Electrochemical atomic force microscopy (EC-AFM), a branch of a scanning probe microscopy (SPM), can image substrate topography with high resolution. Since its inception, it was extended to a wide range of research areas through continuous improvement. The presence of an electrolytic cell and a potentiostat makes it possible to observe the topographical changes of the sample surface in real time. EC-AFM is used in in situ corrosion research because the samples are not required to be electrically conductive. It is widely used in passive film properties, surface dissolution, early-stage corrosion initiation, inhibitor efficiency, and many other branches of corrosion science. This review provides the research progress of EC-AFM and summarizes the extensive applications and investigations using EC-AFM in corrosion science.

In this paper, ZL205A (AlCu5Mn alloy) castings were prepared by squeeze casting. The effects of solution and ageing treatment on the microstructure and mechanical properties of ZL205A castings were studied by metallography, scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS) and mechanical properties tests. The results showed that most of the θ(Al₂Cu) and T(Al₁₂CuMn₂) phases in squeeze-cast ZL205A dissolved into the α(Al) matrix after solution treatment for 15 h. The fine precipitates gradually increased with the ageing time. The ultimate tensile strength of the specimen aged for 6 h was the highest of 467 MPa and the elongation was up to 15.1%, showing good comprehensive mechanical properties.