The launch of Ocean and Land Colour Instrument (OLCI) on board Sentinel-3A in 2016 is the beginning of a new era in long time, continuous, high frequency water quality monitoring of coastal waters. Therefore, there is a strong need to validate the OLCI products to be sure that the technical capabilities provided will be used in the best possible way in water quality monitoring and research. The Baltic Sea is an optically complex waterbody where many ocean colour products, performing well in other waterbodies, fail. We tested the performance of standard Case-2 Regional/Coast Colour (C2RCC) processing chain in retrieving water reflectance, inherent optical properties (IOPs), and water quality parameters such as chlorophyll a, total suspended matter (TSM) and coloured dissolved organic matter (CDOM) in the Baltic Sea. The reflectance spectra produced by the C2RCC are realistic in both shape and magnitude. However, the IOPs, and consequently the water quality parameters estimated by the C2RCC, did not have correlation with in situ data. On the other hand, some tested empirical remote sensing algorithms performed well in retrieving chlorophyll a, TSM, CDOM and Secchi depth from the reflectance produced by the C2RCC. This suggests that the atmospheric correction part of the processor performs relatively well while IOP retrieval part of the neural network needs extensive training with actual IOP data before it can produce reasonable estimates for the Baltic Sea.

Peatlands of northern temperate and cold climates are significant pools of stored carbon. Understanding seasonal dynamics of peatland surface height and volume, often referred to as mire breathing or oscillation, is the key to improve spatial models of material flow and gas exchange. The monitoring of this type of dynamics over large areas is only feasible by remote sensing instruments. The objective of this study is to examine the applicability of Sentinel-1 synthetic aperture radar interferometry (InSAR) to characterize seasonal dynamics of peatland surface height and water table (WT) over open raised bog areas in Endla mire complex in central Estonia, characteristic for northern temperate bogs. Our results show that InSAR temporal coherence, sufficient for differential InSAR (DInSAR), is preserved in the open bog over more than six months of temporal baseline. Moreover, the coherence which is lost in a dry summer, make a recovery in autumn correlate with WT dynamics. The relationship between the coherence from a single master image and the corresponding WT difference is described by the second degree polynomial regression model (Root Mean Squared Error RMSE = 0.041 for coherence magnitude). It is also demonstrated that DInSAR phase is connected to bog surface dynamics and reveals differences between bogs and for ecotopes within a bog. These findings suggest that InSAR long term temporal coherence could be used to describe seasonal bog WT dynamics and differentiate between mire types and ecotopes within a bog. Moreover, DInSAR analysis has the potential to characterize seasonal mire surface oscillation which may be important for assessing the capacity of water storage or restoration success in northern temperate bogs.

A method for estimating meteo-marine parameters from satellite Synthetic Aperture Radar (SAR) data, intended for near-real-time (NRT) service over the Baltic Sea, is presented and validated. Total significant wave height data are retrieved with an empirical function CWAVE_S1-IW, which combines spectral analysis of Sentinel-1A/B Interferometric Wide swath (IW) subscenes with wind data derived with common C-Band Geophysical Model Functions (GMFs). In total, 15 Sentinel-1A/B scenes (116 acquisitions) over the Baltic Sea were processed for comparison with off-shore sea state measurements (52 collocations) and coastal wind measurements (357 colocations). Sentinel-1 wave height was spatially compared with WAM wave model results (Copernicus Marine Environment Monitoring Service (CMEMS). The comparison of SAR-derived wave heights shows good agreement with measured wave heights correlation r of 0.88 and with WAM model (r = 0.85). The wind speed estimated from SAR images yields good agreement with in situ data (r = 0.91). The study demonstrates that the wave retrievals from Sentinel-1 IW data provide valuable information for operational and statistical monitoring of wave conditions in the Baltic Sea. The data is valuable for model validation and interpretation in regions where, and during periods when, in situ measurements are missing. The Sentinel-1 A/B wave retrievals provide more detailed information about spatial variability of the wave field in the coastal zone compared to in situ measurements, altimetry wave products and model forecast. Thus, SAR data enables estimation of storm locations and areal coverage. Methods shown in the study are implemented in NRT service in German Aerospace Center’s (DLR) ground station Neustrelitz.

Multi-mission satellite altimetry (e.g., ERS, Envisat, TOPEX/Poseidon, Jason) data have enabled a synoptic-scale view of ocean variations in past decades. Since 2016, the Sentinel-3 mission has provided better spatial and temporal sampling compared to its predecessors. The Sentinel-3 Ku/C Radar Altimeter (SRAL) is one of the synthetic aperture radar altimeters (SAR Altimeter) which is more precise for coastal and lake observations. The article studies the performance of the Sentinel-3 Level-2 sea level altimetry products in the coastal areas of the Baltic Sea and on two lakes of Estonia. The Sentinel-3 data were compared with (i) collocated Global Navigation Satellite System (GNSS) ship measurements, (ii) the Estonian geoid model (EST-GEOID2017) together with sea-level anomaly corrections from the tide gauges, and (iii) collocated buoy measurements. The comparisons were carried out along seven Sentinel-3A/B tracks across the Baltic Sea and Estonian lakes in 2019. In addition, the Copernicus Marine Environment Monitoring Service (CMEMS) Level-3 sea-level products and the Nucleus for European Modelling of the Ocean (NEMO) reanalysis outcomes were compared with measurements from Estonia’s 21 tide gauges and the buoy deployed offshore. Our results showed that the uncertainty of the Sentinel-3 Level-2 altimetry product was below decimetre level for the seacoast and the selected lakes of Estonia. Results from CMEMS Level-3 altimetry products showed a correlation of 0.83 (RMSE 0.18 m) and 0.91 (RMSE 0.27 m) when compared against the tide gauge measurements and the NEMO model, respectively. The overall performance of the altimetry products was very good, except in the immediate vicinity of the coastline and for the lakes, where the accuracy was nearly three times lower than for the open sea, but still acceptably good.

The current study presents a methodology for water mapping from Sentinel-1 (S1) data and a flood extent analysis of the three largest floodplains in Estonia. The automatic processing scheme of S1 data was set up for the mapping of open-water flooding (OWF) and flooding under vegetation (FUV). The extremely mild winter of 2019/2020 resulted in several large floods at floodplains that were detected from S1 imagery with a maximal OWF extent up to 5000 ha and maximal FUV extent up to 4500 ha. A significant correlation (r² > 0.6) between the OWF extent and the closest gauge data was obtained for inland riverbank floodplains. The outcome enabled us to define the water level at which the water exceeds the shoreline and flooding starts. However, for a coastal river delta floodplain, a lower correlation (r² < 0.34) with gauge data was obtained, and the excess of river coastline could not be related to a certain water level. At inland riverbank floodplains, the extent of FUV was three times larger compared to that of OWF. The correlation between the water level and FUV was <0.51, indicating that the river water level at these test sites can be used as a proxy for forest floods. Relating conventional gauge data to S1 time series data contributes to flood risk mitigation.