The importance of lakes and reservoirs leads to the high need for monitoring lake water quality both at local and global scales. The aim of the study was to test suitability of Sentinel-2 Multispectral Imager’s (MSI) data for mapping different lake water quality parameters. In situ data of chlorophyll a (Chl a), water color, colored dissolved organic matter (CDOM) and dissolved organic carbon (DOC) from nine small and two large lakes were compared with band ratio algorithms derived from Sentinel-2 Level-1C and atmospherically corrected (Sen2cor) Level-2A images. The height of the 705 nm peak was used for estimating Chl a. The suitability of the commonly used green to red band ratio was tested for estimating the CDOM, DOC and water color. Concurrent reflectance measurements were not available. Therefore, we were not able to validate the performance of Sen2cor atmospheric correction available in the Sentinel-2 Toolbox. The shape and magnitude of water reflectance were consistent with our field measurements from previous years. However, the atmospheric correction reduced the correlation between the band ratio algorithms and water quality parameters indicating the need in better atmospheric correction. We were able to show that there is good correlation between band ratio algorithms calculated from Sentinel-2 MSI data and lake water parameters like Chl a (R² = 0.83), CDOM (R² = 0.72) and DOC (R² = 0.92) concentrations as well as water color (R² = 0.52). The in situ dataset was limited in number, but covered a reasonably wide range of optical water properties. These preliminary results allow us to assume that Sentinel-2 will be a valuable tool for lake monitoring and research, especially taking into account that the data will be available routinely for many years, the imagery will be frequent, and free of charge.

Many lakes in boreal and arctic regions have high concentrations of CDOM (coloured dissolved organic matter). Remote sensing of such lakes is complicated due to very low water leaving signals. There are extreme (black) lakes where the water reflectance values are negligible in almost entire visible part of spectrum (400–700 nm) due to the absorption by CDOM. In these lakes, the only water-leaving signal detectable by remote sensing sensors occurs as two peaks—near 710 nm and 810 nm. The first peak has been widely used in remote sensing of eutrophic waters for more than two decades. We show on the example of field radiometry data collected in Estonian and Swedish lakes that the height of the 810 nm peak can also be used in retrieving water constituents from remote sensing data. This is important especially in black lakes where the height of the 710 nm peak is still affected by CDOM. We have shown that the 810 nm peak can be used also in remote sensing of a wide variety of lakes. The 810 nm peak is caused by combined effect of slight decrease in absorption by water molecules and backscattering from particulate material in the water. Phytoplankton was the dominant particulate material in most of the studied lakes. Therefore, the height of the 810 peak was in good correlation with all proxies of phytoplankton biomass—chlorophyll-a (R² = 0.77), total suspended matter (R² = 0.70), and suspended particulate organic matter (R² = 0.68). There was no correlation between the peak height and the suspended particulate inorganic matter. Satellite sensors with sufficient spatial and radiometric resolution for mapping lake water quality (Landsat 8 OLI and Sentinel-2 MSI) were launched recently. In order to test whether these satellites can capture the 810 nm peak we simulated the spectral performance of these two satellites from field radiometry data. Actual satellite imagery from a black lake was also used to study whether these sensors can detect the peak despite their band configuration. Sentinel 2 MSI has a nearly perfectly positioned band at 705 nm to characterize the 700–720 nm peak. We found that the MSI 783 nm band can be used to detect the 810 nm peak despite the location of this band is not in perfect to capture the peak.

The pool of dissolved organic carbon (DOC), is one of the main regulators of the ecology and biogeochemistry of inland water ecosystems, and an important loss term in the carbon budgets of land ecosystems. We used a novel machine learning technique and global databases to test if and how different environmental factors contribute to the variability ofin situDOC concentrations in lakes. In order to estimate DOC in lakes globally we predicted DOC in each lake with a surface area larger than 0.1 km². Catchment properties and meteorological and hydrological features explained most of the variability of the lake DOC concentration, whereas lake morphometry played only a marginal role. The predicted average of the global DOC concentration in lake water was 3.88 mg L⁻¹. The global predicted pool of DOC in lake water was 729 Tg from which 421 Tg was the share of the Caspian Sea. The results provide global-scale evidence for ecological, climate and carbon cycle models of lake ecosystems and related future prognoses.

The launch of Ocean and Land Colour Instrument (OLCI) on board Sentinel-3A in 2016 is the beginning of a new era in long time, continuous, high frequency water quality monitoring of coastal waters. Therefore, there is a strong need to validate the OLCI products to be sure that the technical capabilities provided will be used in the best possible way in water quality monitoring and research. The Baltic Sea is an optically complex waterbody where many ocean colour products, performing well in other waterbodies, fail. We tested the performance of standard Case-2 Regional/Coast Colour (C2RCC) processing chain in retrieving water reflectance, inherent optical properties (IOPs), and water quality parameters such as chlorophyll a, total suspended matter (TSM) and coloured dissolved organic matter (CDOM) in the Baltic Sea. The reflectance spectra produced by the C2RCC are realistic in both shape and magnitude. However, the IOPs, and consequently the water quality parameters estimated by the C2RCC, did not have correlation with in situ data. On the other hand, some tested empirical remote sensing algorithms performed well in retrieving chlorophyll a, TSM, CDOM and Secchi depth from the reflectance produced by the C2RCC. This suggests that the atmospheric correction part of the processor performs relatively well while IOP retrieval part of the neural network needs extensive training with actual IOP data before it can produce reasonable estimates for the Baltic Sea.

Currently, water monitoring programs are mainly based on in situ measurements; however, this approach is time-consuming, expensive, and may not reflect the status of the whole water body. The availability of Multispectral Imager (MSI) and Ocean and Land Colour Instrument (OLCI) free data with high spectral, spatial, and temporal resolution has increased the potential of adding remote sensing techniques into monitoring programs, leading to improvement of the quality of monitoring water. This study introduced an optical water type guided approach for boreal regions inland and coastal waters to estimate optical water quality parameters, such as the concentration of chlorophyll-a (Chl-a) and total suspended matter (TSM), the absorption coefficient of coloured dissolved organic matter at a wavelength of 442 nm (aCDOM(442)), and the Secchi disk depth, from hyperspectral, OLCI, and MSI reflectance data. This study was based on data from 51 Estonian and Finnish lakes and from the Baltic Sea coastal area, which altogether were used in 415 in situ measurement stations and covered a wide range of optical water quality parameters (Chl-a: 0.5–215.2 mg·m⁻³; TSM: 0.6–46.0 mg·L⁻¹; aCDOM(442): 0.4–43.7 m⁻¹; and Secchi disk depth: 0.2–12.2 m). For retrieving optical water quality parameters from reflectance spectra, we tested 132 empirical algorithms. The study results describe the best algorithm for each optical water type for each spectral range and for each optical water quality parameter. The correlation was high, from 0.87 up to 0.93, between the in situ measured optical water quality parameters and the parameters predicted by the optical water type guided approach.