In this paper, we report the successful demonstration of bright InGaN-based microLED devices emitting in the red spectral regime grown by metal organic chemical vapor deposition (MOCVD) on c-plane semi-relaxed InGaN substrates on sapphire. Through application of an InGaN/GaN base layer scheme to ameliorate high defect density and maintain appropriate lattice constant throughout the growth, high-In quantum wells (QWs) can be grown with improved crystal quality. Improvement to the design of the growth scheme also yields higher power output resulting in an increase to the external quantum efficiency (EQE). Combined, these two improvements allow for an 80 × 80 m microLED device emitting at 609 nm to achieve 0.83% EQE. Furthermore, the true In content of the QW is measured using atomic probe tomography (APT) to confirm the improved In incorporation during high temperature active region growth. These developments represent advancement toward the realization of bright, highly efficient red III-nitride LEDs to be used in RGB applications under one material system.
InGaN-based red micro-size light-emitting diodes (μLEDs) have become very attractive. Compared to common AlInGaP-based red µLEDs, the external quantum efficiency (EQE) of InGaN red µLEDs has less influence from the size effect. Moreover, the InGaN red µLEDs exhibit a much more robust device performance even operating at a high temperature of up to 400 K. We review the progress of InGaN red μLEDs. Novel growth methods to relax the strain and increase the growth temperature of InGaN red quantum wells are discussed.
Highly conductive silicon-doped AlGaN and ohmic contacts are needed for deep-UV LEDs and ultrawide bandgap electronics. We demonstrate improved n-Al0.65Ga0.35N films grown by metal–organic chemical vapor deposition (MOCVD) on sapphire substrates using a low V/III ratio (V/III = 10). A reduced V/III ratio improves repeatability and uniformity by allowing a wider range of silicon precursor flow conditions. AlxGa1−xN:Si with x > 0.5 typically has an electron concentration vs. silicon concentration trend that peaks at a particular “knee” value before dropping sharply as [Si] continues to increase (self-compensation). The Al0.65Ga0.35N:Si grown under the lowest V/III conditions in this study does not show the typical knee behavior, and instead, it has a flat electron concentration trend for [Si] > 3 × 1019 cm−3. Resistivities as low as 4 mΩ-cm were achieved, with corresponding electron mobility of 40 cm2/Vs. AFM and TEM confirm that surface morphology and dislocation density are not degraded by these growth conditions. Furthermore, we report vanadium-based ohmic contacts with a resistivity of 7 × 10−5 Ω-cm2 to AlGaN films grown using a low V/III ratio. Lastly, we use these highly conductive silicon-doped layers to demonstrate a 284 nm UV LED with an operating voltage of 7.99 V at 20 A/cm2, with peak EQE and WPE of 3.5% and 2.7%, respectively.
Achieving high quantum efficiency in long-wavelength LEDs has posed a significant challenge to the solid-state lighting and display industries. In this article, we use V-defect engineering as a technique to achieve higher efficiencies in red InGaN LEDs on (111) Si through lateral injection. We investigate the effects of superlattice structure on the V-defect distribution, the electroluminescence properties, and the external quantum efficiency. Increasing the relative thickness of In in the InGaN/GaN superlattice and the total superlattice thickness correlate with a reduction of active region defects and increased external quantum efficiencies. The highest measured on-chip EQE was 0.15% and based on Monte-Carlo ray tracing simulations for light extraction we project this would correspond to a flip-chip EQE of ~2.5%.
We examine full InGaN-based microLEDs on c-plane semi-relaxed InGaN substrates grown by metal organic chemical vapor deposition (MOCVD) that operate across a wide range of emission wavelengths covering nearly the entire visible spectrum. By employing a periodic InGaN base layer structure with high temperature (HT) GaN interlayers on these semi-relaxed substrates, we demonstrate robust LED devices. A broad range of emission wavelengths ranging from cyan to deep red are realized, leveraging the indium incorporation benefit of the relaxed InGaN substrate with an enlarged lattice parameter. Since a broad range of emission wavelengths can be realized, this base layer scheme allows the tailoring of the emission wavelength to a particular application, including the possibility for nitride LEDs to emit over the entire visible light spectrum. The range of emission possibilities from blue to red makes the relaxed substrate and periodic base layer scheme an attractive platform to unify the visible emission spectra under one singular material system using III-Nitride MOCVD.