Additive Manufacturing (AM) brought a revolution in parts design and production. It enables the possibility to obtain objects with complex geometries and to exploit structural optimization algorithms. Nevertheless, AM is far from being a mature technology and advances are still needed from different perspectives. Among these, the literature highlights the need of improving the frameworks that describe the design process and taking full advantage of the possibilities offered by AM. This work aims to propose a workflow for AM guiding the designer during the embodiment design phase, from the engineering requirements to the production of the final part. The main aspects are the optimization of the dimensions and the topology of the parts, to take into consideration functional and manufacturing requirements, and to validate the geometric model by computer-aided engineering software. Moreover, a case study dealing with the redesign of a piston rod is presented, in which the proposed workflow is adopted. Results show the effectiveness of the workflow when applied to cases in which structural optimization could bring an advantage in the design of a part and the pros and cons of the choices made during the design phases were highlighted.
26 December 2023 in International Journal of Fatigue
It has been recognized that parts produced by additive manufacturing with surfaces in the “as‐built” state exhibit reduced fatigue properties. On the other hand, post‐process surface finishing is expensive and often unfeasible due to the complexity of parts. Therefore, surface quality parameters must be considered when designing as‐built parts for structural applications. This work investigates the as‐built surface topography of Inconel 718 samples manufactured via laser powder bed fusion (L‐PBF) with three different production systems (SLM 280HL, EOS M290, and RENISHAW AM250) and discusses their respective experimental fatigue behavior. The aim of the investigation is to identify a link between the fatigue response of L‐PBF IN718 alloy without post fabrication finishing and the surface morphology; a preliminary comparison among the main surface roughness parameters and the fatigue strength is reported and further investigations are planned to find a univocal correlation. Samples with a mean height (Sa) of approximately 20 μm exhibit lower fatigue strength than those with Sa of approximately 5 μm. Skewness (Ssk) and kurtosis (Sku) are instead found to be discriminating parameters when comparing surfaces with relatively low surface roughness (Sa 5 μm), with higher values of Ssk and Sku associated with inferior fatigue performance.
21 April 2022 in Engineering Manufacturing Letters
The fatigue performance of materials, such as Inconel 718, when produced by Laser Powder Bed fusion, needs to be fully understood to manage and exploit the full potential of this Additive Manufacturing technology. Microstructure and as-built surface morphology are strictly related to process parameters and are known to affect the fatigue response. The present contribution examines experimentally the fatigue behavior of laser powder bed fused Inconel 718 testing specimens printed along three different orientations with respect to the built direction. The observed directional fatigue behavior is discussed in terms of surface quality, near-surface microstructure and their interaction with the fatigue crack initiation mechanisms.