Raspberry fruits are a valuable source of bioactive compounds. The study used the modification of the substrate (coconut fibre), consisting of the use of various organic and mineral additives, in the soilless cultivation of raspberries. The additives influenced the biosynthesis of bioactive compounds in the raspberry fruits by modifying the sorption properties and the abundance of the substrate. The influence of the additives on the content of polyphenols was determined as well as their profile (UPLC-MS), antioxidant potential (ABTS), vitamin C content, and the activity of selected enzymes that are markers of stress and resistance to abiotic factors. In the study, a significant effect of these additives was observed on the biosynthesis of polyphenols in raspberry fruit. The highest increase in the content of these compounds in relation to the control sample (substrate—100% coconut fibre), namely 37.7%, was recorded in the case of fruit produced on coconut substrate enriched with sheep wool. These fruits were also characterised by a significantly different profile of these compounds. These changes were caused by readily available ammonium nitrogen and free amino acids in the decomposition of proteins contained in the sheep wool. This was confirmed by the recorded content of chlorophyll SPAD in the plant leaves and the activity of selected enzymes, which proves a low level of stress and good condition of the plants.

Crop fertilization with sulfur is an important part of agricultural practices, as is the systematic increase in soil organic matter content. Materials of waste origin constitute a source of plant-available sulfur, as well as soil organic matter. The study was to verify the hypothesis assuming that combining waste sulfur pulp and its mixtures with organic materials enables simultaneous soil enrichment with readily available sulfur and organic matter. A 240-day incubation experiment was conducted, on two soils: very light and heavy; with two sulfur doses applied to each soil (20 and 40 mg S/kg d.m. for very light soil, and 30 and 60 mg S/kg d.m. for heavy soil). The sulfate sulfur content in the incubated soil material, treated with the addition of sulfur pulp and its mixtures with organic materials, increased significantly up to day 60 and then decreased. The application of these materials significantly increased the content of available sulfur and decreased the pH value of the incubated material. The effect of the introduced materials on dehydrogenase activity depended on soil granulometric composition (the impact of the applied materials on the activity of these enzymes in very light soil was small, and in heavy soil, their activity was usually limited by the presence of introduced materials). Application of the studied materials had little effect on the total organic carbon content in the incubated soil material (a significant change in the value of this parameter, in relation to the control soil, was recorded in some treatments of heavy soil).

The utilization of municipal waste and sewage sludge as a source of energy is technically very difficult due to high variability of their physical and chemical properties. The aim of this study was to evaluate the efficiency of the conversion of biomass contained in the whitewater fraction of municipal waste and sewage sludge by means of methanogenesis. The second objective was to assess the chemical composition of the digestate in the context of its use for fertilizer purposes. The whitewater fraction of municipal waste and sewage sludge was subjected to methanogenesis under static experimental conditions, according to DIM DIN 38414 methodology. The methanogenesis of concentrated substrates used in agricultural biogas plants was taken as a reference to evaluate the efficiency of the process. The organic fraction of the municipal waste was characterized by approximately 30% lower value of the soluble COD, with a comparable level of total COD compared to other materials. The total biogas yield, i.e., 404 dm³ per 1 kg of dry weight of the batch, was measured in the facility with sewage sludge. In COD value, this is 0.232 dm³·g O₂ COD. In the case of corn, these values were, respectively, 324 dm³ and 0.193, and for the organic sub-sieve fraction of municipal waste, 287 dm³·kg⁻¹ dw or 0.178 dm³·g O₂ COD, respectively. The type of fermented material did not affect the intensity of biogas production. The maximum level of biogas production occurred between the 13th and 15th day of the process. The digestate obtained in the process of methanogenesis of corn silage and the organic fraction of municipal waste was characterized by good parameters in terms of possible use for fertilization purposes.

