Antonio Pallarés-Sabater

Dr. Antonio Pallarés-Sabater

orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 August 2021 in Dentistry Journal
Verified
Journal Article
Open access
PDF file
ASAlba Pallarés Serrano
Alba Pallarés Serrano
SPSandra Pallarés-Serrano
Sandra Pallarés-Serrano
APAntonio Pallares-Serrano
Antonio Pallares-Serrano
APAntonio Pallarés-Sabater
Antonio Pallarés-Sabater
Internal bleaching is a conservative, non-invasive, and simple treatment that is frequently performed in daily clinical practice. The present in vitro study analyzes the oxygen expansion of different bleaching agents resulting from the oxidation reaction when interacting with enamel and dentin. Enamel and dentin were crushed separately until obtaining a fine powder with particles of an approximate size between 0.06 and 0.2 mm. Each enamel and dentin sample were mixed with 37% carbamide peroxide (CP 37%), 30% hydrogen peroxide (HP 30%), sodium perborate (SP) combined with HP 30% (HP 30% + SP) and SP with distilled water (SP). A total of 280 1 mm diameter glass tubes were used with 70 for each bleaching agent (30 for powdered enamel evaluation, 30 for powdered dentin evaluation, and 10 controls). The bleaching agents were placed in the prepared tubes immediately after mixing the components. As expansion occurred, the oil inside the tube was displaced, through which the resulting expansion was evaluated and measured for 10 days. A significant expansion was observed that varied in magnitude according to the bleaching agent and the tooth structure used. Student’s t test and Welch’s ANOVA were used to analyze the data obtained. The highest mean expansion of both enamel and dentin was observed with 30% HP (66.6 mm for enamel, 94.5 mm for dentin) followed by HP 30% + SP (48.6 mm for enamel, 52.7 mm for dentin), CP 37% (38.4 mm for enamel, 52.6 mm for dentin) and finally SP with water (12.7 mm for enamel, 4.4 mm for dentin). It was observed that the expansion in the SP group with enamel was significantly lower than in the rest of the groups, while that registered for HP 30% was significantly higher. (p < 0.001). The results with dentin were similar, with a significantly lower expansion for SP and higher for HP 30% (p < 0.001). The oxygen expansion observed as a result of the interaction between bleaching agents and dental tissues could contribute to improving our understanding of bleaching and its results. These results suggest that bleaching agents react with the organic component of the tooth structure.

9 March 2022 in Applied Sciences
Verified
Journal Article
Open access
PDF file
ASAlba Pallarés Serrano
Alba Pallarés Serrano
APAntonio Pallares-Serrano
Antonio Pallares-Serrano
SPSandra Pallarés-Serrano
Sandra Pallarés-Serrano
APAntonio Pallarés-Sabater
Antonio Pallarés-Sabater
Intra-coronal bleaching is a treatment that whitens non-vital teeth from within the pulp chamber, a procedure by which oxygen and free radicals are released. This in vitro study analyzed and compares the oxygen expansion produced when different bleaching agents encounter dental tissues during this type of bleaching. Here, 120 lower incisors were included and prepared to achieve conditions as close as practicable to internal bleaching with the walking bleach technique. The access cavity of the lingual surface was prepared to seal glass tubes with oil inside them by adhesive restoration once the bleach was placed inside the pulp chamber. The following bleaching groups were used: hydrogen peroxide (HP) 30% (n = 30), sodium Perborate (SP) with distilled water (n = 30), a mixture of HP 30% with SP (n = 30) and a control group (n = 30). After 10 days, the oil displacement that took place through the tube due to oxygen release was measured daily. Displacement of the oil was observed in all groups except the control group. The final mean expansion at 10 days was 335.24 ± 76.85 mm for the HP 30% group, 8.40 ± 1.74 mm for the SP group and 183.07 ± 49.93 mm for the HP30% + SP mixture. Significant statistical differences were observed between the three groups using the Games–Howell post hoc test, where HP30% caused the greatest expansion and SP the least expansion. These results suggest that the higher the amount of HP in the sample, the more oxygen expansion is observed, so that temporary restoration must be performed more carefully to avoid displacement.

