It is generally accepted that climate changes will have a major effect on our lives. However, buildings will also be faced with climate changes, and these changes will have an impact on indoor comfort, energy demands and the efficiency of building services, especially on those supporting free cooling and free heating. In order to predict the expected changes in a building's thermal response during its lifetime, it is necessary to look at the climate changes predicted for the future. In our study, the climate changes were considered by using simplified mathematical models combined with available test reference years to establish ‘corrected test reference years’. A transient simulation tool, TRNSYS, was used to simulate the indoor climate and the useful energy demand for the heating and cooling of different buildings with different free-cooling techniques. In order to predict the expected changes in a building's thermal response, the meteorological parameters for the moderate, continental climate region of Slovenia were taken into account. The study shows that during a building's lifetime, significant changes in useful energy demands can be expected—a decrease in the useful energy demand for heating of between 23 and 40% and an up-to-38-times increase in the useful energy needed for mechanical cooling. In buildings without mechanical cooling, the efficiency of the different free-cooling techniques should be increased by between 100 and 200% to ensure the same living comfort. The results presented in the study confirm that it is necessary to evaluate the consequences of global climate changes from the point of view of energy use in buildings, their construction and the buildings' service installations. Copyright © 2008 John Wiley & Sons, Ltd.

The condensation of humid air is a crucial step in air conditioning and process engineering. However, the models that describe the condensation of vapour in the presence of a non-condensable gas require time-consuming numerical calculations that go beyond the Nusselt film theory. Only a small number of publications exist, where simple and computationally effective correlations for the condensation of water vapour in the presence of air are presented for specially designed condenser heat exchangers. Therefore, the objective of this paper is to extend the existing semi-empirical correlations for different geometries and process parameters. For the purpose of the study, an experimental setup with two different condenser heat exchangers based on vertical plates (height 74 mm) and horizontal tubes (3 tubes, diameter 40 mm and 7 tubes, diameter 15 mm) was built. Additionally, based on existing correlations, we developed two semi-empirical models that predict the condensation mass flux for the proposed geometries. Here, we report that the agreement between the experimental and theoretical values predicted by the new, semi-empirical correlations is excellent, with an average uncertainty of less than ±6%. Their usability was demonstrated by a possibly significant performance improvement of the condenser inside a condensation-type tumble dryer.

The main research objective of this paper was to compare exergy performance of three different heat pump (HP)-based systems and one natural gas (NG)-based system for the production of heating and cooling energy in a single-house dwelling. The study considered systems based on: 1. A NG and auxiliary cooling unit; 2. Solely HP, 3. HP with additional seasonal heat storage (SHS) and a solar thermal collector (STC); 4. HP with SHS, a STC and a grey water (GW) recovery unit. The assessment of exergy efficiencies for each case was based on the transient systems simulation program TRNSYS, which was used for the simulation of energy use for space heating and cooling of the building, sanitary hot water production, and the thermal response of the seasonal heat storage and solar thermal system. The results show that an enormous waste of exergy is observed by the system based on an NG boiler (with annual overall exergy efficiency of 0.11) in comparison to the most efficient systems, based on HP water–water with a seasonal heat storage and solar thermal collector with the efficiency of 0.47. The same system with an added GW unit exhibits lower water temperatures, resulting in the exergy efficiency of 0.43. The other three systems, based on air–, water–, and ground–water HPs, show significantly lower annual source water temperatures (10.9, 11.0, 11.0, respectively) compared to systems with SHS and SHS + GW, with temperatures of 28.8 and 19.3 K, respectively.