Purpose: – The purpose of this paper is to provide high-efficiency and high-power hybrid energy source for an urban electric vehicle. A power management strategy based on fuzzy logic has been introduced for battery-ultracapacitor (UC) energy storage. Design/methodology/approach: – The paper describes the design and construction of on-board hybrid source. The proposed energy storage system consists of battery, UCs and two DC/DC interleaved converters interfacing both storages. A fuzzy-logic controller (FLC) for the hybrid energy source is developed and discussed. Control structure has been tested using a non-mobile experimental setup. Findings: – The hybrid energy storage ensures high-power ability. Flexibility and robustness offered by the FLC give an easy accessible method to provide a power management algorithm extended with additional input information from road infrastructure or other vehicles. In the presented research, it was examined that using information related to the topography of the road in the control structure helps to improve hybrid storage performance. Research limitations/implications: – The proposed control algorithm is about to be validated also in an experimental car. Originality/value: – Exploratory studies have been provided to investigate the benefits of energy storage hybridization for electric vehicle. Simulation and experimental results confirm that the combination of lithium batteries and UCs improves performance and reliability of the energy source. To reduce power impulses drawn from the battery, power management algorithm takes into consideration information on slope of a terrain.
This paper introduces a simulation model of battery-ultracapacitor hybrid energy storage system. The study aims at creating adequate model to investigate the benefits of energy storage system hybridization for an electric vehicle. The experimental tests have been carried out in order to identify the parameters of lithium battery and ultracapacitor. The dynamic models are able to simulate terminal voltage of energy storage including the dependencies on state of charge and temperature.
This paper presents simulation studies and preliminary experimental results related to a hybrid battery-ultracapacitor energy source for an urban electric car. A proposal of energy management strategy based on fuzzy logic is introduced. Control strategy for the hybrid source is designed to achieve high-efficiency and high-power source for the vehicle with a relatively small battery storage. Simulation studies show the possibility to use information from a navigation system to improve performance of the source.
21 December 2020 in IEEE Transactions on Industrial Electronics
The paper proposes A ground-breaking solution to address the challenge of imposing constraints in a full-state feedback control system is proposed. In the developed control system a given state variable is stabilized at the threshold value using a separate full-state feedback controller. The overall controller consists then of a set of controllers, the main one with an external reference signal and auxiliary controllers with the internal references set to the desired limits to be imposed on each of the physical states of the plant under consideration, that operate in parallel fashion. This means that in each time instance the processor executes all full-state feedback controllers. Additionally, if the auxiliary integral states are implemented, a back-calculation algorithm is employed to keep the auxiliary states at a desired level for the controllers that are idling at a given time instance. The median of the calculated control signals is put through to the plant as a control signal. Such an elegant and straightforward way of handling constraints in the state feedback system has never been reported before and is currently patent pending. The proposed method is validated for a servo drive using a hardware in the loop setup. All the obtained results confirm technical feasibility of the controller structure and its ability to keep all the state variables within the required intervals.
1 June 2013 in Bulletin Of The Polish Academy Of Sciences-Technical Sciences
This paper discusses benefits of introducing an ultracapacitor (UC) bank into a battery electric vehicle (BEV) powertrain. The case of 12kWh LiFePO4 battery pack is studied quantitatively. Simulation results refer, inter alia, to three main scenarios: fresh cells, half-used battery cells, and half-used ultracapacitors and batteries. Thermal modeling is incorporated into the simulation. Data from real world are considered: various driving cycles recorded using GPS receiver (incl. elevation), discharge curves from battery manufacturer, and UC equivalent series resistance (ESR) variations due to cycling according to real data reported in papers. Cost, as well as gravimetric and volumetric issues are presented. The key decisions referring to an energy storage for BEV being currently designed within the frame of ECO-Mobility Project are highlighted.
The majority of the paper is devoted to debunking flawed methods proposed in the literature within the context of multiresonant control systems for grid-connected converters and then a novel approach is proposed. Several flawed approaches to grid tied power electronic converters (rectifiers and shunt active power filters) are discussed to initiate a critical discussion regarding some tuning methods reported in the topical literature. In this paper we analytically show that some of them are even erroneous from the control theory point of view or are based on mathematically erroneous derivations. That is especially prevalent for papers in which the Naslin polynomial method is employed to tune proportional-multiresonant controllers. Some authors recognize that the resulting control systems are not robust, i.e. not practical, and use obtained gains only as a starting point for further tuning using the trial and error method or evolutionary global optimization. Robustness of such systems is often not guaranteed and if it occurs at all, it is by chance or thanks to a combination of luck and expert knowledge of the engineer (not by deliberate design). Therefore, the absence of such a guarantee motivates the search for better ways to tune such controllers. As a result, a practical robust controller tuning method for multiresonant grid current controllers is proposed and verified experimentally. We are convinced that one of the solutions can be based on the disk margin stability analysis and a global search algorithm. The required robustness is expressed as stability margins. The design procedure is very user-friendly and the disk size is the key design parameter to be selected by an engineer. The practicality of the tuning method is demonstrated empirically in a 10 kVA physical grid-tied converter.