utilisation factor was 85.7% in cogeneration and 75.6% in trigeneration. These factors indicated a reduced utilisation of chemical fuel energy; however, this reduction is caused by a lower COP for adsorption chillers. Besides, the adsorption aggregate additionally generates chilled water for air conditioning or other technological processes, which stands for an added value of the innovative concept proposed in the paper.