Christian Zollner

Dr. Christian Zollner


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 October 2021 in Semiconductor Science and Technology
Verified
Journal Article
Closed access
CZChristian Zollner
Christian Zollner
SDS P DenBaars
S P DenBaars
JSJ S Speck
J S Speck
SNS Nakamura
S Nakamura
Ultraviolet light emitting diodes (UV LEDs) are one of the most promising technologies for preventing future pandemics, improving health outcomes, and disinfecting water sources. Currently available UV LEDs emitting in the conventional germicidal wavelength range (254–285 nm) have efficiencies below 5% and cost about 100 times more (per watt) than mercury vapor lamps. On the other hand, germicidal UV LEDs provide many advantages over vapor lamps including instant-on and dimmable functionality, wavelength tunability, miniaturization, and durability, and are already in widespread use for certain applications. It is expected that III-nitride based UV LEDs will soon have similar cost and efficiency to white LEDs and will become the dominant germicidal light source within this decade. Unlike vapor discharge lamps, LEDs have theoretical efficiency limits approaching 100%; the challenges to improving UV LED efficiency are not fundamental, but technological. Improvements in material quality, chemical purity, electrical conductivity, optical transparency, and fabrication technologies are needed. In this review, we outline the major challenges in each of these areas and summarize the recent advances that have enabled rapid improvements in UV LED efficiency within the past 5 years. We discuss the physical principles underlying the mechanisms of improved efficiency, and comment on likely future trends in UV LED design and commercialization.

14 October 2019 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
CZChristian Zollner
Christian Zollner
AAAbdullah Almogbel
Abdullah Almogbel
YYYifan Yao
Yifan Yao
BSBurhan SaifAddin
Burhan SaifAddin
FWFeng Wu
Feng Wu
SNShuji Nakamura
Shuji Nakamura
Crack-free AlN films with threading dislocation density (TDD) below 109 cm−2 are needed for deep-UV optoelectronics. This is typically achieved using pulsed lateral overgrowth or very thick buffer layers (>10 μm), a costly and time-consuming approach. A method for conventional metalorganic chemical vapor deposition growth of AlN/SiC films below 3 μm with greatly improved quality is presented. Focusing on substrate pretreatment before growth, we reduce average film stress from 0.9 GPa (tension) to −1.1 GPa (compression) and eliminate cracking. Next, with optimized growth conditions during initial deposition, AlN films with x-ray rocking curve widths of 123 arc-sec ( 0002 ) and 304 arc-sec ( 20 2 ¯ 1 ) are developed, and TDD is confirmed via plan view transmission electron microscopy (TEM) to be 2 × 108 cm−2. Film stress measurements including x-ray 2θ-ω, reciprocal space mapping, and curvature depict compressively stressed growth of AlN on 4H-SiC due to lattice mismatch. The thermal expansion coefficient mismatch between AlN and SiC is measured to be Δ α = α AlN − α SiC = 1.13 × 10 − 6   ° C − 1 and is found to be constant between room temperature and 1400 °C. TEM confirms the existence of dense misfit dislocation (MD) networks consistent with MD formation near SiC step edges and low MD density regions attributed to nearly coherent AlN growth on SiC terraces. These low-TDD, crack-free AlN/SiC buffers provide a platform for deep-UV optoelectronics and ultrawide bandgap electronics.

1 September 2021 in AIP Advances
Verified
Journal Article
Open access
PDF file
AAAbdullah S. Almogbel
Abdullah S. Almogbel
CZChristian Zollner
Christian Zollner
BSBurhan SaifAddin
Burhan SaifAddin
MIMichael Iza
Michael Iza
JWJianfeng Wang
Jianfeng Wang
JSJames S. Speck
James S. Speck
The impact of AlGaN growth conditions on AlGaN:Si resistivity and surface morphology has been investigated using metalorganic chemical vapor deposition. Growth parameters including growth temperature, growth rate, and trimethylindium (TMI) flow have been systematically studied to minimize the resistivity of AlGaN:Si. We observed a strong anticorrelation between AlGaN:Si conductivity and growth temperature, suggesting increased silicon donor compensation at elevated temperatures. Secondary ion mass spectrometry and positron annihilation spectroscopy ruled out compensation by common impurities or group-III monovacancies as a reason for the observed phenomenon, in contrast to theoretical predictions. The underlying reason for AlGaN:Si resistivity dependence on growth temperature is discussed based on the possibility of silicon acting as a DX center in Al0.65Ga0.35N at high growth temperatures. We also show remarkable enhancement of AlGaN:Si conductivity by introducing TMI flow during growth. A minimum resistivity of 7.5 mΩ cm was obtained for n-type Al0.65Ga0.35N, which is among the lowest reported resistivity for this composition.

