Additive manufacturing of high strength Al alloys brings problems with hot cracking during rapid solidification. One of the ways to solve this challenge is technology developed by the Elementum 3D company. The way consists of inoculation by ceramic nanoparticles using RAM technology. When applying the L-PBF method, a very fine equiaxed microstructure with exceptional properties and without cracks is created. This paper offers the results and discussion of the microstructure, surface roughness and fatigue life of the high-strength Al2024-RAM2 alloy made from a gas atomized powder with an additive of 2 wt.% ceramic nanoparticles on the base of Ti. The specimens for fatigue tests were produced in different orientations relative to the building platform and left in the as-built conditions with different surface quality (roughness). The specimens were T6 heat-treated. The treatment caused a coarsening of a part of the fine grains. After T6 heat treatment, the hardness increased significantly, which occurred by precipitation hardening. Fatigue tests of specimens with different build orientation were performed in plane bending and the experimentally determined fatigue life was discussed in terms of surface roughness and material microstructure.
21 April 2022 in Engineering Manufacturing Letters
The fatigue performance of materials, such as Inconel 718, when produced by Laser Powder Bed fusion, needs to be fully understood to manage and exploit the full potential of this Additive Manufacturing technology. Microstructure and as-built surface morphology are strictly related to process parameters and are known to affect the fatigue response. The present contribution examines experimentally the fatigue behavior of laser powder bed fused Inconel 718 testing specimens printed along three different orientations with respect to the built direction. The observed directional fatigue behavior is discussed in terms of surface quality, near-surface microstructure and their interaction with the fatigue crack initiation mechanisms.