Surface acoustic wave (SAW) devices have been utilized for the sensing of chemical and biological phenomena in microscale for the past few decades. In this study, SAW device was fabricated by electrospinning poly(vinylidenefluoride-co-trifluoroethylene) (P(VDF−TrFE)) incorporated with zinc oxide (ZnO) nanoparticles over the delay line area of the SAW device. The morphology, composition, and crystallinity of P(VDF−TrFE)/ZnO nanocomposites were investigated. After measurement of SAW frequency response, it was found that the insertion loss of the SAW devices incorporated with ZnO nanoparticles was much less than that of the neat polymer-deposited device. The fabricated device was expected to be used in acoustic biosensors to detect and quantify the cell proliferation in cell culture systems.
We present a phononic crystal to achieve efficient manipulation of surface acoustic waves (SAW). The structure is made of finite phononic micro-ridges arranged periodically in a substrate surface. Each ridge is constructed by staking silicon and tungsten layers so that it behaves as one-dimensional phononic crystal which exhibits band gaps for elastic waves. The band gap allows the existence of resonance modes where the elastic energy is either confined within units in the free end of the ridge or the ones in contact with the substrate. We show that SAW interaction with localized modes in the free surface of the ridge gives rise to sharp attenuation in the SAW transmission, while the modes confined within the ridge/substrate interface cause broad band attenuations of SAW. Furthermore, we demonstrate that the coupling between the two kinds of modes within the band gap gives high SAW transmission amplitude in the form of Fano-like peaks with high quality factor. The structure could provide an interesting solution for accurate SAW control for sensing applications, for instance.
Surface-acoustic-wave (SAW) sensors have undergone outstanding developments during the last decades. However, for biosensing applications, they struggle to compete with optical sensing technologies. In this work, we present a Love-wave-based sensing platform that leverages the use of the local resonances of micropillars fabricated on the surface of the guiding layer. We demonstrate numerically and experimentally that the Love-wave interaction with the micropillars produces sharp attenuation dips in the transmission spectrum. These dips are associated with the excitations of flexural and torsional resonance modes of the pillars. We utilize these modes to achieve higher detection sensitivity of temperature variation and mass loading using sugar and microbeads concentrations in aqueous solutions. Integrating a lattice of micropillars into SAW-based devices offers a strong potential for detecting low particles concentrations.
In this paper, the layered structure ZnO/Quartz (90deg rotated ST-cut) is investigated theoretically and experimentally. Both waves, Rayleigh and Love, are analyzed. Dispersion curves of phase velocities, electromechanical coupling coefficient (K2) and temperature coefficient of frequency (TCF) were calculated as a function of normalized thickness ZnO film (khZnO = 2pihZnO /lambda) and the optimum value of hZnO was determined for experimental study. Experimental results combined with simulation lead to clearly identify the generated waves and their higher modes in this structure except the mode 0 that shows comparable velocity for both Rayleigh and Love waves. The identification of the wave type was performed by studying the frequency response of the device with or without a droplet of water in the wave path. We also demonstrate that the highest elastic velocity is obtained for the mode 1 of the Love wave. This Love wave mode exhibits very interesting electrical characteristics, good K2, high-frequency rejection, low TCF, and very low attenuation in liquid making it very attractive for gas and liquid sensor applications.
Medical imaging has relied on ultrasound (US) as an exploratory method for decades. Nonetheless, in cell biology, the numerous US applications are mainly in the research and development phase. In this review, we report the main effects on human or mammal cells of US induced by bulk or surface acoustic waves (SAW). At low frequencies, bulk US can lead to cell death. Under specific intensities and exposure times, however, cell proliferation and migration can be enhanced through cytoskeleton fluidization (a reorganization of the actin filaments and microtubules). Cavitation phenomena, frequencies of resonance close to those of the biological compounds, and mechanical transfers of energy from the acoustic pressure could explain those biological outcomes. At higher frequencies, no cavitation is observed. However, USs of high frequency stimulate ionic channels and increase cell permeability and transfection potency. Surface acoustic waves are increasingly exploited in microfluidics, especially for precise cell manipulations and cell sorting. With applications in diagnosis, infection, cancer treatment, or wound healing, US has remarkable potential. More mechanotransduction studies would be beneficial to understand the distinct roles of temperature rise, acoustic streaming and mechanical and electrical stimuli in the field.