8 July 2014 in IEEE Transactions on Industrial Electronics
This paper presents evolutionary optimization of the linear quadratic regulator (LQR) for a voltage-source inverter with an LC output filter. The procedure involves particle-swarm-based search for the best weighting factors in the quadratic cost function. It is common practice that the weights in the cost function are set using the guess-and-check method. However, it becomes quite challenging, and usually very time-consuming, if there are many auxiliary states added to the system. In order to immunize the system against unbalanced and nonlinear loads, oscillatory terms are incorporated into the control scheme, and this significantly increases the number of weights to be guessed. All controller gains are determined altogether in one LQR procedure call, and the originality reported here refers to evolutionary tuning of the weighting matrix. There is only one penalty factor to be set by the designer during the controller synthesis procedure. This coefficient enables shaping the dynamics of the closed-loop system by penalizing the dynamics of control signals instead of selecting individual weighting factors for augmented state vector components. Simulational tuning and experimental verification (the physical converter at the level of 21 kVA) are included.
5 January 2015 in COMPEL - The international journal for computation and mathematics in electrical and electronic engineering
Purpose: – The purpose of this paper is to provide high-efficiency and high-power hybrid energy source for an urban electric vehicle. A power management strategy based on fuzzy logic has been introduced for battery-ultracapacitor (UC) energy storage. Design/methodology/approach: – The paper describes the design and construction of on-board hybrid source. The proposed energy storage system consists of battery, UCs and two DC/DC interleaved converters interfacing both storages. A fuzzy-logic controller (FLC) for the hybrid energy source is developed and discussed. Control structure has been tested using a non-mobile experimental setup. Findings: – The hybrid energy storage ensures high-power ability. Flexibility and robustness offered by the FLC give an easy accessible method to provide a power management algorithm extended with additional input information from road infrastructure or other vehicles. In the presented research, it was examined that using information related to the topography of the road in the control structure helps to improve hybrid storage performance. Research limitations/implications: – The proposed control algorithm is about to be validated also in an experimental car. Originality/value: – Exploratory studies have been provided to investigate the benefits of energy storage hybridization for electric vehicle. Simulation and experimental results confirm that the combination of lithium batteries and UCs improves performance and reliability of the energy source. To reduce power impulses drawn from the battery, power management algorithm takes into consideration information on slope of a terrain.
21 December 2020 in IEEE Transactions on Industrial Electronics
The paper proposes A ground-breaking solution to address the challenge of imposing constraints in a full-state feedback control system is proposed. In the developed control system a given state variable is stabilized at the threshold value using a separate full-state feedback controller. The overall controller consists then of a set of controllers, the main one with an external reference signal and auxiliary controllers with the internal references set to the desired limits to be imposed on each of the physical states of the plant under consideration, that operate in parallel fashion. This means that in each time instance the processor executes all full-state feedback controllers. Additionally, if the auxiliary integral states are implemented, a back-calculation algorithm is employed to keep the auxiliary states at a desired level for the controllers that are idling at a given time instance. The median of the calculated control signals is put through to the plant as a control signal. Such an elegant and straightforward way of handling constraints in the state feedback system has never been reported before and is currently patent pending. The proposed method is validated for a servo drive using a hardware in the loop setup. All the obtained results confirm technical feasibility of the controller structure and its ability to keep all the state variables within the required intervals.
1 June 2013 in Bulletin Of The Polish Academy Of Sciences-Technical Sciences
This paper discusses benefits of introducing an ultracapacitor (UC) bank into a battery electric vehicle (BEV) powertrain. The case of 12kWh LiFePO4 battery pack is studied quantitatively. Simulation results refer, inter alia, to three main scenarios: fresh cells, half-used battery cells, and half-used ultracapacitors and batteries. Thermal modeling is incorporated into the simulation. Data from real world are considered: various driving cycles recorded using GPS receiver (incl. elevation), discharge curves from battery manufacturer, and UC equivalent series resistance (ESR) variations due to cycling according to real data reported in papers. Cost, as well as gravimetric and volumetric issues are presented. The key decisions referring to an energy storage for BEV being currently designed within the frame of ECO-Mobility Project are highlighted.