Pero Gatarić

Mr. Pero Gatarić

orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 October 2018 in Drying Technology
Verified
Journal Article
Closed access
PGPero Gatarić
Pero Gatarić
BŠBrane Širok
Brane Širok
MHMarko Hocevar
Marko Hocevar
LNLovrenc Novak
Lovrenc Novak
The use of heat pump tumble dryers is nowadays more common because they offer huge energy savings compared to conventional tumble dryers. Earlier studies made on conventional tumble dryers have shown that parameters such as heater power, fan speed, drum speed, weight and initial moisture content of textiles and air leakage have a huge impact on the energy efficiency and drying time. In the present study, a modified commercial heat pump tumble dryer was evaluated for energy consumption and drying time by changing operating parameters including fan speed, drum speed, and mass load. The total energy consumption and drying time were measured and corrected for the initial and final moisture content in the textiles. The experimental results based on 27 drying tests were evaluated to develop linear regression models for energy consumption and drying time, which show a good agreement with the experimental data. The results show that a large mass load, a high drum speed, and a low fan speed give the highest energy efficiency, i.e. the lowest energy consumption per kg of drying load. Larger loads extend the length of the drying cycle while higher fan and drum speeds result in shorter drying time.

4 March 2020 in Drying Technology
Verified
Journal Article
Closed access
LNLovrenc Novak
Lovrenc Novak
BŠBrane Širok
Brane Širok
MHMarko Hocevar
Marko Hocevar
PGPero Gatarić
Pero Gatarić
The present study investigates fabric motion in the drum and its effect on performance parameters of a domestic heat pump tumble dryer in several operating points, defined by different load masses and drum speeds. Fabric motion in the drum was recorded by using a high-speed camera and evaluated statistically in order to determine the relation between the fabric distribution and the dryer performance parameters. Multiple regression analysis was performed to develop models for condensate mass flow rate as a function of drum speed, load mass, and drying stage. The results enable optimization of dryer operating parameters with respect to energy efficiency, drying time per kilogram of fabric, and condensate mass flow rate.

23 June 2025 in Energy
Verified
Journal Article
Open access
PPPrimož Poredoš
Primož Poredoš
HSHe Shan
He Shan
ZSZhao Shao
Zhao Shao
FDFangfang Deng
Fangfang Deng
EZEva Zavrl
Eva Zavrl
RWRuzhu Wang
Ruzhu Wang

1 June 2021 in Drying Technology
Verified
Journal Article
Open access
PGPero Gatarić
Pero Gatarić
BŠBrane Širok
Brane Širok
MHMarko Hocevar
Marko Hocevar
LNLovrenc Novak
Lovrenc Novak
This work investigates the evenness of fabric drying in a household heat pump tumble dryer. The evenness of drying was defined as the standard deviation of the fraction of water, evaporated from each fabric item. Drying experiments were performed according to the IEC 61121 standard, which was also followed to determine quantities and types of cotton fabric items (towels, pillowcases and sheets) within each load. Regression analysis was performed to develop models for evenness of drying as a function of load mass and drum speed. Similarities between the tumble dryer energy efficiency parameters and the evenness of drying were analyzed. A high level of agreement was determined between responses of energy efficiency, drying time and evenness of drying to changes in drum speed. Effects of load mass were however more complex and were reflected in a non-linear response of evenness of drying to changes in load mass – the best evenness of drying could be obtained at 2 kg load, followed by 6 kg and 4 kg load. Load composition was determined as an important factor affecting the evenness of drying. At larger loads, a sheet or a pillowcase in average contributed more to the un-evenness of drying than a towel. The presence of sheets and probably the ratio of sheets to other item types in the load were determined as the most probable factors that negatively affected the evenness of drying.

19 April 2021 in Energies
Verified
Journal Article
Open access
PDF file
PPPrimož Poredoš
Primož Poredoš
NPNada Petelin
Nada Petelin
TŽTilen Žel
Tilen Žel
BVBoris Vidrih
Boris Vidrih
PGPero Gatarić
Pero Gatarić
Andrej KitanovskiAndrej Kitanovski
Andrej Kitanovski
The condensation of humid air is a crucial step in air conditioning and process engineering. However, the models that describe the condensation of vapour in the presence of a non-condensable gas require time-consuming numerical calculations that go beyond the Nusselt film theory. Only a small number of publications exist, where simple and computationally effective correlations for the condensation of water vapour in the presence of air are presented for specially designed condenser heat exchangers. Therefore, the objective of this paper is to extend the existing semi-empirical correlations for different geometries and process parameters. For the purpose of the study, an experimental setup with two different condenser heat exchangers based on vertical plates (height 74 mm) and horizontal tubes (3 tubes, diameter 40 mm and 7 tubes, diameter 15 mm) was built. Additionally, based on existing correlations, we developed two semi-empirical models that predict the condensation mass flux for the proposed geometries. Here, we report that the agreement between the experimental and theoretical values predicted by the new, semi-empirical correlations is excellent, with an average uncertainty of less than ±6%. Their usability was demonstrated by a possibly significant performance improvement of the condenser inside a condensation-type tumble dryer.