1 January 2016 in The Journal of Advanced Prosthodontics
Verified
Journal Article
Open access
PDF file
RMRaquel Montes-Fariza
Raquel Montes-Fariza
MMManuel Monterde-Hernández
Manuel Monterde-Hernández
CCCristina Cabanillas-Casabella
Cristina Cabanillas-Casabella
APAntonio Pallarés-Sabater
Antonio Pallarés-Sabater
Montes-Fariza R, et al. J Adv Prosthodont. 2016 Jun;8(3):201-206. http://dx.doi.org/10.4047/jap.2016.8.3.201

27 March 2024 in Materials
Verified
Journal Article
Open access
PDF file
SPSandra Pallarés-Serrano
Sandra Pallarés-Serrano
APAlba Pallarés-Serrano
Alba Pallarés-Serrano
APAntonio Pallarés-Serrano
Antonio Pallarés-Serrano
APAntonio Pallarés-Sabater
Antonio Pallarés-Sabater
Polishing after the removal of brackets is the final step in orthodontic treatment. It is simple to perform, though some studies have reported that polishing causes damage to the enamel surface. An in vitro study was made of the influence of the buccal surface convexity of the tooth upon possible enamel loss when the remaining resin and adhesive are removed after bracket decementing using two different polishing modes: a tungsten carbide bur at low and high speeds. The convexity of the buccal surface was quantified in 30 incisors and 30 premolars. A stereoscopic microscope was used to obtain photographs of the profile of the crown, and Image J software was used to calculate convexity by dividing the length of a line from the cementoenamel junction to the incisal margin by another line from the mentioned junction to the maximum convexity of the buccal surface. Brackets were cemented on all the teeth and were decemented 24 h later. In both groups, the residual composite was removed with a tungsten carbide bur at a low speed in one-half of the teeth and at a high speed in the other half. The buccal surface of each tooth was then photographed again, and the convexity was calculated and compared against the baseline value. The difference between the two values were taken to represent the enamel loss. The convexity of the premolars was significantly greater than that of the incisors, but this did not result in greater enamel loss when the same polishing mode was used. However, the tungsten carbide bur at a high speed proved more aggressive, causing significantly greater enamel loss than when used at a low speed.

22 September 2025 in Journal of Clinical Medicine
Verified
Journal Article
Open access
PDF file
SASusana Aranda
Susana Aranda
APAntonio Pallarés-Sabater
Antonio Pallarés-Sabater
APAntonio Pallares-Serrano
Antonio Pallares-Serrano
JCJorge Rubio Climent
Jorge Rubio Climent
CACasino A.
Casino A.
Background: Endo-periodontal lesions (EPLs) are defined by a pathological connection between the pulp and the periodontium in a specific tooth. Although the identification of EPL etiology is of paramount importance for a correct treatment plan, it may be impossible at times to pinpoint the primary cause prospectively. A critical aspect of treatment planning involves assessing the necessity of root canal treatment in periodontal patients presenting with EPLs, evaluating the indication for periodontal intervention in cases of endodontic origin and determining whether splinting of the affected tooth is required. The aim of this article is to provide a concise perspective on the management of EPLs without root damage. Methods: A clinical decision-making flowchart was created based on current classification systems to guide treatment strategies for EPLs. Results: A flowchart of the treatment of EPLs based on possible decision pathways with a starting point in the diagnosis of the periodontitis or non-periodontitis patient that can prove particularly useful in cases where the initial etiology remains uncertain. Conclusions: EPLs are infections that represent a significant clinical challenge. This article summarizes key diagnostic considerations and therapeutic steps, offering practical guidance for clinicians managing these lesions.

17 December 2022 in Materials
Verified
Journal Article
Open access
PDF file
BLANCA GIL MARQUÉSBLANCA GIL MARQUÉS
BLANCA GIL MARQUÉS
APAntonio Pallarés-Sabater
Antonio Pallarés-Sabater
Aritza Brizuela-VelascoAritza Brizuela-Velasco
Aritza Brizuela-Velasco
Fernando Sanchez LasherasFernando Sanchez Lasheras
Fernando Sanchez Lasheras
PLPedro Lázaro-Calvo
Pedro Lázaro-Calvo
CLCarolina Larrazábal
Carolina Larrazábal
Edentulism produces resorption of alveolar bone processes, which can complicate placement of dental implants. Guided bone regeneration techniques aim to recover the volume of bone. These treatments are susceptible to the surgical technique employed, the design of the autologous block or the tension of the suture. These factors can relate to major complications as the lack of primary closure and dehiscence. The present study, using finite element analysis, aimed to determine differences in terms of displacement of the oral mucosa, transferred stress according to Von Mises and deformation of soft tissue when two block graft designs (right-angled and rounded) and two levels of suture tension (0.05 and 0.2 N) were combined. The results showed that all the variables analyzed were greater with 0.2 N. Regarding the design of the block, no difference was found in the transferred stress and deformation of the soft tissue. However, displacement was related to a tendency to dehiscence (25% greater in the right-angled/chamfer design). In conclusion different biomechanical behavior was observed in the block graft depending on the design and suture tension, so it is recommended to use low suture tension and rounded design. A novel finite element analysis model is presented for future investigations.