The overarching goal of agricultural sciences is to optimize production technology to rationalize the use of production resources, energy, and space. Due to its high fertilization and water requirements, the vine is a plant with a high potential for greenhouse gas (GHG) emissions. The modifying factor in the production technology is plantation management. To reach the assumed goal, a field experiment was conducted in the years 2001–2020, and the following training systems were used: multi-arm fan system (A) trunk height <30 cm, (B) 80 cm, (C) 120 cm, one-side multi-arm, paired planting (D) 120 cm, (E) 140 cm. The total amount of GHGs emitted in vine cultivation was calculated according to ISO 14040 and ISO 14044 standards. The system boundaries were: establishing the plantation, the production and use of fertilizers and pesticides, energy consumption for agricultural treatments, and gas emissions from the soil. The amount of GHG emissions for cultivation using the systems A, B, C ranged from 426.77 to 556.34 kg of CO_2-eq Mg of yield⁻¹, while in the case of D and E systems, the value was approx. 304.37 to 306.23 CO_2-eq Mg of yield⁻¹. When comparing this stage with total annual emissions related to cultivation (for 1 ha), the amount of emitted GHGs at this stage is from approx. 42% to 58% higher than from annual emission related to cultivation. Concrete poles are the main element related with GHG emission during stage of plantation establishment, from 97 to 98% of emission. In the case of annual production, nitrogen fertilizers are responsible for approx. 36%. Moreover, the results show that systems D and E increased the average annual fruit yield (per 19 years of research) by approx. 68% compared to the A, B, C systems. There was no difference in the yield of plants with different height of shoots in the D and E systems. The “one-side, multi-arm, paired planting system” was characterized by the highest production and environmental efficiency.

As a country with not only significant production potential but also fragmented land ownership, the Kyrgyz Republic struggles with environmental efficiency, which is a strategic element of environmental management in agricultural production. The objective of this study was to assess the environmental efficiency of sheep’s wool when used as a fertilizer in bean production in northern Kyrgyzstan. In this study, the efficiency indicator was taken to be GHG emissions per functional unit of product, using a proprietary methodology for calculating GHG emissions to determine the true value of this material as a source of soil nutrients and organic matter. Two experimental factors were used in the experiment: fertilizer type and fertilizer rate. Fertilization with sheep wool resulted in a 15% higher bean yield compared to when fertilized with mineral fertilizers at a comparable rate, converted to pure nitrogen. By using sheep wool as a source of mineral nutrients for the plants, the carbon footprint was reduced by almost 10% compared to a facility with mineral fertilization. Therefore, the use of sheep wool as a source of plant nutrients is environmentally justified.

The problem of the use and disposal of horticultural substrates is an important element of the optimization of plastic greenhouse production in terms of economic and environmental efficiency. The production of mineral substrates is associated with a high energy expenditure, which generates costs and greenhouse gas (GHG) emissions. An important factor is also the transport of professional substrates over long distances. The research objective was to evaluate the possibility of using sheep wool to create horticultural substrates in the hydroponic production of cucumber. The modifier of production technology was the use of substrates of various origins. The experiment was based on the use of two substrates: one was a conventional substrate, made of mineral wool, and the other was made of greasy Gissar sheep wool, which is considered waste or a nuisance byproduct of sheep farming today. The adopted functional unit was 1 ton of commercial cucumber yield. The boundaries of the system were soil formation, fertilization, irrigation, and harvesting. The amount of GHG emissions was calculated in accordance with the ISO 14040 and ISO 14044 standards. The results of the experiment show that the use of sheep wool as a substrate in the hydroponic cultivation of cucumbers reduced yield by approximately 8%, but it allowed for a higher efficiency of water and mineral fertilizer use per crop mass unit. Within the adopted system boundary, the value of the carbon footprint in the object with the conventional substrate was 276.9 kg CO₂ eq · Mg⁻¹. The value of this parameter for the object with the sheep wool was 193.9 kg CO₂ eq · Mg⁻¹. The use of sheep wool did not increase the phytosanitary risk of the cultivated plants. An important goal for achieving sustainability, especially in food production, is to use materials that are easily recyclable and renewable, locally available, and environmentally friendly. The use of sheep wool as a substrate for soilless plastic greenhouse cultivation is a rational solution, as this material consists of 60% animal protein fibers, 10% fat, 15% moisture, 10% sheep sweat, and an average of 5% impurities. This makes it an easily recyclable, easily renewable, and environmentally friendly source of raw material for hydroponic substrates in food production, contrary to rockwool, which produces waste that is difficult to manage and a nuisance to the natural environment. In the countries of Central Asia, the sheep population is over 20 million; therefore, the potential for using sheep wool material for agricultural production is significant.