This article proposes a novel compliance compensator that can measure six-axis force, torque and displacement. The proposed device can provide the information necessary for feedback control while protecting the robot from impact. The device was designed based on a 6-DOF parallel mechanism to have six-axis sensing and deform greatly at the rated load without failure. We designed new flexure links with flexure joints connected in series, which facilitates fabrication and stiffness analysis. Through the stiffness analysis, the measured force can be converted to displacement and the stiffness of the device can be customized to the desired value by simply adjusting the thickness of the links. The sensing performance was evaluated through experiments using a commercial force/torque sensor (F/T sensor) and precision stages. We also propose a displacement-based misalignment compensation method in a robotic peg-in-hole assembly using the proposed device. The method uses the intrinsic passive compliance of the device and measured displacement, not the force and torque. We reduced the reaction force generated in the peg-in-hole assembly by 92.6% through the proposed method. The proposed method is simple and intuitive, and can be used for automatic teaching of the manipulator.
27 August 2022 in International Journal of Control, Automation, and Systems
This letter proposes and verifies a new method, the ring-pull mechanism, to overcome the disadvantages of existing wearable robotic gloves. By attaching a ring to the metacarpopha-langeal joint of the finger, the ring-pull mechanism supplements the grasping force of the user, while reducing the weight of the entire wearable robotic glove system. Ring-pull mechanism experiments were conducted to determine which finger combinations had the most positive effect on muscle strength assistance, and through this, the Ring-Pull type Soft Glove (RPSG) was developed. The main body of the developed RPSG is composed of single polymer silicon, a soft material, and is driven by tendon-driven actuation. The tendon path is secured through a tube attached to the palm that matches the direction of the flexor digitorum superficialis (FDS). The new type of wearable robotic glove was manufactured with the proposed mechanism, and excellent fit and strength support effects were confirmed. The RPSG increased the subject's grasping force by 25.69% on average, and the %MVIC data analysis demonstrated that the activation of FDS decreased by about 23.51%. As a result, it was confirmed that the user's muscle efficiency was increased due to the muscle support and muscle function improvement provided by the RPSG.
6 November 2024 in International Journal of Control, Automation, and Systems
Nowadays, many types of manipulators have been developed and used in lots of production processes. Force-based control methods or additional mechanical devices called Remote Center Compliance (RCC) have increased the system’s compliance and accuracy. However, the force-based control method’s operating speed is low, and the RCC cannot measure deflection. Thus it cannot calculate the position of the end-effector accurately. For accurate force and position control, it is necessary to measure the deflection of the RCC and to perform this, a different type of device than the existing RCC is required. This paper presents the necessity and possibility of developing an RCC capable of measuring the displacement of the end-effector and showing the displacement sensor’s feasibility using a 6 DOF parallel mechanism. In particular, we suggest that it is possible to make devices cheaper and more compact by using angular displacement sensors. Finally, we show the possibility of use in actual industrial sites through peg-in-hole simulation using the device.