23 August 2021 in Crystals
Verified
Journal Article
Open access
PDF file
CZChristian Zollner
Christian Zollner
YYYifan Yao
Yifan Yao
MWMichael Wang
Michael Wang
FWFeng Wu
Feng Wu
MIMichael Iza
Michael Iza
SNShuji Nakamura
Shuji Nakamura
Highly conductive silicon-doped AlGaN and ohmic contacts are needed for deep-UV LEDs and ultrawide bandgap electronics. We demonstrate improved n-Al0.65Ga0.35N films grown by metal–organic chemical vapor deposition (MOCVD) on sapphire substrates using a low V/III ratio (V/III = 10). A reduced V/III ratio improves repeatability and uniformity by allowing a wider range of silicon precursor flow conditions. AlxGa1−xN:Si with x > 0.5 typically has an electron concentration vs. silicon concentration trend that peaks at a particular “knee” value before dropping sharply as [Si] continues to increase (self-compensation). The Al0.65Ga0.35N:Si grown under the lowest V/III conditions in this study does not show the typical knee behavior, and instead, it has a flat electron concentration trend for [Si] > 3 × 1019 cm−3. Resistivities as low as 4 mΩ-cm were achieved, with corresponding electron mobility of 40 cm2/Vs. AFM and TEM confirm that surface morphology and dislocation density are not degraded by these growth conditions. Furthermore, we report vanadium-based ohmic contacts with a resistivity of 7 × 10−5 Ω-cm2 to AlGaN films grown using a low V/III ratio. Lastly, we use these highly conductive silicon-doped layers to demonstrate a 284 nm UV LED with an operating voltage of 7.99 V at 20 A/cm2, with peak EQE and WPE of 3.5% and 2.7%, respectively.

14 August 2020 in Optical Materials Express
Verified
Journal Article
Open access
PDF file
CZChristian Zollner
Christian Zollner
AAAbdullah S. Almogbel
Abdullah S. Almogbel
YYYifan Yao
Yifan Yao
MWMichael Wang
Michael Wang
MIMichael Iza
Michael Iza
SNShuji Nakamura
Shuji Nakamura
AlGaN-based germicidal UV LEDs show promise in fighting the COVID-19 pandemic through disinfection of air, water, and surfaces. We report UV LEDs grown by MOCVD on SiC substrates, fabricated into thin-film flip chip devices. Replacing the uniform p-Al x Ga1-xN layer (x = 0.2) with a short-period-superlattice of alternating (x = 0.1 and 0.8) Al-composition improved EQE from 1.3% to 2.7% (3.2% with encapsulation) at 20 A/cm2. Peak EQE and WPE values of 4.8% and 2.8% (287 nm) were measured at current densities below 2 A/cm2, and maximum output power of 7.4 mW (76 mW/mm2) was achieved at 284 nm. Further WPE improvements are expected with both superlattice and uniform layer optimization, improved p-contact metallization, and active region optimization.

4 December 2023 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
MWMichael Wang
Michael Wang
FWFeng Wu
Feng Wu
YYYifan Yao
Yifan Yao
CZChristian Zollner
Christian Zollner
MIMichael Iza
Michael Iza
JSJames S. Speck
James S. Speck
We report on the material challenges of the growth of highly conductive n-AlGaN in germicidal ultraviolet light emitting diodes (GUV LEDs), with the degradation of the surface morphology of thick highly doped n-AlGaN due to the Si anti-surfactant effect. Threading dislocation inclination, increasing relaxation, and eventual cracking were observed with epitaxial n-AlGaN films thicker than 400 nm, along with an increasing Ga composition with the same metalorganic flows. With the optimization of the n-AlGaN conductivity in previous works, thin n-AlGaN films with high conductivity along with a smoothing superlattice were incorporated in GUV LED devices, resulting in LEDs with 285 nm electroluminescence, a low forward voltage of 4.2 V with a peak external quantum efficiency (EQE) of 10.6% and a peak wall-plug efficiency of 8.6% below 1 A/cm2, and an EQE of 5.5% at 20 A/cm2.